Data for falling head permeability test:Length of specimen, L= 127mmArea of specimen, A = 7854mm?.Area of standpipe, a = 113mm?.Initial head, h = 1200mm.Final head, h2 = 550mm.Test water Temp. = 24°CTime required to drop from h1 to h2 = 122sec.Find the coefficient of permeability at 20°C?

Answered: Image /qna-images/answer/f0e63086-25a4-418a-97b3-a06a77663e90.jpg

Data for falling head permeability test: Length of specimen, L= 127mm Area of specimen, A = 7854mm?. Area of standpipe, a = 113mm?. Initial head, hi = 1200mm. Final head, h2 = 550mm. Test water Temp. = 24°C Time required to drop from h1 to h2 = 122sec. Find the coefficient of permeability at 20°C ?

Data for falling head permeability test: Length of specimen, L= 127mm Area of specimen, A = 7854mm?. Area of standpipe, a = 113mm?. Initial head, hi = 1200mm. Final head, h2 = 550mm. Test water Temp. = 24°C Time required to drop from h1 to h2 = 122sec. Find the coefficient of permeability at 20°C ?

Principles of Geotechnical Engineering (MindTap Course List)

9th Edition

ISBN:9781305970939

Author:Braja M. Das, Khaled Sobhan

Publisher:Braja M. Das, Khaled Sobhan

Chapter7: Permeability

Section: Chapter Questions

Problem 7.23P

See similar textbooks

Similar questions

GEOTECHNICAL COMPLETE SOLUTION PLS For a falling-head permeability test, the following are given: length of specimen = 15.1 in., area of specimen = 3.9 in^2, and k = 0.0686 in./min. What should be the area in sq. in. of the standpipe for the head to drop from 25.1 to 12.6 in. in 8.9 min. ?
In order to compute the seepage loss through the foundation of a cofferdam, flownets were constructed. The result of the flownet study gave Nf = 6, Nd = 16. The head lost during seepage was 19.68 ft. If the hydraulic conductivity of the soil is k = 13.12 x 10-5 ft/min, compute the seepage loss per foot length of the dam per day. a.1.9 ft3/day/foot length of the dam b.1.95 ft3/day/foot length of the dam c.1.39 ft3/day/foot length of the dam d.2.9 ft3/day/foot length of the dam e.2.25 ft3/day/foot length of the dam
A 12m high circular tank with 45m radius contains oil weighing 9.4kN/m3. This tank stands over a 3m saturated sand layer (γsat = 18.88 kN/m3) underlain by a 14m thick clay layer (γsat = 17.30 kN/m3 , e = 1.27 and Cc = 0.40). Neglect weight of the tank. Assume no precompression has occurred. What is the difference between the settlement below the center and below the end of the tank?
A course sand sample is placed in the constant permeameter test. Water passes through the sample water with a constant head of 40cm and after 0.00167hr, 40grams of water have been collected. What is the coefficient of permeability of the sand in cm/sec if the sample is placed inside a 166cm container with a 7.89cm radius?
Use 10 kN/m3 for unit weight of water. For a concrete structure that retains water, a flow net is sketched as shown in Figure H8-3. Noting the marked location of the Datum, answer the following: Mark on the figure all boundary Also mark the type of each boundary. Calculate the uplift pressures at points A, B, C, D, E, and F. Calculate the factor of safety against The seepage loss (q) per day per meter length of the (i.e. q in m3/day/m) if the permeability of the soil is k = 10-4 m/sec.
A dense silt layer has the following properties: Void ratio = 0.76, SG= 2.59. Free ground water is 9.31m below the ground. Capillary action rise will reach 7.93m. The soil above capillary action rise is dry while within the zone, it is saturated at 53.13%. Determine the effective pressure (kPa) at a depth of 7.05m from the groind surface. Use stored value. Asnwer in 5 decimal places.
Pumping test was carried out in a layer of soil extending to a depth of 28 m. The initial position of water table is located 4 m below the ground. Observation wells were sighted 33.5 m & 97.5 m from the pumping well. Water is pump at 248.4 m3/hr and when steady level was attained, the drawdowns at the observation wells were observed to be 1.1 m and 0.54 m, respectively. Compute the coefficient of permeability in m/day. CHOICES A. 64.82 m/day B. 71.49 m/day C. 71.49 m/day D. 78.09 m/day
Datasheet for consolidation test Load,kN/m? Dail reading &H=dail reading*0.01mm 25 27 0.27 50 46 0.46 100 72.3 0.723 200 101.5 1015 400 135 1.35 800 186.9 1.869 200 169.9 1.699 50 149.5 1.495 Find: 1.The coefficient of volume compressibility, m, 2. Compression index, C, 3. Preconsolidation load, P, 4. The coefficient of consolidation, c,
For a falling a head permeability test, the following data were recorded. Length of soil specimen = 500 mm. Area of soil specimen = 16 cm2 Area of stand pipe = 0.97 cm2 Head difference at time t =0 is 760 mm. Head difference at time t = 6min. is 410mm. The test was conducted at a temp. of 20 ֯C. with a unit wt. of water equal to 9.789 kN/m3 and the viscosity of water at 20 ֯C is 1.005 x 10-3 N.8/m2 . Compute the hydraulic conductivity of the soil. Compute the absolute permeability of the soil. What is the head difference at time t = 4 min?
A concrete dam retaining water is shown in FIGURE FMHF-1. If the specific weight of concrete is 23.5 kN/m^3, determine the following: Factor of safety against sliding (coefficient of friction: 0.48)a. 2.48 b. 1.34 c. 3.77 d. 3.42 39. Factor of safety against overturninga. 1.34 b. 3.105 c. 3.416 d. 1.987 40. Maximum soil pressure intensitya. 73.22 b. 183.48 c. 173.53 d. 58.48
A constant-head permeability test is performed where the hydraulic gradient is 0.75. The crosssectional area of the sample is 0.25 ft2. The quantity of water flowing through the sample is measured to be 0.004 ft3/minute. (a) What is the coefficient of permeability in feet per minute? (b) What is the coefficient of permeability in millimeters per second?
In a constant head permeameter with cross section area of 10cm2 when the flow was taking placeunder a hydraulic gradient of 0.5. the amount of water collected in 60seconds is 600cc.find thepermeability of soil..