Deficiency in transmission is caused by attenuation, distortion, and noise. What's the solution, and how can we make things better?

Q: BJT DC Biasing 1. Determine the range of possible values for V for the network using the 1MOhm…

A: We need to find out range of voltage for given circuit

Q: Fig (2) B-Determine the resistance if 4-10¹6 electrons pass through the imaginary surface, the time…

A: B. The charge due to the given number of elections is, Q=nee=1.6×10-19 n=4×1016Q=4×1016×1.6×10-19…

Q: For an ordinary end fire uniform linear array, the progressive phase current K is 90 +/-Bd O 45 O…

A: The cut-off frequency for Transverse magnetic transmission mode and Transverse electric transmission…

Q: Q1/ For the circuit of Fig. (1) a. Determine V2 using Kirchhoff's voltage law. b. Determine I. c.…

A:

Q: 25. The p.d. measured across a coil is 20 V when a direct current of 2 A passed through it. With an…

A: We need to find out current for given circuit

Q: Determine the resistance and conductance of 20m of copper wire 2mm in diameter. P= 1-72 x10 S

A:

Q: = You = yourself, they themselvs Themselves themselfes O

A: Given, If You = Yourself They = .........

Q: c) Draw the block diagram of delta modulation with a brief explanation of this modulation techniques

A: Delta modulation is a Differential Pulse Code modulation (DPCM) technique in which the difference…

Q: Q1: For the J-K flip-flop, determine the Q output for the inputs in figure below Assume that Q…

A: State table of JK flip flop J K Q 0 0 Q (Hold) 0 1 0 (reset) 1 0 1 (set) 1 1 ǭ (Toggle)

Q: 1. For an open circuit (OC) load, the value of the reflection coefficient equal to (a) 1 (b)-1 (c)…

A:

Q: Q2:- Find the transfer function (Vo/Vin) for the system shown in figure below. voo 2 H Vin Vo 102 5…

A:

Q: Calculate the current " I " to give air-gap flux of 20 mwb

A:

Q: a) For the Current Locus shown Draw the equivalent electric circuit? Find the value of each element…

A:

Q: Q6) Find the Fourier transform of the following function? f(1) A 24 3T 2 0 эт E2 1

A: In this question,  The rectangular function is given.  We need to find the Fourier transform of the…

Q: Find the voltage of point A with .respect to point B in the fig 5A 5022 w A lov 3322 34222 [ C B…

A:

Q: Example: Three inductors have values L₁ = 10 mH, L₂ = 100 MH, and L3 = 500 MH. Determine the total…

A:

Q: = Given the open loop transfer function G(s) such that the output settling time T, = 2. R (s) +…

A:

Q: 12 Sensor 2 Sensor 0 17 Sensor OX 05-1 you're only allowed to pick one, from which column would you…

A: Q.9) ans(B) (2) To ensure for better protection column 2 must be removed

Q: If X= (1100101)excess-3

A:

Q: 12/60° V 592 € j2 52 j3 92 12.12 For Practice Prob. 13.2. j692 =-449

A:

Q: Q3: Air flows across a 20-cm-square plate with a velocity of 5 m/s. 1

A: Reynolds number is a dimensionless which decides whether flow is turbulent, laminar or in transition…

Q: Q2) Write the Assembly language instructions required to find: Z-X/Y, where X and Y are 16- bit…

A: Memory address Mnemonics 2000 LDA 2050 2003 MOV H, A 2004 LDA 2051 2007 ADD H 2008 MOV L,…

Q: 1012 W 15.12 15 u M M R

A:

Q: full-wave bridge rectifier

A:

Q: 4. A coil whose resistance is 10 ohms and inductance of 50mH is connecte in parallel with a series…

A: According to the given data, equivalent circuit is shown below. At resonance, the circuit should be…

Q: 24V 318-4 Sensor K2 08 05-8 21 If you're only allowed to pick one, from which column would you…

A: Ans :( B) coulomn 2 Since two sensors are connected in series without any coordination... Which…

Q: Question 3 : Determine the number of poles on the RHS, LHS, and jw-axis for the following open loop…

A:

Q: A 3300/230 V, 50-kVA, transformer is found to have impedance of 4% and a Cu loss of 1.8% at…

A: Given data, A 3300/230 V, 50-kVA transformer  percentage impedance = 4% and Cu loss =  1.8% at…

Q: Q-2. B. A 2 MVA, 3-phase, 8-pole alternator runs at 750 r.p.m and operates in parallel with other…

A:

Q: The arms of the Maxwell's bridge are arranged for balanced condition as follows: R2-60092, R4-40022;…

A:

Q: Example: . Sketch the root locus for the following system G(s)H(s) = K (s+1) s(s+4) (s² +28+2)

A:

Q: 6. When a 240 V, 50 Hz supply is applied to a combination of a resistor of 15 Q in parallel with an…

A:

Q: A single phase 1.1 KVA, 50 Hz, 220/110 transformer has an Iron losses = 80 W and equivalent…

A:

Q: Suppose the discrete time signal x(n) = [233] To shift the sequence x [n] to the right by one sample…

A: Answer: false  Because of following explanation.

Q: Calculate the current " I " to give air-gap flux of 20 mwb

A:

Q: We need a three-stage space-division switch with N = 100. We use 10 crossbars at the  first and…

A: The Given is three- stage space- division  The N is 100, At the first and third stages, use 10…

Q: Find GZAS(z) for the series R-L circuit shown in Figure with the inductor voltage as output. M R L V…

A: Given: Converting into s-domain:

Q: For the parallel resonant circuit with resonance frequency fo-2 M Hz, the bandwidth i B-1.25 M rad/s…

A:

Q: In the transverse electromagnetic ......,TEM mode Ez = 0, Hz #0 O Ez # 0, Hz = 0 O Ez = 0, Hz =0 O…

A: We are authorized to answer one question at a time, since you have not mentioned which question you…

Q: Determine current in 5 ohm resistor by any one method

A:

Q: Q5/ Find the current /4 and the voltage V2 for the network of Fig. (5)? 1280 4,390 flay 430 436010…

A:

Q: In a delta modulation system, the voice signal is sampled at a rate of 32 K samples per second.…

A: Given a delta modulation system with, The voice sampled at a rate, fs=32  Ksamplessec=32×103…

Q: Given G(s) = R(S)+ G(s) Determine the steady state error es for ramp input, r(t) = 5t. Choice e=0:…

A: We need to find out steady state error for given system

Q: Q-2. A. A lighting load of 2000 kW and a motor load of 4000 kW at a p.f. 0.8 lagging are supplied by…

A:

Q: ind the inverse Z transform for the following by using Partial Fraction method: z (z² - z+2) H(z)…

A:

Q: Q-1. A 3 phase, 0.8 MVA, 3.3 kV, star - connected synchronous generator has 5 N/phase synchronous…

A:

Q: (a) Derive the logic function for the shown logic diagram. (b) Use K-Map to simplify this function…

A:

Q: A dc shunt motor has the following

A: DC shunt motor the speed can  can be controlled very easily  The speed can  be maintained constant…

Q: Q-2. A. A lighting load of 2000 kW and a motor load of 4000 kW at a p.f. 0.8 lagging are supplied by…

A:

Q: PRACTICE PROBLEM 13.2 Determine the phasor currents I, and 12 in the circuit of Fig. 13.13 592 j222…

A: (13.2) To find the phasor currents I1 and I2 in the given circuit

Maximum power transfer theorem

A resistive load will consume maximum power from a network when the load resistance is equal to the resistance of the network as viewed from the open-circuit terminals, with all energy sources removed leaving only the internal resistances. Physicist Moritz von Jacobi introduced the maximum power transfer theorem in 1940. Therefore, this theorem is also known as Jacobi's law.