Density of a Liquid (Methanol) Run I Run II Mass of 10 mL graduate cylinder 18.345 g 18.416 g Volume of liquid (V) 8.92 mL 5.84 mL Mass of liquid + graduate cylinder 24.446 g 23.035 g Mass of liquid (M) Density of solid (D = M/V) g/mL g/mL Average density g/mL Accepted value for density of liquid g/mL

Density of a Liquid (Methanol) Run I Run II Mass of 10 mL graduate cylinder 18.345 g 18.416 g Volume of liquid (V) 8.92 mL 5.84 mL Mass of liquid + graduate cylinder 24.446 g 23.035 g Mass of liquid (M) Density of solid (D = M/V) g/mL g/mL Average density g/mL Accepted value for density of liquid g/mL

EBK A SMALL SCALE APPROACH TO ORGANIC L

4th Edition

ISBN:9781305446021

Author:Lampman

Publisher:Lampman

Chapter82: Physical Constants Of Liquids: The Boiling Point And Density

Section: Chapter Questions

Problem 4P

See similar textbooks

Similar questions

Conversion of units using the DimensionalAnalysis(Factor Label Method) I – Give the equivalent units of measurement. 1. 1m = ____ cm = _____ mm =_____ dm =______km = _____in =____ ft =___yd=______mi2. 1kg = ____ g =______mg = _____cg = _____ dg = ____lb 3. 1h = _____s = _____ ms = ______ min = ____ yr =______ day 4. 1A = ____ MA = ____V = ______ W = ______ kW = ____mA 5. 1mol = ____ mmol = _____kmol = ______Mmol 6. 1K = ____ oC= ______ oF=_______oR 7. 1g/mL = ______g/cm3 = _____lb/in3 = _____ lb/cm3 =______kg/m3 8. 1Pa=________kPa =_______mPa = ____ GPa = _____ atm 9. 1J = ________kJ = ______ nJ = _____cal = ____k cal =_____dcal 10.1Byte = _____ GB =______ kB = _____TB=_____MB =_____
1. σ=[(Σd2)/(n-1)]½ n= number of trials d= measured value - mean σ=[(8.50mL-8.74mL)2+(9.72mL-8.74mL)2+(8.00mL-8.74mL)2/(3-1)]½ 2. σ=[(Σd2)/(n-1)]½ n= number of trials d= measured value - mean σ=[(10.69-11.52)2+(11.80-11.52)2+(12.07-11.52)2/(3-1)]½
If the unknown liquid in letter e has a volume of 5.0mL and a mass of 1.95g. what is its density? Make sure to show all work, use significant figures, and include the final unit. Will the sample float or sink in water? Explain.
Composite decking is a manufactured substitute for woodcompounded from post-consumer plastic and wood. It isfrequently used in outdoor decks. The density of a particularcomposite decking is reported as 60.0 lb>ft3. What isthe density in kg/L? 11.5 kg/L
A student decided to undertake a balance calibration exercise during a lab session involving burette calibration. He found the apparent weight of calcium carbonate in air to be 100 grams and density to be 1.33g/mL. Assume that the standard steel weight used in the calibration has a density of 8.0g/mL and air has a density of 0.0012g/mL. What would be the true mass of the calcium carbonate sample?
Which substance should go at the bottom of the fraction ration and which should go on the top ? 0.37 mol H2(--------) Which answer choice ? 2NH3 at the top N2 at the bottom 2NH3 at the top 3H2 at the bottom 3H2 at the top 2NH3 at the bottom N2 at the top 2NH3 at the bottom
Hemant Kohli please answer: A sample of 500 g dry sand, when poured into a 2 litre capacity cylinder which is partially filled with water, displaces 188 cm3 of water. The density of water is 1gm/cm3 . The specific gravity of the sand is (a) 2.55 (b) 2.72 (c) 2.66 (d) 2.52
Given the following data forMass of test tube, beaker and cyclohexane = 100.17 gMass of test tube and beaker = 84.07 gFreezing point of cyclohexane = 6.59 oCMass of weighing paper + naphthalene =1.080 gMass of weighing paper = 0.928 gFreezing point solution = 5.11oCKf = 20.8oC/mDetermine the followinga. mass of cyclohexane in g (2 decimal places); _____b. mass of naphthalene in g (4 decimal places); _____c. freezing point depression (2 decimal places); _____d. molality of solution (3 significant figures); _____e. moles of naphthalene (3 significant figures); _____f. molar mass of naphthalene, experimentally (3 significant figures); _____g. % error if theoretical molar mass of naphthalene is 128.17 g/ mole, USE ABSOLUTE VALUE (3 significant figure); ____
Value Units Number Initial reading of water level (ml) Final reading of water level (ml) Volume (ml) Least count of the balance 0.1 g 1 21.0 24.0 Mass of solid, reading 1 25 g 2 19.0 21.0 Mass of solid, reading 2 24.8 g Average mass of solid 24.75 Least count of the graduated cylinder 1 ml Average volume of solid Density of the solid = mass/volume Standard value of the density of the solid 11.37 gm/cm^3 Percent error in the experimental value of density Probable error in the initial reading of the water level Probable error in the final reading of the water level Probable error in the volume of the solid Probable percent error in the mass of the solid Probable percent error in the volume of the solid Probable percent error in the density of the solid =…
1000 mg of granular salt is briefly stirred into a glass container of 1/4 liter volume filled with water. After briefly mixing, some salt is still seen at the bottom of the glass. The undissolved salt is filtered from the water, weighed and determined to have a mass of 200 mg. What is the dissolved phase concentration of salt remaining in the water? Provide your answer to the nearest whole number in units of mg/l. Example: 120 (no decimals, commas, or zeros after decimal)
Chemistry Fraction no. Elution Vol. (mL) Abs (λ = 410) Fraction no. Elution Vol. (mL) Abs (λ = 410) 1 (PB pH 6.0) 1 0.0050 11 11 0.0041 2 2 0.0032 12 12 0.0060 3 3 0.0040 13 13 0.0064 4 4 0.0064 14 14 0.0063 5 5 0.0067 15 15 0.1109 6 6 0.0067 16 16 2.8902 7 7 0.0050 17 17 0.8500 8 (PB pH 8.0) 8 0.0049 18 18 0.2019 9 9 0.0052 19 19 0.0378 10 10 0.0050 20 20 0.0073 Use the data above to plot an elution profile, in which the absorbance is on Y-axis, and elution volume (volume = fraction number) is on X-axis. The elution profile must indicate at (1) which point the pH change occurred, (2) the fraction(s) which contain the highest myoglobin content, and (3) the maximum absorbance detected.
solve as neatly as possible and show completesolution. Round your final answer to 4 decimal places and box / highlight all final answers. and all values must include proper units with proper conversion if needed in your solution. kindly folllow the format Given,Required,Solution subject physical chemistry #4) final answer must be in cm/sec 4. An iron sphere of density 7.874 g/cm3 is falling at a steady speed in glycerol at 200C. The density of glycerol is 1.2613 g/ml and its viscosity at this temperature is 1.49 kg/m-s. If the diameter of the sphere is 10 mm, find the speed (in cm/s), assuming Stoke’s Law is valid.