Determine the capillary rise of kerosene at 680F in inches in a glass tube having a diameter of 0.25 inches.

Q: Determine the pressure difference

A: Need to Determine the pressure difference

Q: A U-tube is made up of two capillaries of bores 1.2 m and 2.4 mm respectively. Q9) The tube is held…

A: Given data:      d1=1.2mm      d2=2.4mm      σ=0.06N/m      θ=0·      h1-h2=15mm

Q: Determine the distance that the column of fluid

A: Determine the distance

Q: Q2:- A- Calculate the capillary effect in a glass tube of 0.24 in diameter when immersed in mercury,…

A:

Q: Determine the pressure difference between the inside and outside of the 0.13 mm diameter air bublle…

A:

Q: Is the capillary rise greater in small- or large-diameter tubes? explain in 350 words and cite your…

A:

Q: Which step of the following steps is for use of a manometric tubes to measure the * differential…

A: Given: Which step of the following steps is for use of manometric tubes to measure the differential…

Q: A roller with a diameter of D=84 cm, unit width up to a quarter of the volume was filled with…

A: Given data: The radius of the roller is calculated as,

Q: A 98.43ft vertical column of fluid (density is 1878 kg/m3) is located where is 31.66ft/sec2.…

A:

Q: As the temperature of the hydrogen gas decreases of same gas decreases. Surface tension O Specific…

A:

Q: If the average temperature of the water was 21.5 ºC, what pressure inside the graduated cylinder is…

A: According to the definition of vapor pressure it is the pressure exerted by the vapor on its liquid…

Q: 2.18 What is the change in the viscosity and density of water be- tween 10°C and 70°C? What is the…

A:

Q: Determine the pressure difference between the inside and outside of the 0.14 mm diameter air bublle…

A: Given data, σ = 0.136 N/m  Diameter or bubble , d= 0.14 mm = 0.00014 m  Need to find pressure…

Q: A 0.6-mm-diameter glass tube is inserted into water at 20°C in a cup. Determine the capillary rise…

A: Given data d=0.6 mmσ=0.073 N/mθ=0°

Q: The pressure and temperature of the vessel is 1,271.31 kPa and 525.74 C, what is the density of air…

A:

Q: Determine the capillary rise (in cm) in a glass tube of radius 0.25 mm that is immersed vertically…

A: Given Data S= 0.0725 N/m R=0.25 mm

Q: Five sections of a pipe, each five meters long, are connected and arranged as shown below. The pipe…

A: Solution: Given Data: L = 5 m h = 5 m ρg=0.001h Pin=1.5 atmPD=1 atm

Q: An air bubble is observed from the bottom up to the water surface The atmospheric pressure is 101…

A: Given data: PAtm=101.325 kPaV1=V7 Need to determine the height of the water in meters.

Q: The ratio of fluid density to the density of water at a certain temperature is called

A: The ratio of fluid density to the density of water at a certain temperature is called Specific…

Q: Calculate the capillary effect in millimetres in a glass tube of 4 mm diameter, when immersed in…

A: Given data: -  The diameter of the glass tube is d = 4 mm. The temperature of the liquid is T =…

Q: Determine the elevation of the liquid surface in each piezometer

A:

Q: The liquids are positioned as shown in an open tank with a square bottom figure below. Solve for the…

A:

Q: Derive a relation for the capillary rise of a liquid between two large parallel plates a distance t…

A:

Q: Q2:- A- Calculate the capillary effect in a glass tube of 0.24 in diameter when immersed in fluid,…

A:

Q: Determine the minimum size of glass tube that can be used to... Determine the minimum size of glass…

A: Given data : Capillary rise (h)=5 mm Surface tension σ=0.073 N/m Density of water ρ=1000 kg/m3 Angle…

Q: A 0.018-in-diameter glass tube is inserted into mercury, which makes a contact angle of 140° with…

A: Given: The diameter of the glass tube is D=0.018 in. The contact angle of the glass is ϴ=140°. The…

Q: Q8) Determine the minimum size of glass tubing that can be used to measure water level, if the…

A: Given data ,Let h be the capilaary riseh≤0.3 mmSurface tension of water σ=0.0735 NmLet 'd' be tge…

Q: Consider a glass of water. Compare the water pressures at the bottom surface for the following…

A: a. When glass is stationary:       Pressure at bottom of water glass =Patm+ρghwhere,ρ=density of…

Q: How does the depth of the center of pressure and the depth of immersion related?

A:

Q: 17. Calculate the density of water vapor at 350 kPa abs and 20 °C if its gas constant is 0.462…

A: 17. The given values are -        P = 350 kPa, T=293 K, R = 0.462 kPa-m3kg-K

Q: Determine the pressure difference between the inside and outside of the 0.1 mm diameter air bublle…

A:

Q: Determine the reading of the pressure gage, in kPa. (Poil:850kg/m², pmercury: 13600kg/m³,…

A:

Q: the unite of viscosity constant is O N/m O gm/cm3 gm/sec.cm O O

A: Unit of viscosity  Using the Newton law of viscosity  τ=μdVdLμ=τdLdVμ=gmcm-1S-2cmcms-1=gmcm-1s-1

Q: Determine the pressure at the interface of liquids of an open tank containing 3 m of oil (SG=0.79)…

A: Given:  Oil: S>g = 0.79    h = 3 m Mercury: S.G = 13.6      h = 10 cm = 0.1 m

Q: You want to size a hollow sphere made of bronze with an outer radius re and an unknown inner radius…

A:

Q: This pertains to the mass divided by the volume of the fluia O Capillary Rise

A: As we knowMass density  is defined as the mass of the fluid per unit volume occupied by the fluid.

Q: . A water pipe is connected to a double-U manometer as shown in the figure below, at a location…

A: Atmospheric pressure, Patm = 14.2 psia

Q: How does the pressure vary at depth (Z) in liquid and gaseous fluids, and explain the reasons why…

A: Have you wondered why your ear hurts as you dive deep into a swimming pool? This is due to the…

Q: Calculate the density of water vapor at 350 kPa abs and 20C if its gas constant is 0.462 kPa-m3/kg-K

A: Given data: Assumption: Steam is considered as ideal gas.

Q: A closed cylindrical container with diameter 650 mm is rotated at 600 r/min about its vertical axis.…

A:

Q: Calculate the capillary effect in millimetres in a glass mm diameter, when immersed in mercury. The…

A:

Q: Determine the capillary rise of water in glass tube if the surface tension of water=0.00287 N/m and…

A: Given data : The value of surface tension of water=0.00287 N/m The value of diameter of tube=80 mm…

Q: Determine the pressure difference between the inside and outside of the 0.15 mm diameter air bublle…

A: GiveDiameter of the air bouble, d=0.15mmsurface tension σ=0.111N/m

Q: Q2:- A- Calculate the capillary effect in a glass tube of 0.24 in diameter when immersed in fluid,…

A:

Q: Determine the pressure difference between the inside and outside of the 0.17 mm diameter air bublle…

A: For solution refer below images.

Q: Calculate the capillary rise in cm in a glass tube of 3.0 mm diameter when immersed vertically in…

A: In the given question, the surface tension of water is taken to be wrong and hence answer does not…

Q: 3.12 The manometer shown contains water and kerosene. With both tubes open to the atmosphere, the…

A: Given Data  The initial level of difference, 20 mm the density of the water, 1000 Kg/m3 When 98Pa…

Q: 2.2m Air B 0.6m Oil Oil S.g. 0.85- Fig. 32

A: