If the average temperature of the water was 21.5 ºC, what pressure inside the graduated cylinder is contributed by the water vapor

Q: Nitrogen is contained in a 4 m^3 rigid vessel at a pressure of 4200 kPa. Determine the mass if the…

A: Given data: The volume of the vessel, V = 4 m3. Pressure of nitrogen, P = 4200 kPa. The temperature…

Q: If water has a pressure of 35 kPa absolute, at what approximate temperature will it boil?

A: This question is possible to solve with the help of steam table

Q: -35%- The pressure in the automobile tire depends on the air in the tire. When the air temperature…

A: Given:T1=25°C =298 KPg1=210 kPaV=0.025 m3T2=50°C =323 KPatm=95 kPa

Q: Q1:- Find the time period of the fluid in a U-tube manometer shown by using Newton Method. Fluid…

A: given; density of liqiud=ρmass of liquid=marea of tube=Atime period(T)=?

Q: The vacuum pressure of a condenser is given to be 98 kPa. If the atmosphericpressure is 98 kPa, what…

A:

Q: The partition is now removed and the gas expands to fill the entire tank. Heat is now transferred to…

A: In this problem, there is a tank that has a partition. The initial temperature and pressure of the…

Q: Taking the coefficient of compressibility of water to be 2200 MPa, determine the pressure increase…

A: Given   Coefficient of compressibility, B = 2200 MPa                Change in volume, dV1 = 1% =…

Q: If the initial volume of the gas is compressed to one-half its original volume and the new…

A:

Q: The superheated steam has a pressure of 2.3 Mpa and temperature of 450 oC. Determine the specific…

A: Given data: P=2.3 MPaT=450°C Need to determine the  specific volume, specific internal energy,…

Q: cylinder of 125mm radius rotates concentrically inside a fixed cylinder of 130mm radius. Both…

A: Given Data Inner Radius=125 mm Outer Radius=130 mm L=300 mm w=2π rad/s

Q: Identify the state of the fluid:  Water at 19.94kPa, with a temperature of 60°C

A: Given:- P=19.94 kPa T=60°C To find:- State of the water

Q: Q2:- A- Calculate the capillary effect in a glass tube of 0.24 in diameter when immersed in mercury,…

A:

Q: QUESTION 8 What is the specific volume of air at 184 K and 139.23 kPa? Give your answer in mkg to 3…

A: Solution is attached below:

Q: the steam is cooled until the pressure is reached to 500 kPa. If the piston reaches the stops? and…

A:

Q: A cylinder of 100 mm diameter and 300 mm length rotates about a vertical axis inside a fixed…

A: given data  Diameter of cylinder (d) = 100 mm length of cylinder (L) = 300 mm Inside Dia of…

Q: A tank containing potable water is under an absolute pressure of 60 KPa and has a temperature of…

A: Air in the tank P = 60 kPa  T = 60 oC r = 1.5 m  L = 4 m  Volume of tank = π×r2×L=π×1.52×4=9π m3

Q: Calculate the Specific Volume at a temperature of 47.3 ° C for a pressure of 0.06 MPa.

A: Specific volume of a substance is defined as the volume of the substance per unit volume considered.…

Q: 2.18 What is the change in the viscosity and density of water be- tween 10°C and 70°C? What is the…

A:

Q: The 8.8-mm-diameter spherical balloon is filled with helium that is at a temperature of 28∘C and an…

A: As per given question  We have to determine weight

Q: The two-fluid U-tube manometer is being used to measure the difference in pressure in a line…

A: The density of the lighter fluid ρB=812 kg/m3 The density of the heavier fluid ρA=998 kg/m3 Diameter…

Q: contained in A and rises in the tube to a level 52 in above A. Kerosene is contained in B. the…

A:

Q: Determine the diameter of a droplet of water in mm if the pressure inside is to be greater than that…

A: Given data,  σ= 7.26 *10-2  P= 130 N/m²  Diameter of droplet is required

Q: 1)Determine the force F that needs to be applied in the horizontal direction. 2) If a 0.30 mm thick…

A: Answer: (a) The force F needs to be applied in the horizontal direction is 193.3824 N. (b) The…

Q: The capillary rise of water in the :glass tube is given by h= 40/x d. O h=20/x d. O h=60/x d. O h=…

A: Capillary effect When a tube with a radius less than 3 mm is dipped into the liquid then the level…

Q: Question 1 a) Initially, the wheel was filled with Nitrogen at temperature of 20°C and a pressure…

A: Given: The initial temperature of the nitrogen gas is , T1=20C°+273=293 K. And the gauge pressure…

Q: ?What is the shear force that acts on the circumference of the piston (N) Assume the variation in…

A:

Q: Q1: the pressure at point A is 172 pa. All fluids are at 20°C. The air pressure in the closed…

A:

Q: For the vessel containing glycerin under pressure as shown in Fig. 2-2, find the pressure at the…

A: Given data:  Pressure P0 = 50kPa  Depth of glycerin = 2m  Find:  The pressure at the bottom of the…

Q: Determine the elevation of the liquid surface in each piezometer

A:

Q: The volume of an aluminum ball at 5°C is 10cc, determine its new volume if it is heated to a…

A:

Q: What is the effect of Time and the relative viscosity of the liquid?

A: first of all, we will learn some basic knowledge about the viscosity of the fluid. The term…

Q: Determine the specific volume of refrigerant -134a at a temperature of 5°C and a quality of 70%.

A:

Q: The boiling temperature of water decreases by about 3°C for each 1000-m rise in altitude. What is…

A: Given data,  Temperature is decreasing on increasing the altitude  At , per 1000 m , ΔT = 3°C  It is…

Q: QI/ the cylinder contains 0.2 kg of saturated water vapor at 1000 kPa. The stops location…

A:

Q: Determine the specific volume o of 5°C and a quality of 70%.

A: GivenT=5°Cquality=70%

Q: 3. Determine the force required to drag a thin plate placed in the middle of two parallel plates 24…

A:

Q: Taking the coefficient of compressibility of water to be 7 × 105 psia, determine the pressure…

A: Given data: The compressibility of water, k = 7 × 105 psia. (a) When volume of water is reduced by…

Q: Q1: the pressure at point A is 172 pa. All fluids are at 20°C. The air pressure in the closed…

A: Let the air pressure in the tank be PB , pressure at point A is PA=172 Pa, Assuming g =9.81msec2…

Q: direction, acting on the plug if it is inverted and if the tank contains 600mm of oil having an SG…

A:

Q: The tank is filled with water and gasoline at a temperature of 20∘C to the depths shown in (Figure…

A: To find: The gauge pressure at the bottom of the tank and also explain, whether the results be…

Q: Positions A-l are different points with respect to the atmospheric pressure as shown in the figure…

A:

Q: As shown in the diagram, the state of helium gas is changed in such a way that its PV graph is a…

A:

Q: 2. Mercury is poured into the tube in the figure until the mercury occupies 375 mm of the tube's…

A: GivenH=L=375mm

Q: A liquid flows over the plate as shown in the image below. The liquid behavior as a Newtonian fluid…

A: Newtons law of viscosity.

Q: o 1000 kgm-3 s taken in

A: Answer h= 2.93*10-2m

Q: If it is estimated that 75 percent of electricity consumed by the heater is transferred to the water…

A: First, we calculate how much thermal energy (heat) was transferred to the water:…

Q: A rigid tank contains 15kg of water at 75 degrees celcius. if 3kg the water is in the vapor form and…

A: (a) The pressure in the tank is 38.597 kPa. (b) The volume of the tank is 12.4 m3.

Q: Q1:- Find the time period of the fluid in a U-tube manometer shown by using Newton Method. Fluid…

A: Restoring force = -Ky Weight of the fluid oscillation, W=mg=ρl×A×2y×g Weight of the fluid…