Answered: Determine the height h above the base B…

Determine the height h above the base B at which the resultant of the three forces acts. 290 lb 24" F 24" 280 lb 24" B 615 lb Answer: h- in.

Glencoe Physics: Principles and Problems, Student Edition

1st Edition

ISBN:9780078807213

Author:Paul W. Zitzewitz

Publisher:Paul W. Zitzewitz

Chapter5: Displacement And Force In Two Dimensions

Section: Chapter Questions

Problem 82A

See similar textbooks

Related questions

Q: A tire rotates at an angular velocity of 40 rad/s. What angular displacement will the tire undergo…

Q: Calculate the required power to pump 972 kg of water up to the tank at the height of 22 from the…

A: Given in question - Mass of the water (m) = 972 Kg Height of tank…

Q: Answers: Fx= Fy= Fn = Ft= i i i 67° 47° B F = 850 lb lb lb lb lb

Q: force of gravity acting on the men

A: Given data; Mass,m=40 kg Height,h= 8 m Time,t= 5 secFind; 1. Force of gravity 2. Workdone

Q: 3. This time we have a crate of mass 32.0 kg on an inclined surface, with a coefficient of kinetic…

Q: The sun orbits the center of the Milky Way galaxy for a period of 2.5x10^8 years. (a) Assuming a…

Q: A fluid system has two sensors, a pressure sensor and a flow sensor. The pressure sensor has two…

A: The given problem has 6 subparts. As per the Bartleby policy, we will answer the first three. Kindly…

Q: he summit of a mountain, 2450 m above base camp, is measured on a map to be 4580 m horizontally…

Q: A 10 monolayers thick layer of Ag is deposited on Mo. The intensity of electrons emitted by the Ag…

A: Given: Ratio of intensity before agglomeration = I0AgI0Mo= 100 Ratio of…

Q: Q10 In the figure, one end of a uniform beam of weight 310 N is hinged to a wall; the other end is…

A: GIVEN: weight of beam = 310N θ=270

Q: Q9/ The bandwidth of amplitude modulation (AM) if a sinusoidal signal at 1.5 KHz, ---

A: Given Frequency of modulating signal is fm=1.5 kHz Find the band width of amplitude modulation.

Q: Consider a non-rotating space station in the shape of a long thin uniform rod of mass 1.84 x 10^6 kg…

Q: The caster unit is subjected to the pair of 81-lb forces shown. Determine the moment associated with…

Q: A wheel (of radius 0.5 meters) spins with an angular velocity of 2 radians per second (rad/s). If…

Q: How much work is being done the ball by the 10 n tension for The strinh during one complete…

A: Given : F = 10 N

Q: You kick a soccer ball so rolls along the ground at 15 m/s. It goes up a ramp that is angled at 60°…

Q: A potential difference will be induced in the wire if it is moved (1) toward the top of the page (2)…

A: In the given question, The straight wire is rest initially in a region of the uniform magnetic…

Q: Determine the magnitude of the resultant force and its direction measured from the positive x-axis.…

Q: The uniform solid block in the figure has mass 33.7 kg and edge lengths a = 0.950 m, b = 1.36 m, and…

A: In the given question, Mass of the block (m) = 33.7kg Edge lengths a = 0.95m; b = 1.36m; c = 0.0821m…

Q: You have been linked to a version of you where you have hotdogs for fingers, fearing that Jotaro is…

Q: (a) What is a.m.u? Express 1 a.m.u. in MeV. (b) Write the approximate mass of a proton, neutron and…

Q: What is the change in momentum of a 0.50 kg softball if it approaches a batter at 30 m/s and is hit…

Q: A diver is diving to a depth of 20 m below the surface of the sea. Assume the relative density of…

A: Given: The depth of the diver is 20 m. The relative density of the seawater is 1.02. The density of…

Q: Draw a I-V graph for a linear resistor.

A: Given; Draw a I-V graph for a linear resistor. And define the slope drawn in figure .

Q: Find the wavelength of a wave traveling at 20 m/s at a frequency of 5 Hz.

Q: 6. You launch a projectile with an initial speed of 39.3 m/s from the top of a building 62.7 m above…

Q: Find the wavelength of a wave traveling at 20 m/s at a frequency of 5 Hz.

A: Introduction : In this question we are provided with value of wave speed and frequency . with these…

Q: Two kids are playing on a seesaw on the school playground. The first kid (of mass 50 kg) sits 2…

Q: How would I solve for Fnetx and Fnety for problems 2 to 9?

Q: If the moment of inertia of a disk is 0.270 kg*m^2, what is the smallest amount of torque needed to…

Q: How does the resistance of a metallic wire depend on its temperature? Explain with reason.

A: The resistance of the conductor increases with an increase in it's temperature. R = Rref × [1 + α (T…

Q: An electric heater of power 3 kW is used for 10 h. How much energy does it consume? Express your…

A: Given data: Power, P=3 kW Time, T=10 h Our question is to find the energy

Q: High–power lasers in factories are used to cut through cloth and metal. One such laser has a beam…

Q: Find the speed of a satellite moving around the earth in a circular orbit that has a radius equal to…

Q: A 0.643 kg cat sits at the end of a 15.7 kg, 11.2 m long beam. An accident occurs and the support…

A: Answer : The impact speed of the cat is 17.81 m/s

Q: In the figure below, mA > mB and the table surface is frictionless. If the system is released from…

Q: 1. A meter reader determines that a business has consumed 3550 kWh of energy in two months. If…

A: Given: The total consumed electricity is 3550 kWh. The time interval is 2 month. The electricity…

Q: Calculate the work done when a force of 15 N moves a body by 5 m in its direction.

A: Introduction : In this question we are provided with value of force and displacement . with these…

Q: Green light has a wavelength of approximately 510 nm. When green light is diffracted through a…

Q: Two blocks are positioned on surfaces, each inclined at the same angle of 48.8 degrees with respect…

A: Given:- Two blocks are positioned on surfaces, each inclined at the same angle of θ=48.8o The mass…

Q: What’s the history behind gravitational waves?

A: Gravitational waves are 'ripples' in space-time that result from some of the Universe's most…

Q: In the figure, block 1 of mass m1 slides from rest along a frictionless ramp from height h = 2 m and…

Q: QUESTION 8 can assume that its moment of inertia, I, is A yo-yo on a string, which is initially at…

A: Given:- A yo Yo on a string, which is initially at rest, is released from a height of 2 meters…

Q: In the figure, two 6.80 kg blocks are connected by a massless string over a pulley of radius 2.10 cm…

Q: Calculate the wavelength of the light that produces dark fringes 5.95 x 10^-3 m apart on a screen…

Q: 3. The Distance of 50m, & 500 m. were accu rately measure & the intercepts on the staff blw the…

A: Solution: The tacheometric distance equation is given by: D=kS+c........................ (i) Here, D…

Q: 02. What push P up the incline is needed to move a 200-N block up the incline at constant speed if μ…

A: Draw the free-body diagram of the system.

Q: Draw a I-V graph for a linear resistor. What does its slope represent?

Q: The rate of heat transfer on a cold day in the Canada through a rectangular window is 2300 W. The…

Q: The direction of the vector A = 4 i +4j is O 0° O 45° O 90° none of these

A: Given data: The vector, A→=4i+4j (1)

Concept explainers

Torque

Torque is the rotational equivalent of linear force in physics and mechanics. Based on the course of study, it is also known as the moment of force, rotational force, or turning effect.

Question

Determine the height h above the base B at which the resultant of the three forces acts.
290 lb
24"
615 lb
24"
280 lb
24"
Answer: h= i
B
in.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.

Similar questions

Forces F→1, F→2, and F→3 act on the structure of the figure, shown in an overhead view. We wish to put the structure in equilibrium by applying a fourth force, at a point such as P. The fourth force has vector components F→h and F→v. We are given that a= 1.90 m, b = 3.27 m, c = 1.31 m, F1 = 38.1 N, F2 = 18.9 N, and F3 = 2.05 N. Find (a) magnitude of Fh, (b) magnitude of Fv, and (c) d.
Replace the loading system by an equivalent resultant force and a couple moment acting at point OO. Assume F1= 150 N , F2= 210 N and Mc= 85 N⋅m. .
Determine the weight "W" so that the system become Equilibrium.
A 30 kN horizontal force and 40 kN vertical force is directed 53 degrees wrt x axis to the upper right, at what angle (in degrees) will forces of the same magnitude be directed to the lower left to produce equilibrium?
The semi-circular arch is loaded as shown in the Figure. For this problem, P1 = 1.8 kN, P2 = 0.90 kN, and P3 = 0.45 kN. 55. •What is the resultant of the three forces? • Determine the reaction of A &B
Find the range of mass M2 for which the system shown below will be in static equilibrium. Theta is 30 degrees and M1 is 2kg. The surface is frictionless.
A 12 ft ladder that weighs 50lb rests against a frictionless wall at a point 10ft above the ground. How much force does the ladder exert (a) on the ground and (b) on the wall?
The figure below shows two blocks connected by a string of negligible mass passing over a frictionless pulley. m1 = 6.4kg and ? = 12.0?. Assume that the incline is smooth. (a) For what value of m2 the will the system be in equilibrium? m2 = kg (b) If the block has to slide down the incline with an acceleration of 1.2m/s2, what should be the value of m2? m2 = kg
The drawing below shows a person whose weight is W = 603 N doing push-ups. Assume L1 = 0.880 m and L2 = 0.435 m. Calculate the normal force exerted by the floor on each hand, assuming that the person holds this position.
Forces F1, F2, and F3 act on the structure depicted in the figure, shown in an overhead view. We wish to put the structure in equilibrium by applying a force, at a point such as P located a distance d from F1, whose vector components are Fh and Fv. We are given that a = 2.1 m, b = 2.6 m, C = 1.15 m, F1 = 18.05 N, F2 = 11.05 N, and F3 = 4.85 N.Find Fh.
A tutor told me that the answer to 1b was 10N but I don't understand why it would be 10N for the tension. If that is correct could someone break it down for me?
A force of 5 lbs acts on a 32.2 lb-f body for 2 seconds. If the body is initially at rest, how far it is displaced by the force? Correct answer is 10 ft.