From the given figure, determine the linear acceleration of the reel ? A reel of mass mand radius of gyration k is rolling downsmoothly from rest with one end of the thread wound onit held in the ceiling as depicted in the figure. Considerthe thickness of the thread and its mass negligible incomparison with the radius r of the hub and the reelmass m. Symbol g represents the acceleration due togravity.ThreadReelr (Hub radius)

Given; A reel of mass m and radius of gyration k is rolling downsmoothly from rest with one end of…

Answered: , determine the linear acceleration of…

Engineering

Mechanical Engineering

, determine the linear acceleration of the reel

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

The wheel in the figure has a mass of 40 kg and a radius of rotation, in relation to its center of gravity, kG = 250 mm. Whereas there is no slip, determine the angular velocity of the rotates after it rotates 90 ° clockwise from illustrated position. The AB spring has a constant stiffness k = 100 N / m and a length in the undisturbed situation of 500 mm. Consider that the wheel is initially at rest.
1) Three small spheres are rigidly mounted to a horizontal shaft with rotates with angularvelocity omega as shown. Neglect sphere radii, ignore gravity. Spheres have masses m1, m2andm3 as shown.a. What is the angular momentum HO about O the center of the coordinates shown?b. At this instant, what is Ax , the x component of the bearing force at A to offset the dynamicimbalance? Note that you are NOT asked to find any other forces (Ay, Ox, or Oy) in interestof time.
A stepped cylinder has the dimensions R₁ = 0.30 m, R₂ = 0.65 m, and the radius of gyration, k, is 0.35 m. The mass of the stepped cylinder is 100 kg. Weights A and B are connected to the cylinder. If weight B has a mass of 80 kg, and weight A has a mass of 50 kg, how far does A move in 5 seconds? In which direction does it move? (Draw all FBDs)
1. As shown in the figure, a uniform circular ring with mass M, radius R, and moment of inertia lcM= D MR^2 performs pure rolling motion along the slope with 0 inclination angle at rest. ) What is the acceleration AcM of the center of mass of the circular ring?
3.32). As shown in Figure 3, a yo-yo toy is formed by wrapping a massless cord around adisk of radius R= 0.2 m and mass M=3 kg. The cord is vertical and its top end is fixed and the disk isinitially stationary. The cord remains vertical for the entire motion and does not slide on the disk.When the disk is released from rest, it falls down by a distance H=0.8 m, The moment of inertia ofthe disk around its center is I disk=1/2mdiskR^2a . Find the angular acceleration of the disk when it is lowered by a distance H.b . Find the angular velocity of the disk when it is lowered by a distance H.
A cable is wrapped around the spool’s center hub. The mass of the spool is m= 100 kg, the radius r1 = 0.4 m, r2 =0.6 m, and the radius of gyration is kG = 0.3 m. A horizontal force P = 10 N is applied to the cord. The spool is initially at rest and rolls without slipping. (2) The mass moment of inertia about point A _______(kg·m2)(two decimal places)
The thin rod in the figure has a mass of 15kg and is attached to a spring of constant k = 50 N / m at one end, which has an unstretched length of 1.5 m. If the rod is released from rest in a horizontal position (ѳ = 0 °) and only conservative forces act on it, determine:a) What is the moment of inertia of the thin rod around the axis of rotation at A? b) What is the angle at which the rod is momentarily at rest again? c) What is the maximum angular velocity of the path?
Consider the system of two blocks. Thereis no friction between block A and the tabletop. The mass of block B is5.00 kg. The pulley rotates about a frictionless axle, and the light ropedoesn’t slip on the pulley surface. The pulley has radius 0.200 m andmoment of inertia 1.30 kg . m2. If the pulley is rotating with an angularspeed of 8.00 rad/s after the block has descended 1.20 m, what is themass of block A?
A 256-lb block is released from rest when the spring is unstretched. The drum has a weight of 76 lb and a radius of gyration of kO = 0.9 ft about its center of mass O. The coefficient of stiffness of the spring is k=78 lb/ft. The radius of the drum are: rin=0.485ft and rout=0.82ft. Find the velocity of the block after it has descended d=4 feet.
A weight with mass mw=150 g is tied to a piece of thread wrapped around a spool, which is suspended in such a way that it can rotate freely. When the weight is released, it accelerates toward the floor as the thread unwinds. Assume that the spool can be treated as a uniform solid cylinder of radius R=4.00 cm and mass Ms=200 g. Find the magnitude ?a of the acceleration of the weight as it descends. Assume the thread has negligible mass and does not slip or stretch as it unwinds. Use ?=9.81 m/s2. Find the tension T in the thread.
A uniform, 0.0300 kg rod of length 0.400 m rotates in ahorizontal plane about a fixed axis through its center and perpendicularto the rod. Two small rings, each with mass 0.0200 kg, are mounted sothat they can slide without friction along the rod. They are initially heldby catches at positions 0.0500 m on each side of the center of the rod,and the system is rotating at 48.0 rev/min. With no other changes in thesystem, the catches are released, and the rings slide outward along therod and fly off at the ends. What is the angular speed (a) of the systemat the instant when the rings reach the ends of the rod; (b) of the rodafter the rings leave it?
A uniform rod of mass M = 2.3 kg and length L = 0.2 m, lying on a frictionless horizontal plane, is free to pivot about a vertical axis through one end, as shown. The moment of inertia of the rod about this axis is given by 1/3 ML2. If a force F = 7 N, q = 47° acts as shown, what is the resulting angular acceleration (in rad/s2) about the pivot point?