Determine the y-coordinate of the centroid of the shaded area shown. 16" Parabolic 3" 1 Answer: y = i 8" in.

Q: Air at p = 1 atm enters a thin-walled (D = 5-mm diameter) long tube (L = 2 m) at an inlet…

A: NOTE: Can't provide handwrittenas its against the company's policy and it decreases our QC…

Q: What is the maximum amount of energy released when a 5 kg sample ofcoal from McDowell, West Virginia…

A: Write the higher heating value of coal from McDowell, West Virginia. HHV=36.2 MJ/kg

Q: S HAVE BEEN OPERATED FOR 100 URS. WHAT IS THE MEAN TIME B ISTANT FAILURE RATE FOR THE AB

A: given:total operating time =100hrtwo machine failed in 100hr

Q: SETB: A cylindrical steel pressure vessel 400 mm in diameter with a wall thickness of 18 mm, is…

A:

Q: The slotted arm OA rotates about a fixed axis through O. At the instant under consideration, € =…

A: Given data: θ=28°θ˙=46 deg/s=0.803 rad/sθ¨=21 deg/s2=0.36652 rad/s2m=0.7 kgL=0.53 m Need to…

Q: Find the pressure at depth of 2 m from free surface of water

A: Given data : Depth of water h=2 m Density of water ρ=1000 kg/m3 Acceleration due to gravity g=9.81…

Q: (b) Electrolytic Tough Pitched Copper is often used in telecommunications applications. Justify why…

A:

Q: In NH3-water absorption system the heat is supplied to generator by condensing stream at 0.2 MPa.…

A: Ammonia - water absorption refrigeration cycle Heat input by steam at 0.2 MPa and dryness fraction…

Q: A tubular steel shaft transmits a power of P = 450 hp at a speed of 3000 rpm. Determine the maximum…

A:

Q: in Figure 4b. A load of 200 N is applied at B at an angle 30°. The structure has diameter of 50mm,…

A:

Q: A two-stage piston-cylinder system compresses propane from 7 kPa to 17 bar in a refrigeration…

A: Given: Initial pressure of the compressor→Po=7 kPa Final pressure of the compressor→Pf=17 bar=1700…

Q: A commercial aircraft flies at 0.86 at altitude of 10000 feet above sea level. The inlet has been…

A: Given:  gamma = 1.38 Mach number , M = 0.86 pressure recovery = 0.96

Q: A Diesel engine has an inlet temperature and pressure of 16 0C and 96 kPa respectively. The…

A:

Q: The length of the crank is 2 inches and the length of the connecting link is 4 inches. The distance…

A:

Q: Air at p = 1 atm enters a thin-walled (D = 5-mm diameter) long tube (L = 2 m) at an inlet…

A:

Q: The 186-lb exerciser is beginning to execute a bicep curl. When in the position shown with his right…

A: Given data WE=186 lb WC=22 lb ay=0.30g

Q: Outline THREE advantages of using carbon fibre composites, in preference to other materials, in…

A: Carbon fiber composites are being used more often by commercial airlines to construct airplane…

Q: A concentrated load of P = 20 kN is applied to the upper end of a pipe with length L = 5 m. The…

A:

Q: Investigate the mass flow rate of oil inside the Alaskan pipeline, and write a brief report to your…

A: At three locations, near Fairbanks, Paxson and Valdez, Alaska, the gradient configuration of two…

Q: 1. Using the TTT diagram for Eutectoid Steel, specify the constituents and their approximate…

A: To find: Indicate the components of a tiny specimen that underwent the ensuing time-temperature…

Q: A fan with a capacity of 1.5 m³/s draws air at a static pressure of 3.0 cm of water through a duct.…

A:

Q: Prove the following two equations: Strengh of Material G= K = E 2(1+v) E 3(1-2v)

A:

Q: Find the potential energy stored in object Mass of object=9.55 kg Height to be raised=3.33 m

A: Given :  mass of object , m = 9.55 kg height , z = 3.33 m   To find :  potential energy stored in…

Q: Air occupying a volume of 12 liters at 35 0C is compressed adiabatically to a volume of 4 liters. It…

A: this question is based on the concept of thermodynamics. Since the initial pressure is not given so…

Q: A water jet strikes a moving plate at velocity of 10 m/s as the plate moves at a velocity of 2 m/s.…

A:

Q: The 45 kg piston is supported by a spring of modulus k = 35 kN/m. A dashpot of damping coefficient…

A: Given data: ◆ The mass of the piston: m = 45 kg ◆ The spring modulus: k = 35 kN/m = 35000 N/m ◆ The…

Q: Find the density of liquid having specific gravity 1.221

A:

Q: 1. In the figure below, if a=5 feet, L=14 feet, and the respective weights of the diver and the…

A:

Q: Write shear and moment equations for the beam loaded as shown. And the equations obtained, draw the…

A: To draw SFD and BMD

Q: Determine the coordinates of the centroid of the trapezoidal area shown. 60" 40" 60" x

A:

Q: Compute the pressure. at depth g 5.337m from free 2 wface of watey.

A:

Q: a) What is a truss? Explain shortly in your own words, and illustrate with one example. b) For the…

A: Answer (a): Truss: A fixed frame of members which is used to support something (roof, bridge) is…

Q: An ideal Diesel cycle with air as the working fluid has a compression ratio of 18 and a cutoff ratio…

A:

Q: A hydraulic turbine running at 1700 rpm at a head of 70 ft. has an efficiency of 90%. The flow is 65…

A: Turbines are widely used to obtain some amount of work. When we talk about hydraulic turbines, water…

Q: At the top of a steel pole, there are two cables as shown in the figure. It is known that the weight…

A:

Q: Q-2 For a beam of hollow rectangular section of outer geometry of b x d and the inner geometry of b₁…

A: Given: Area moment of inertia about its axis passing through the plane (the plane of area of cross…

Q: J/mm3. The process parameters are: current = 6000 A and welding duration = 0.3 s, interface…

A: GivenThickness of aluminium sheet, t=5 mmSpecific melting energy of aluminium, E=2.9 J/mm3Current,…

Q: Determine the moment of inertia and the radius of gyration of the shaded area with respect to the…

A: Given Length at base = 24 + 24 mm   Length at top = 12 +12 mm Find   Moment of inertia, I   Radius…

Q: Because of the additional equipment installed, it requires an additional flowrate of 800 CFM. The…

A: Solution: Given Data: ∆Q=800 CFM∆BHP=7.5 hpsp1=2 inQ1=8000 CFMN1=1500 rpmBHP1=5.5 hp   To Find:

Q: 11 A steam power plant operates according to the regenerative Rankine cycle with one feed water…

A:

Q: A rigid (closed) tank contains 16 kg of saturated water at 90 °C. If all of this water is in the…

A: we have to determine the quality of the vapor

Q: A vertical cylinder of 60 mm diameter is penetrated by another cylinder of 40 mm diamet the axis of…

A: A vertical cylinder of 60 mm diameter is penetrated by another cylinder of 40 mm diameter, Q2. the…

Q: Air at p = 1 atm enters a thin-walled (D = 5-mm diameter) long tube (L = 2 m) at an inlet…

A: Given:P=1 atmD=5 mmL=2 mTi=100 CTs=160 CT=400 Km=105*10-6 Kg/s

Q: A piston-cylinder device contains mgmg of refrigerant R-21 at temperature T1T1. The piston that is…

A:

Q: 2. A drone is flying in the air at some altitude. The drone is equipped with piezometer that…

A:

Q: Consider the frame below consisting of 3 beams with pins at B, C, and D. Beam CDE is 7 meters long,…

A: (a) Calculate the equivalent force for the distributed load.

Q: 7. A typical drive train for a 'geared' bicycle meant to be used on paved road (see a representative…

A: (a) Write the given data. Tf=48Df=10.5 inTs1=30Ts2=26Ts3=23Ts4=20Ts5=16Ts6=12Nf=105 rpmFf=28 lb

Q: 16 A steering rack of a car must be able to withstand large amounts of sudden impact forces without…

A: Ductility: When the tensile load is applied on the material then the material fails after a…

Q: Determine the magnitude of the velocity of block C at this instant.

A:

Q: The sensible and latent heat losses from a space are 22 kW and 9.5 kW respectively. The space is…

A:

Center of Gravity and Centroid

The term center of gravity indicates the position or location of a point about which the whole weight of a body or system is supposed to be concentrated, which means the whole weight of the body or system works through this point. It is closely related to mass distribution. For all positions of the body, the center of gravity would be a single point.