Dos fuerzas, F1 y F2, actúan sobre un tornillo de ojo. Si la fuerza resultante (FR) tiene una magnitud de 150 [lb] y los ángulos directores coordenados que se muestra en la Figura, determina los ángulos directores coordenados

Q: 2. At the beginning of the compression stroke and ideal Otto cycle has an air pressure of 15 psia, a...

A: Dear student,                    According to the guidelines I am allowed to answer only three sub-p...

Q: a) Differentiate axial load and eccentric load b) Explain the limit of eccentricity.

A:

Q: A water jet consumes "3X50"W for 126 hours a week. What is the energy consumed (kWh) for a one-year ...

A: Given data: Energy consumption for a week = 3 x 50 W = 150 W/week

Q: 10 KN 20 KN / m 5 KN / m A SIMPLE STRESSES 5 KN / m 50 KN-m 5 KN / m 2. Points C and D of the 1.00 1...

A:

Q: Q3. As shown on the right in image below, the force Facting on the box varies with displacement s, a...

A: Given:C=13

Q: 1800 m/s, nozzle throat diameter of 25 cm, An ideal rocket has characteristic velocity c* = thrust c...

A:

Q: Find the fraction of th mixture

A: Given; Volume ,v=2.0 m3It contains a mixture of liquid water and steam in equilibrium at 2 barVolume...

Q: How much work is required to compress 75 kg of air isothermally at 205°C if the compression ratio is...

A:

Q: State 1 for a dual combustion engine is p1 = 1 atm and T1 constant volume combustion process, the pr...

A: The Dual Combustion Cycle combines the Otto and Diesel cycles. It's also known as the semi-diesel cy...

Q: Q2: A Freon -12 installation has the following data: Сараcity: Evaporator temperature : Condenser te...

A: A compressor, condenser, expansion device (which might be a valve, a capillary tube, an engine, or a...

Q: a (m/s²) В 24 A 12 t (s) 30 60

A: for time t= 0 to 30 , a= (12/30 t  a= 0.4 t a=(dV/dt)= 0.4 t integrating we get, velocity= V= 0.2 t2...

Q: (b) Is the 0.03 lb/10° Btu rule more or less restrictive than the 1 percent emission rule?

A: As shown in Table 3.1, there are two cases: (1) the plant began operations on September 18, 1978, an...

Q: find frmperature at the trißle point ? Vapow pressure of.liquid & Sofid ammoni ay are respecfivelcy ...

A:

Q: The velocity field of an incompressible flow is given by V = (a,x + a,y + az)i + (b,x + b,y + b3Z)j ...

A: Given:Velocity field:V=(a1x+a2y+a3z)i + (b1x+b2y+b3z)j + (c1x+c2y+c3z)ka1=2c3=-4

Q: A simply supported beam is subjected to a distributed load of wi=640 N/m and a point load pi = 940 N...

A:

Q: 1. Do a project research based on this topic. Gas turbines are used for many purposes from aeroplane...

A: A gas turbine, additionally called an ignition turbine, is a kind of consistent and gas powered moto...

Q: Consider the steam pipe of Problem 1. The objective is to reduce the heat losses from the steam pipe...

A:

Q: ed arch of span 16 m has its a carries the load system as s.

A: given:

Q: The dimensions of a rectangular beam are limited to b = 300 mm and effective depth, d = 700 mm.  Usi...

A: according to given details 

Q: Clarence was driving his car when he drove into a busy parking lot last Monday morning. Unaware that...

A: Impulse = F * T = M * a * T = M * V/T * T = M * V = 1400 * 12 = 16800 N/s

Q: Determine the time(s) when the acceleration of the vehicle becomes 20m/s^2. The car starts from rest...

A:

Q: ᴀɴ ᴀᴍᴍᴏɴɪᴀ ꜱɪᴍᴘʟᴇ ꜱᴀᴛᴜʀᴀᴛɪᴏɴ ᴄʏᴄʟᴇ ᴏᴘᴇʀᴀᴛᴇꜱ ᴇᴠᴀᴘᴏʀᴀᴛᴏʀ ᴀɴᴅ ᴄᴏɴᴅᴇɴꜱᴇʀ ᴛᴇᴍᴘᴇʀᴀᴛᴜʀᴇꜱ ᴏꜰ -20°ᴄ ᴀɴᴅ 35°ᴄ,...

A:

Q: 2. You wish to lift a 15,000 lb stone by a vertical distance of 25 ft. Unfortunately, you can only g...

A:

Q: Determine displacement

A: Given data : Force=F Work done=W   To find : Displacement

Q: A body hangs from a spring balance supported from the roof of an elevator. If the elevator has an up...

A: Given   Weight, m = 45 lb   Acceleration, a = 4 ft/s2 Find  True weight of the body

Q: A system consisting of 1 lb of water undergoes a power cycle composed of the following processes: 2....

A: Dear student, we are suppose to solve only 3 sub parts. Please post other question as a separate que...

Q: pin at O and the cable AB. The weight W = 7 N is attached to the free end of the cable. a) Determine...

A: Since you have asked a multi-question, thus we can provide you the solution to the first question on...

Q: A steel bar with diameter d1 = 10 mm has upset ends with diameter d2 = 15 mm. The lengths of the bar...

A: Given that, d1=10 mm,d2=15 mm,L1=0.3 m,L2=0.15 m,R=1.25 mm,E=90 GPa,δ=0.5 mm,  

Q: 5. Determine the maximum deflection of the simply supported beam shown. E = 200 GPa and I = 39.9 (10...

A:

Q: Freight car A with a gross weight of 194000 Ib is moving along the horizontal track in a switching y...

A:

Q: 1) A basic, ideal Rankine cycle using water as the working fluid, has a saturated vapor exiting the ...

A: Givenat exit of steam boiler preesure P4=P1=12MPa saturated vapourat condenser exit Pressure P2=P3=4...

Q: Change in specific ENTROPY in the ideal gas from state 1 to state 2.

A: Given; T1=420 KT2=530 KP1=130 KPaP2=480 KPaCP=2 kJ/kg-KCV=0.7 KJ/kg-K Find change in entropy from st...

Q: A HP absorbs 10kW of heat from outside environment at 260K while absorbing 18kW of work. It delivers...

A: Given data,  Q2= heat absorb = 10 kW  T2= 260 K  T1= 300 K  W=work input =18 kW         

Q: n figure has an n of 48 cm/s?. T and AB = BC = 6

A:

Q: A swimmer can swim 30km in 5 hours when swimming along the flow of river. While swimming against the...

A: Given Datad=30kmt=5hour

Q: Then find the current through R for values of 2 2, 10 2, and 1002.

A: To find the current RL

Q: One box contains four cards numbered 1, 3,5,and 6. Another box contains three cards numbered 2, 4, a...

A: Given   First box      Total cards = 4 Second box   Total cards = 3 Find   Probability that the sum ...

Q: For a Gas Turbine, operating in an ideal Brayton cycle, with temperatures being: Input air temperatu...

A: Given:- A Gas Turbine, operating on an ideal Brayton cycle.  Compression pressure ratio (PR) = 17.7...

Q: A HP absorbs 10kW of heat from outside environment at 260K while absorbing 18kW of work. It delivers...

A: Answer: The COP of heat pump is 1.5556.  

Q: 6.1: A single-stage, single-acting air compressor delivers 15 m/min of free air from 1 bar to 8 bar ...

A: We have provided information from the question are, F.A.D=15 m3/min,p1=1 bar ; p2=8 barN=300 r.p.m.n...

Q: A Three cables are joined at the junction ring C. Determine the tensions in cables AC and BC 45 15° ...

A: Answer: (a) The tension in the cable AC is 215.4425 N. (b) The tension in the cable BC is 263.8622 N...

Q: A HP absorbs 10kW of heat from outside environment at 260K while absorbing 18kW of work. It delivers...

A:

Q: A 2.9-kip car speeds up uniformly from 0 to 60 mph in 37 seconds up the 15 e. If the engine has an e...

A:

Q: The rigid, homogeneous slab weighing 600 kN is supported by three rods of identical material and cro...

A: Given   Weight, W = 600 kN Find  Axial force in each rod

Q: mary force i

A:

Q: 3. A fine (thin) ring with a radius 50 mm is being pulled from the surface of water. If the ring has...

A: Given data: m=1.0 gθ=75°r=50 mm Need to determine the force (P) required to pull the ring free from ...

Q: For a steam turbine with the following data: Initial Temperature T0=36,7°C, Final temperature after ...

A: Given that, Initial temperature, T0=36.7 °C,Initial pressure, P0=1 bar,Final temperature of boiler, ...

Q: fx A C 1 1 3 13 4 The image above shows a section of a Google sheet. What formula should be written ...

A: Answer: The correct answer is option (a)  =sum(A1:A3).  

Q: A HP absorbs 10kW of heat from outside environment at 260K while absorbing 18kW of work. It delivers...

A: Given:Qa=10 kWTo=260 KW=18 kWTi=300 K

Q: Consider an ideal gas-turbine cycle with two stages of compression and two stages of expansion. The ...

A: Given Data : Compressor Temperature T1 =300 K Turbine Temperature T5 = 1200 K Pressure Ratio P2P1 = ...

Fluid Kinematics

The branch of science that deals with objects which are either in motion or stationary are studied under the branch of classical mechanics. Fluid mechanics is a subcategory of classical mechanics that deals with the behavior of fluids at rest (fluid statics) or in motion (posing some velocity). In fluid kinematics, studies focus on the associated motion of fluid particles or groups of particles, and its associated parameters like displacements, velocity, and acceleration without concerning about the forces that caused the motion. All the laws of classical mechanics are applied in the study of fluid kinematics.