Draw the moh'r circle Several forces are applied to the pipe assembly shown. Knowing that each section ofpipe has inner and outer diameters equal to 36 and 42 mm, respectively. Assumingthat all stress remains below the proportional limit of the material. Determine theprincipal stresses and principal planes, maximum shearing stress at point H located atthe top of the outer surface of the pipe and draw the oriented elements for thosestresses. Use Mohr's circle to show all the principal stresses.175300150 N250150 NHI225100 N100 N225150 N100 NDimensions in mm

Answered: Image /qna-images/answer/f9da59f2-4296-4fea-ad82-52124ca71879.jpg

Answered: Draw the moh'r circle

Engineering

Mechanical Engineering

Draw the moh'r circle

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

Determine the principal planes and the principal stresses for the state of plane stress resulting from the superposition of the two states of stress shown. Given: X = 60 MPa and Y = 20 MPa. Determine the orientation of the principal plane in the first and second quadrant. Determine the maximum/minimum principal stresses
For the given state of stress, determine (a) the orientation of the planes of maximum in-plane shearing stress, (b) the maximum in-plane shearing stress, (c) the corresponding normal stress.
A single horizontal force P with a magnitude of 150 lb is applied to end Dof lever ABD. Knowing that portion AB of the lever has a diameter of 1.2 in., determine (a) the normal and shearing stresses located at point H and having sides parallel to the x and y axes, (b) the principal planes and princi-pal stresses at point H.
Knowing that the machine component shown has a trapezoidal cross section with a = 2.5 in. and b = 3.5 in., determine the stress at point A and at point B. Take M = 80 kip·in. The stress at point A is ksi. The stress at point B is ksi.
For the given state of stress, determine the normal and shearing stresses after the element shown has been rotated through (a) 25° clockwise, (b) 10° counterclockwise.
Given the plane element shown which is an element acted upon by combined stresses. a. Use Mohr's Circle to determine the maximum shear stress on the element b. Also, using Mohr's Circle determine the maximum normal stress on the element.
The state of stress at a point in a member is shown on the rectangular stress element where the magnitudes of the stresses are |σx|=19 ksi and |σy|=14 ksi. Determine the state of stress on an element rotated such that the +x′ axis is 40∘ below the −x axis of the original stress element.
The shape shown was formed by bending a thin steel plate. Assuming that the thickness t is small compared to the length a of a side of the shape, determine the stress (a) at A, (b) at B, (c) at C.
A 10-kN force and a 2.8-kN·m couple T are applied at the top of the 65-mm-diameter brass post shown. Determine the principal stresses and maximum shearing stress at point H. Determine the principal stresses and maximum shearing stress at point K.
The stress acting on two planes at a point is indicated. Determine the shear stress on plane a–a and the principal stresses at the point.
Suppose that σx = 42 MPa . A) Determine the orientation of principal planes of stress. B) Determine the orientation of the planes of maximum in-plane shear stress.
The stress of member AB is equal to the stress of member BC having a diameter of 100 mm. Determine the diameter of member AB.