dwelling units, the lighting load demand factor for the computed load above 120,000 VA is

Q: What is the third method of checking the condition of a wet or flooded battery ? Explain the…

A: The electrolytic batteries are made up of conducting plates and volatile electrolyte solution, which…

Q: Q1: For the continuous-time signalx(t) shown in Fig.1: a- Sketch x(-2t). b- Sketch x(t/3). c- Sketch…

A: We are authorized to answer three subparts at a time, since you have not mentioned which part you…

Q: + V - C 3 µF + C2 Q2 V2 |4 μΕ C3 03 V3 2 µF E = 120 V +

A:

Q: 3.) Determine the effective resistance between points A and B in the given network below. Express in…

A: In this question,  We need to determine the effective resistance across the terminal A and B.  We…

Q: What will happen if the back emf drops to zero because the external mechanical load stops the…

A: We need to state What will happen if the back emf drops to zero because the external mechanical load…

Q: NOTE: Show COMPLETE Solution, NO Shortcuts. Thank you so much!

A:

Q: 10. By first resolving ¥(z)/z into partial fractions, find 2-l(z)] when ¥(z) is given by (2z + 1)(z…

A:

Q: What is the types of radars using for fixed and moving targets?

A: Brief description: In the above given question they want to know type of radars which are used to…

Q: Answer the following about measuring electricity:

A: We are authorized to answer one question at a time since you have not mentioned which question you…

Q: 11. The supply voltage is 100 V, the armature resistance is 1.3 Ohms, the CEMF is 93 V and the speed…

A: The solution is given below

Q: Which of the following s-plane represents the graph for the system having a transfer function G(s) =…

A: In this question,  We need to determine the representation in the s plane.  If transfer function is…

Q: Q1: check the Circuit is stiff or not ? Bdc = l0 Vce = lov R, Rc lok RE 5.6K 56052

A: The solution is given below

Q: Determine developed torque and shaft torque of 220-V, 4-pole series motor with 900 conductors…

A: This question belongs to electrical machine . It is based on the concept of torque in dc series…

Q: For the schematic diagram below, the switch has been in the position shown for a long time. Then at…

A:

Q: Question 3 For the circuit shown below, please fill the state table. OUT IN Q2 Q1 D D CLK Present…

A:

Q: x(1) Q1: For the continuous-time signal x(t) shown in Fig.1: 6 a- Sketch x(-2t). 3 b- Sketch x(t/3).…

A:

Q: Determine the transfer function

A:

Q: Solve the following circuit using the graph theory approach C2 www R. R L

A: Graph Theory: Simply put, a network graph is referred to as a graph. It is made up of a series of…

Q: 6.) Find the Thevenin's equivalent across 5-ohm resistance (branch AB) and determine its Branch…

A:

Q: Q.5) (a) Find the unknown currents I1, I2 I3 I4, I5 I6 from the Electric circuit in Figure 1. 20 2…

A: Note: As per the policy we can solve only 1 question at once, please re-upload the remaining part as…

Q: r(t) c(t) G,(s) (10s+1)(s+1) 2. For the system above, design lead compensators to meet the following…

A: Given: For the system below: Design lead compensators to meet the following specifications: P.O. =…

Q: 9.11 Find the phasors corresponding to the following signals: (a) v(t) = 21 cos(4t – 15°) V (b) i(t)…

A: As per the guidelines of Bartley we supposed to answer first three subpart only.

Q: Find the equivalent resistance and output voltage ???? of a bridged T network

A: This question belongs to circuit theory . It is based on the concept of delta star transformation ,…

Q: Quizl: Digital Communication Three different information signals each bandlimited to 6kHz, 11kHz,…

A: Digital communications:

Q: When the 10V are applied across a 20-ohm resistor, the current is

A:

Q: Calculate the voltage across the inductor in phasor form

A:

Q: An impedance ZL = (11.5 + j10) ohms is connected in parallel with an impedance ZC = (8 – j20) ohms.…

A:

Q: Draw a circuit that represents the following equation "A•B•C" gate using only 2-imput AND gates.

A:

Q: 5.) Given the Star Connection, convert into equivalent Delta Connection and solve for resistance…

A:

Q: Nuclear Instrumentation and Control A proportional controller has a proportional band value of 50%.…

A:

Q: 3. Determine the nodal voltages for the networks in Figure? 1,- 3AZ0 anee 40 20 I-SAZ 30

A:

Q: The network shown in Figure 2 contains two voltage sources, V, = 3020° and V, = 2020°. Using mesh…

A:

Q: Sketch the transfer curve for p-channel JFET with IDSS 18 mA and Vp -9 V %3D %3!

A: In this question we will draw transfer characteristics for p-  channel JFET.

Q: Find Vo in the circuit and the power dissipated across 30-ohm resistor. 10 Q 24 N 50 N 25 Q 15 V 20…

A:

Q: resistor of 50 ohms, a 200mH inductor, and a 1.5 x 10-4 F capacitor are connected in parallel to a…

A: Since you have asked multiple questions in a single request, we will be answering only the first…

Q: configuration shown below, an n-MOSFET with its drain and gate terminals connected together, is…

A:

Q: Q1 R2 R3 VCC R1 Calculate the value of RB in ohms. at VCC=18 V, IB=27 uA, and VC=6V and B=63

A: Solve the first question, unless the student has asked for a specific question to be solved, subject…

Q: Determine the frequency deviation and carrier swing for a frequency modulated signal which has a…

A: Consider the upper frequency is the sum of the resting frequency and the frequency deviation given…

Q: 1. Draw the circuit diagram in series and parallel connection Given: R1= 5Ω  R2= 7Ω R3= 8Ω Vt=…

A:

Q: A clothes dryer rated at 6kW is connected to a 120/240 V, single-phase, three-wir individual branch…

A: In this question,  We need to choose the correct options What is load current if  total load 6kW…

Q: Two tests were performed on a 4-kVA , 200/400 V transformer to in order to determine its efficiency.…

A:

Q: 2) Sketch the dc load line. Show detailed graph/sketch and computation of values plotted. 3) Is…

A:

Q: 4. A 5kW (shaft power) DC motor has 200 W of electrical losses and 3 W of mechanical losses. Which…

A: The solution is given below

Q: Given the following circuit, what the current through the diode D2 (in mA) if: Vin = 1 V, R1 = 6 k2,…

A:

Q: Use the (integral transformation) definition of the Laplace transforms to find the Laplace transform…

A: In this question, Find the Laplace transform of the given signals using the integral property of the…

Q: Using definition of CTFT, find X(2) for the following x(t). Also plot |X(N)| and /X(2) a. r(t) =…

A: According to the question, we need to find CTFT for the following functions

Q: 12Ω R3 93 E 30 V R2 60 60 V E2

A: The point related to the superposition theorem: To apply superposition,  it is essential that if…

Q: 5. Which type of DC motor should be used if constant speed is needed? series shunt induction…

A: In this question,  We need to choose the correct option Which motor is used for constant speed?

Q: 10. A circuit has a real power of 230 W and a reactive power of -250 VARS. Find the Apparent power…

A: Given, P = 230 W Q = -250 VAR

Q: A 220-V dc shunt motor runs at 500 rpm, when the armature current is 50 A. Calculate the speed if…

A: Given, Problem regarding to shunt motor. Please find the below attachments for the clear…

Electrical Heating Unit

The conversion of electrical energy to heat energy is known as electric heating. The heating system that converts the electrical energy to heat energy for various application is called electrical heating unit. Electricity is employed as the firing mechanism in electric heating systems, which transforms electric current to heat. Electric heaters have heating elements in the form of electric resistors.