The reactive power output of an alternatoris limited by load angleO TrueO False

In this question , we have to explain that which quantity limits reactive power output of an…

Answered: e reactive power output of a mited by…

Engineering

Electrical Engineering

e reactive power output of a mited by load angle True

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter5: Transmission Lines: Steady-state Operation

Section: Chapter Questions

Problem 5.25MCQ

See similar textbooks

Related questions

Q: Q.18: For the circuit shown, find the value of coupling coefficient "k" and put the dots on 50/00 V…

A: Explanation: First, we are calculating the total impedance Considering the dotes are placed at the…

Q: Q8. Which of the following is possible value of crest factor for a non-liner load current? (ay 1.5…

A: Crest factor It is the ratio of peak value to the effective value of given signal

Q: A 5000KVA, 6600V, 3 star connected alternator has a resistance of 0.75 per phase Estimate by ZPF…

Q: A smaller lagging reactive power drawn by a circuit, consists of power factor zero Smaller greater…

A: the power factor value is depends on the amount of reactive power drawn by the load

Q: (a) the full load efficiency at unity power factor;

Q: Draw the block diagram of a load frequency control of a single area power system

A: Load-frequency control (LFC) : For large scale electric power systems with interconnected areas,…

Q: Power factor correction sub-stations are located at the beginning of the distribution system. Select…

A: the given question is from the topic power factor correction.

Q: A power station is to supply two loads. The daily load curve of the station is as shown in figure…

A: Given: A power station which is supplying two loads and the daily load curve. Also the load factor…

Q: Q.6 (a) Explain in detail the four-quadrant operation of chopper and how it is differed from dual…

A: Operation of four quadrant chopper four quadrant chopper consists of four semiconductor switches and…

Q: 8. An alternator requires an excitation of 2A to produce on short circuit its full load current of…

Q: A step-down chopper, with voltage source 20V. If the duty cycle is 50% and chop frequency is 0.1Hz,…

A: In this question , step down chopper is given...We have to find out ON time of chopper and average…

Q: A power station is to supply two loads. The daily load curve of the station is as shown in figure…

Q: 2A P-POle theee-Phase in duetion machine with sPetint od istribution of stator wihdings is essumed…

A: Three-phase Induction Machine:- A three-phase balanced winding in the stator of the Induction motor…

Q: Consider the circuit diagram below. Draw the power triangle for this circuit and compute the power…

A: Given:R1=150ΩC1=120μF ,L1 =850mHXC=1jwC1=1j2π×30×120×10-6=-j44.209ΩXL=jwL1=j2π×30×850×10-3=j160.22Ω

Q: a-Calculate and draw the load current for the first two-period interval b-Calculate and draw the…

Q: (a) The base impedance in (N) (b) The reactive power drawn by the load (p.u.) (c) The total current…

Q: A generating station is to supply four regions of load whose peak loads are10 MW, 5 MW, 8 MW and 7…

A: Given that, The peak load demand of four regions which are supplied by a generating station are 10…

Q: Two generators are supplying a load. Both the generators have a no-load frequency of 61.5 Hz and the…

Q: homework, Ofind a-point values Iecsat) Ves Ceutoft)- sketch Dc load Line and indicate 7cC 20V loks…

A: The given circuit is shown below:

Q: A power station is to supply four regions of loads whose peak values are 10,000 kW, 5000 kW, 8000 kW…

A: The solution can be achieved as follows.

Q: D0 kW. The diversity factor of the load at the station is 1.5 and Calculate the maximum demand on…

A: In this question, we have given individual maximum demand, diversity factor and average annual load…

Q: A generating station is to supply four regions of load whose peak loads are 10 MW, 5 MW, 8 MW and 7…

A: Given that, Peak loads are 10 MW, 5 MW, 8 MW, and 7 MW diversity factor=2 average annual load factor…

Q: 37. 29 Discuss the causes and consequences of harmonic distortion Enlict the Power quality issues…

A: Given We need to elaborate the causes and consequences of harmonic distortion in power systems.…

Q: Manufacturers usually specify the impedances of machines and transformers in O Percent O Per-unit O…

A: Need to Find correct option

Q: A step-down chopper, with voltage source 20V. If the duty cycle is 50 frequency is 0.1Hz, Find…

Q: 4. For the netwoYk Shown below sketch vo and determine Vor 2k2 12oyc'rms)

Q: Q.22: For the magnetically coupled circuit shown, find the voltage across (-J100) 100° impedance and…

A: For the magnetically coupled circuit shown calculation of voltage across (-j10 ohm) impedance and…

Q: The load current at which maximum efficiency occurs is independent of the load power factor. Select…

A: We need to find The load current at which maximum efficiency occurs is independent of the load…

Q: During balanced load condition the current flowing through the neutral is

Q: 2. calculate the n at 25% , 50% , 75% , 100% and 125% full load condition for u.p.f and 0.8 p.f lag…

Q: A generating station has a maximum demand of 20MW,a load factor of 60%, a plant capacity factor of…

Q: Find the complex power delivered to the load that draw: 500 VA and leading power factor of 0.75.…

Q: HW In the chopper circuit shown, E = 220U, L = 1.5mH R = 0.5 and it is operating with T=3ms and Ton…

A: Given data, The supply voltage (E)= 220V The given inductance(L) = 1.5mH The value of resistance (R)…

Q: Reactive Power Compensation Regulation, capacitive reactive power should not exceed what percent of…

A: Reactive Power Compensation Since the major load in power systems is an inductive load that…

Q: For the shown rms. ind the value of coupling coefficient "k" and put J60 J72 the dots on the coils,…

Q: Units SI Nominal power and frequency [Pn(VA) fn(Hz)]: 250e6 50 ] Winding 1 parameters [V1(Vrms)…

A: Given data,

Q: source, Vcs. rces, if it is supplier or receiver of power. Ix + Vcs IB 30 ID –5V 8V

A: In this question, we have to find out four currents..And 2 voltages..

Q: 3. A load of 40+j55 ohm is connected across a 120-Volt source. Determine the value of the reactive…

A: Given parameters: Load resistance, RL = 40 + j55 ohm Source voltage, Vs = 120 V To find: Reactive…

Q: A 65KVA load with a lagging powner factor is combined with a 25-kIA synchronous motor load which…

A: According to the question we have to calculate the value of power factor.

Q: At low power factor, the feeders have to carry more current for the same power to be tra Select one:…

Q: 2. Distribution factor proportional with......

A: Note: As per our rule we’ll answer the first question since the exact one wasn’t specified. Please…

Q: non-sinusoidal quasi-square wave voltage v(t) is applied to a nonlinear load, resulting in a…

Q: Pzi- The of abalanced Y connected load is- Each phase of the load cousist of loL30 s2 Find the Line…

Q: A power station has a maximum demand of 13590 kW. The annual load factor is 60% and plant capacity…

A: We have an power station and the data given about that power factor as below, Maximum Demand = 13590…

Q: The substation power factor is found from the total reactive and real powers of the various loads…

Q: O O A.C. distribution calculationg differ from of d.c. distribation power factor, vectarially…

A: For DC distribution frequency is 0, also there is no phase so addition is algebrically.

Q: 2. In your own words, explain : a. What is reactive power? b. What is average power? C. What is…

A: As per the guidelines of Bartley we supposed to answer first question only for solution of remaining…

Q: ) A single-phase full-wave AC voltage controller consists of two SCRs connected in invers-parallel.…

A: “Since you have posted a question with multiple sub-parts, we will solve the first three sub-parts…

Q: 3- draw the load line then determine the start point below Vce +10 V 1 KO Rg B=120 80 k2 VBB=6V

A: To solve above problem, one should know about DC analysis of BJT. DC analysis of transistor is done…

Question

The reactive power output of an alternator
is limited by load angle
O True
O False

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

A source supplies power to the following three loads connected in parallel: (1) a lighting load drawing 10kW. (2) an induction motor drawing 10kVA at 0.90 power factor lagging, and (3) a synchronous motor operating at 10hp,85 effIciency and 0.95 power factor leading (1hp=0.746kW). Determine the real, reactive, and apparent power delivered by the source. Also, draw the source power triangle.
The power factor for an inductive circuit (R-L load), in which the current lags the voltage, is said to be (a) Lagging (b) Leading (c) Zero
Convert the following instantaneous currents to phasors, using cos(t) as the reference. Give your answers in both rectangular and polar form. (a) i(t)=5002cos(t30) (b) i(t)=4sin(t+30) (c) i(t)=5cos(t15)+42sin(t+30)
The total instantaneous power delivered by a three-phase generator under balanced operating conditions is (a) A function of time (b) A constant
The power factor for a capacitive circuit (R-C load), in which the current leads the voltage, is said to be (a) Lagging (b) Leading (c) One
A 60Hz, single-phase source with V=27730 volts is applied to a circuit element. (a) Determine the instantaneous source voltage. Also determine the phasor and instantaneous currents entering the positive terminal if the circuit element is (b) a 20 resistor. (C) a 10mH inductor, and (d) a capacitor with 25 reactance.
You are an electrician working in an industrial plant. A 30-hp three-phase induction motor has a current draw of 36 amperes at full load. The motor is connected to a 480-volt line. A three-phase wattmeter indicates a true power of 22 kW. Determine the power factor of the motor and the amount of capacitance needed to correct the power factor to 95. Also determine the minimum voltage rating of the capacitors. The capacitors are to be connected in wye.
The speed of a synchronous motor is fixed by the a. rotor winding. b. amortisseur winding. c. supply voltage. d. frequency of power supply and number of poles.
The total instantaneous power absorbed by a three-phase motor (under balanced steady-state conditions) as well as a balanced three-phase impedance load is (a) A constant (b) A function of time
A smaller lagging reactive power drawn by a circuit, consists of_________ power factor Smaller zero greater not effects
a load of 15 mva with power factor 0.86 lagging is given. Calculate the reactive power delivered by shunt capacitors to increase power factor to 0.9 lagging
The harmonic which would be totally elimanated from the alternator emf using fractional pitch of 4/5 is