Answered: Find the approximate dc voltage…

Find the approximate dc voltage produced by a center tapped full wave rectifier, if the peak output voltage is 8 V and the diode cut in voltage is 0.7V O 3.3 V O 2.5 V O 7.3 V O 5V

Electricity for Refrigeration, Heating, and Air Conditioning (MindTap Course List)

10th Edition

ISBN:9781337399128

Author:Russell E. Smith

Publisher:Russell E. Smith

Chapter12: Electronic Control Devices

Section: Chapter Questions

Problem 3RQ: Diodes and rectifiers allow current to _________. flow in one direction only flow in both...

See similar textbooks

Related questions

Q: Given a half wave rectifier wiith input voltage at the primary of 110 volts rms and turns ratio of…

A: Given:Vrms = 110VNPNS =10load resistance =5000Ω1) At primary,Vrms =Vpeak2Vpeak=2×110 =…

Q: half-wave rectifier using an ideal diode is connected to an input of 24V 50Hz AC, what is the…

A: A half-wave rectifier using an ideal diode is connected to an input of 24V 50Hz AC, what is the…

Q: A half-wave rectifier with the diode arrow pointing away from the load has a DC output voltage of…

A: In this answer we will try to find the DC output voltage which is nothing but the average output…

Q: b) Consider a full wave center tap rectifier circuit made up of silicon diodes, containing output ac…

A: Centre tapped full wave rectifier,

Q: 7 Full-Wave Rectification 28. A full-wave bridge rectifier with a 120-V rms sinusoidal input has a…

A: In this question full wave bridge rectifier is given...We have to find dc voltage at load ,PIV of…

Q: 1- The process of adding an impurity to an intrinsic semiconductor is called. 2- The maximum number…

A: According to the bartleby's guidelines we have to solve only first three subparts of a question so…

Q: In a full wave rectifier circuit involving double diodes, a sinusoidal input signal of the following…

A: A full-wave rectifier is a circuit that converts the alternating voltage into direct voltage.

Q: A half-wave recitifier is connected to a 50V AC source. If the load resistance is 100 ohms, find:

Q: An ac supply of 220 V is applied to a half-wave rectifier circuit through transformer with a turns…

Q: 28. A full-wave bridge rectifier with a 120-V rms sinusoidal input has a load resistor of 1 kN. a.…

A: Since you have asked multiple questions in a single request, we will be answering only the first…

Q: Find the approximate dc voltage produced by a center tapped full wave rectifier, if the peak output…

A: Find the output voltage of the centre tap. Rectifier. Peak voltage Vm= 8V Diode cut off voltage…

Q: A full-wave bridge rectifier with a 236.86V p-p sinusoidal input has a load resister of 2KΩ i. Draw…

A: "Since you have posted a question with multiple sub parts we will solve first three subpart for you…

Q: 29.A simple half-wave rectifier consists of a diode and load. If the internal resistance of the…

Q: Determine the peak output voltage for the bridge rectifier in this figure. Assuming the practical…

Q: 2. A full-wave bridge type rectifier with a 120 Vrms sinusoidal input has a load resistor of 1 kN.…

A: We need to find dc voltage and PIV .

Q: In a fully controlled rectifier with RL load and freewheeling diode. Which of the given condition is…

A: Fully controlled rectifier with RL. Load The period of the free wheeling diode?

Q: 2. A full-wave bridge type rectifier with a 120 Vrms sinusoidal input has a load resistor of 1 kN.…

A: The solution is given below

Q: Find the level of Vo for each circuit shown in the Figure below. Also, determine the status of each…

Q: If a diode full wave rectifier circuit is excited by an ac source with an amplitude of 10 V and…

A: For a full wave rectifier circuit using diodes, if VP is the amplitude of the ac signal voltage…

Q: A full-wave bridge rectifier with a 314 V peak sinusoidal input has a load resistor of 10.6 KO 1. If…

A: Full wave bridge Rectifier peak voltage 314V load resistance 10.6k ohm 1. Average voltage 2. PIV?

Q: A three-phase half wave rectifier has a supply of 150V/phase. Determine the mean load voltage and…

A: Efficiency of Rectifier: The ratio of d.c power output to the applied input a.c power is known as…

Q: Exam: Find the output waveform for the following full wave rectifier and the current pass through…

A: To solve above problem, one should know what converter or rectifier circuit and how it is working.…

Q: What is the relevance of the PIV rating of a diode? What will happen if a diode is operated beyond…

A: PIV( peak inverse voltage) It is defined for diode in non- conducting or reverse biased condition.…

Q: Analyse the circuit (write all necessary steps and formulae required and upload the answer sheet) D₂…

Q: A classical rectifier is to be designed to provide 5V ± 1% for a logic circuit, with output power of…

A: Given:Vout = 5V ±17°Pout = 12WVin = 120Vf = 50Hzi) and ii)Diode configuration is full wave bridge…

Q: a to Bis the conduction period in single phase half wave controlled rectifier with RL load without…

A: we will draw the output voltage of half wave controlled recifier with RL load and without…

Q: Q1/ a/Draw the output voltage waveform for the bridge rectifier in this figure : D D4 120 V ms B/…

A: This is full wave Rectifier, Draw the output waveform of the given circuit. What's peak inverse…

Q: Compare the DC output voltages of the three rectifier circuits. Full-Wave Bridge Rectifier ▪…

A: We need to find out dc output voltage and peak inversion voltage for different rectifier .

Q: Sketch VL and IL for the given half-wave rectifier.

Q: Exercise 3 Compare between Half-wave and Full-wave in term of the following: a- Number of diodes b-…

Q: A full-wave bridge rectifier with a 120-V rms sinusoidal input has a load resistor of 1 k_. (a) If…

A: “Since you have posted a question with multiple sub-parts, we will solve first three subparts for…

Q: Consider a full wave bridge rectifier, whose transformer secondary voltage is 130sinwt. If the…

Q: Given a half wave rectifier with input ac voltage of 200 Vrms, a transformer turns ratio of 18:3 and…

A: In the half wave rectifier Find the peak voltage in primary side Secondary side Peak value of load…

Q: What is value of form factor and ripple factor of half wave diode rectifier. I know the values…

A: Given rectifier is half wave diode rectifier.

Q: Determine VL, IL, IZ and IR

A: APPLY KVL to input loop 25-IR.RS –Vz =0 IR =25-6.2/270 =0.06963 IR=69.63 Iz max =Pz.max…

Q: a/Draw the output voltage waveform for the bridge rectifier in this figure : 120 V s B/ What PIV…

Q: Compare the output waveform for Half-Wave Rectifier with and without capacitor.

A: From the given question we need to compare the output waveform for half-wave rectifier with and…

Q: Explain the principle operation for a diode and how it is used as a rectifier.

A: Diode is a two terminal device which have two terminals such as a anode and cathode. Diode easy…

Q: Analyse the circuit ( write all necessary steps and formulae required and upload the answer sheet)…

Q: Answer the following. Use a detailed explanation. In the characteristic curve of the diode what…

A: Characteristics of diode is given by below curve,

Q: 3. An SCR full-wave rectifier supplies to a load of 200 Q. If the peak a.c. voltage between centre…

Q: For the half-wave rectifier given in the figure below, find the average values of the output voltage…

A: It is given that : It is Half-Wave Rectifier. Vmax = 169.71 V F=50 Hz. R=1 kΩ

Q: 2. What is the value of the peak inverse voltage on the diode in half -wave rectifier?

A: As per Bartleby guidelines we are allowed to solve only three subparts please ask the rest again.…

Q: Q3: Determine Vout, PIV and Ripple factor for the following circuit considering Ideal and practical…

A: Assume the turns ratio is 10:1 ; fin =60 Hz Peak primary voltage Vp(primary) = 2 x 150 = 212.13 V…

Q: Write the following for a half wave controlled rectifier with RL load and freewheeling diode a) Draw…

Q: Determine the ripple factor for the filtered rectifier circuit below when RL= 4KQ. Then explain…

A: Solution : The peak to peak variation of the output of a rectifier is called as ripple factor.…

Q: Design a full wave bridge rectifier power supply to deliver an average voltage of 20 V with a…

A: Given Data: Average output = 20 V Peak to peak ripple voltage = 0.1 V Average load current = 15 mA…

Q: Give a conclusion regarding the experiment of pn junction applications: rectifiers, clippers and…

A: A diode is a two-terminal one-way switch, it will only allow the flow of current in one direction,…

Q: Q7. What is the specialty of Zener diode so as we can operate it in breakdown region for longer…

A: Since zener diodes are highly doped than a normal diode and hence depletion layer is less wider as…

Concept explainers

Applications of Diode

Diodes are the two-terminal components used in many electronics and electrical applications. The current flow in such components is unidirectional. A diode provides very low resistance in one direction, but in the opposite direction, it provides very high resistance. One of the common functions of a diode is to allow the current flow in the forward direction and resist the current flow in the reverse direction. However, besides this simple functioning of diodes, diodes generally show non-linear current-voltage characteristics. For instance, the semiconductor diodes conduct current only when a certain threshold voltage, or preferably cut-off voltage is reached in the forward direction. They are known as forward-biased diodes. Also, upon reaching a certain voltage, known as the breakdown voltage, the high resistance provided by diodes in the reverse direction reaches a low resistance value.

Question

Find the approximate dc voltage produced by a center tapped full wave rectifier, if the peak output voltage is 8 V and the diode
cut in voltage is 0.7V
O 3.3 V
O 2.5 V
O 7.3 V
O 5V

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 3 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

How is a solid-state diode tested? Explain.
What is CEMF?
Diodes and rectifiers allow current to _________. flow in one direction only flow in both directions divide paths of flow none of the above
Sketch VL and IL for the given half-wave rectifier.
What is the approximate rms value of secondary voltage to get a peak load voltage of 40 V out of a bridge rectifier? Ignore diode drop.
Consider the half-wave rectifier shown in the figure below. Let vs be a sinusoidal with 10V peak amplitude with frequency of 60Hz and let R = 1000 ohms. Use the contant voltage-drop diode model with VD = 0.7 V.
In a center-tapped full wave rectifier circuit utilizing ideal diodes, if the primary voltage is 160Vpeak, the turns ratio is 8:1 and the load resistance is 860 ohms, what is the rectified dc voltage at the output? express answer in volts
A bridge rectifier circuit has secondary voltage of 12 V Assume secondary resistance and diode forward resistance to be negligible. Load resistance is 100(ohm.) Calculate peak load current, DC load current, rms current and across each diode.
For a single phase half wave rectifier feeding 10 ohms load with input supply voltage of 796 V and frequency of 50Hz, Determine Pac, Pdc, FF, RF, TUF, PIV of the diode, and input PF
. If the peak output voltage of a bridge full-wave rectifier is 50 V, determine the minimum value ofthe load resistance that can be used when 1N4002 diodes are used
In a full wave rectifier circuit involving double diodes, a sinusoidal input signal of the following nature is applied e=10 sin(500*pi*t) V. What will be value of the dc voltage obtained at the output of the rectifier.
Give the difference between zener diode and an ordinary rectifier diode