4. please give correct answer PROBLEM SET #4_EFFECTIVE STRESSES IN SOILProblem 4. A 20m thick submerged saturated clay layer has water content of 57%. The specific gravity ofthe solid particle is 2.84.1. Determine the density of the clay in kg/m³.2. Determine the total vertical stress at the bottom of the clay layer in kpa.3. Determine the effective vertical stress at the bottom of the clay layer in kpa.

ESSES IN SOIL oblem 4. A 20m thick submerged saturated clay layer has water content of 57%. The specific gravity of solid particle is 2.84. Determine the density of the clay in kg/m³. Determine the total vertical stress at the bottom of the clay layer in kpa. Determine the effective vertical stress at the bottom of the clay layer in kpa.

ESSES IN SOIL oblem 4. A 20m thick submerged saturated clay layer has water content of 57%. The specific gravity of solid particle is 2.84. Determine the density of the clay in kg/m³. Determine the total vertical stress at the bottom of the clay layer in kpa. Determine the effective vertical stress at the bottom of the clay layer in kpa.

Fundamentals of Geotechnical Engineering (MindTap Course List)

5th Edition

ISBN:9781305635180

Author:Braja M. Das, Nagaratnam Sivakugan

Publisher:Braja M. Das, Nagaratnam Sivakugan

Chapter8: Stresses In A Soil Mass

Section: Chapter Questions

Problem 8.12P

See similar textbooks

Similar questions

Refer to Figure 10.48. If R = 4 m and hw = height of water = 5 m, determine the vertical stress increases 2 m below the loaded area at radial distances where r = 0, 2, 4, 6, and 8 m. Circular contact area of radius R on the ground surface Figure 10.48
A soil profile consists of a sand layer underlain by a clay layer, as shown. If the degree of saturation of the sand above water table was 50%. Saturated and dry unit weight of sand are 21.2 kN/m^3 and 18.22 kN/m^3 respectively. The saturated unit weight of clay is 18 kN/m3. Determine the total stress, pore pressure and effective stress at point A,B,C.
Effective Stresses in Soil Problem 4. A 20m thick submerged saturated clay layer has water content of 57%. The specific gravity of the solid particle is 2.84. 1.Determine the density of the clay in kg/m³. 2.Determine the total vertical stress at the bottom of the clay layer in kpa. 3.Determine the effective vertical stress at the bottom of the clay layer in kpa.
Problem 1 A ground profile consists of 2 m of silty sand underlain by 3 m of clay. The ground water table is 3 m below the ground surface. The sand has a unit weight of 14 kN/m3. The clay has unit weight of 16 kN/m3 above the water table and 20 kN/m3 below the water table. a. Determine the total stress at bottom of the clay b. Determine the pore water pressure at the bottom of the clay c. Determine the effective stress at the bottom of the clay Problem 2 50 ft thick sand is underlain by 25 ft clay. The ground water table, initially at the ground surface, was lowered to a depth of 25 ft below the ground. After such lowering, the degree of saturation of the sand above water table was lowered to 20%. Saturated and dry unit weight of sand are 135 pcf and 116 pcf respectively. The saturated unit weight of clay is 120 pcf. a. What is the vertical effective pressure at the midheight of the clay layer before lowering of the water table in psf? b. What is the vertical effective pressure at the…
A soil profile is shown in Figure Q3(b)(i). The groundwater level is located on the ground surface. The sand layer is under artesian pressure where the excess pore water pressure is 40 kN/m^2. (i) Calculate the total vertical stress, pore water pressure and effective vertical stress at the base of each layer. (ii)Determine the increment of the effective stress at the base of sand layer if the 1.5m height fill will be imposed on the ground surface. Note that, the density of the fill material is 1750 kg/m^3. (iii) The excavation will be made in the clay layer for the basement construction. Evaluate the stability of the soil from boiling or quick condition. The depth of the excavation is shown in Figure Q3(b)(ii). (iv)Propose the maximum depth of cut that can be made to avoid boiling or quick condition.
A layer of soil has the following properties: void ratio = 0.44, effective diameter = 12 μm, capillary constant C = 0.18 cm2 . Groundwater table is 10 m below the ground surface. (a) Find the height of capillary rise in the soil in mm. (b) What is the effective stress in kPa at 7 m depth if unit weight of solids is 25.55 kN/m3 and soil above the capillary zone is 40 % saturated? (c) What is the effective stress in kPa at 14 m depth?
Effective Stress in Soil Problem 1. The water table in a certain deposit of soil is at a depth of 2m below the ground surface. The soil consists of clay up to depth of 4m from the ground and below which lies sand. The clay soil is saturated even above the water table: Clay strata: ? = 30%,?? = 2.72 Sandy Strata: ? = 26%, ?? = 2.64 1. Compute the total pressure. 2. Compute the pore water pressure. 3. Compute the effective stress pressure at a depth of 8m below the ground surface
For a site, there is a layer of sand, 5.3m thick, that lies over a clay layer of 1.2m. The water table is 1.3m below the ground surface. The saturated unit weights of the sand and clay are 21.6 kN/m3 and 18.8 kN/m3, respectively. The unit weight of sand above the water table is 17.2 kN/m3. Determine the total vertical stress, porewater pressure and effective vertical stress at the bottom of each layer. Plot the values found in (a) against the depth below ground level. If the water table rises up to an elevation of 0.7 m above the ground level, what will the total vertical stress, pore water pressure and effective vertical stress at the bottom of the clay layer?
Caculate the total, neutral and effective stress (kPa) at the base of each soil layer listed below. Assume the water table rest 4 m below ground surface and that there is a capillary rise of 1 m above the water table. Provide your answers in kPa to 1 decimal place. Use 9.81 kN/m3 as the unit weight of water. Total Neutral Effective Silty Sand: 5m thick, γt = 17.5 kN/m3, γsat = 18.5 kN/m3, Blank 1 Blank 2 Blank 3 Clay: 4m thick, γt = 16.5 kN/m3, γsat = 17.8 kN/m3, Blank 4 Blank 5 Blank 6 Sand: 6m thick, γt = 17.3 kN/m3, γsat = 18.1 kN/m3, Blank 7 Blank 8 Blank 9
A)Plot graphically all the vertical stresses, pore water and effective vertical stresses throughout the depth. B)How would the effective vertical stress value at the midpoint of the clay layer change if the groundwater level increased 2 m? (g = 10 m / s2)
A saturated clay layer has a thickness of 10 meters with a water content of 51% and a specific gravity 2.72. Determine the following: 1. Saturated unit weight of the clay * a. 21.46 kN/m³ b. 18.12 kN/m³ c. 16.87 kN/m³ d. 14.95 kN/m³ 2. total stress at depth of 10 meters a. 122.1 kPa b. 151.3 kPa c. 168.7 kPa d. 142.5 kPa 3. Effective stress at depth of 10 meters a. 42.1 kPa b. 70.6 kPa c. 68.7 kPa d. 82.5 kPa
Determine the total vertical stress, pore water pressure, and the effective stress of the soil mass at the Centre of the clay layer and at the Centre of the sand layer for the conditions stated below.