Explain, motorcycle engine is either considered as free or forced convection. Justify your answer. Explain, motorcycle engine is either considered as free or forced convection. Justify your answer.

Convection is described as a phenomenon in which the alteration of heat takes place by the motion of…

Answered: Explain, motorcycle engine is either…

Engineering

Mechanical Engineering

Explain, motorcycle engine is either considered as free or forced convection. Justify your answer.

Principles of Heat Transfer (Activate Learning with these NEW titles from Engineering!)

8th Edition

ISBN:9781305387102

Author:Kreith, Frank; Manglik, Raj M.

Publisher:Kreith, Frank; Manglik, Raj M.

Chapter7: Forced Convection Inside Tubes And Ducts

Section: Chapter Questions

Problem 7.22P

See similar textbooks

Related questions

Q: How is the angular momentum equation obtained from Reynolds transport equations?

A: For a system of force, From the above expression,

Q: Consider two concentric horizontal cylinders of diameters 55 cm and 65 cm, and length 125 cm. The…

A: Given Data Length of the horizontal cylinder, L=125cm=1.25m The diameter of the inner cylinder,…

Q: The top surface of the passenger car of a train moving at a velocity of 70 km/h is 2.8 m wide and 8…

A: Write the given data Note the relative velocity of the air will be same as the velocity of the…

Q: Air flows across a 20-cm-square plate with a velocity of 5 my/s. Free-stream conditions are 10:C and…

A: In general, there are three modes by which heat gets transferred from one place to another. The…

Q: 31. A uniformly heated square plate of 2 ft x 2 ft is exposed to cold air at 80 F. The heater output…

A: following is the solution to the above problem-

Q: Q3/ An average person generates heat at a rate of 84 W while resting. Assuming one-quarter of this…

Q: 1- Air at 288.8 k and 101.32 kPa with a free stream velocity of 3.05 m/s is flowing parallel to a…

A: Given:

Q: What are the turbulence intensity differences on offshore and onshore?

A: Turbulence intensity differences on offshore and onshore ;

Q: Water at 20°C is flowing with velocity of 0.89 m/s between two parallel flat plates placed 1 cm…

A: Given: V=0.89 m/s Temperature of water = 20℃ ρ=998.0 kg/m3 μ=1.002 x 10-3 kg/m.s Pr=7.01 To find:…

Q: Flat-plate solar collectors are often tilted up towardthe sun in order to intercept a greater amount…

A: Write the given information.

Q: Why do we classify partial differential equations?

A: The classification of partial differential equation helps in knowing the initial and boundary…

Q: Water at a temperature of 25oC flows parallel over a flat plate with free-stream velocity of 2 m/s.…

Q: A 4-m x 4-m flat plate maintained at a constant temperature of 80°C is subjected to parallel flow of…

Q: An array of power transistors, dissipating 6W of power each, are to be cooled by mounting them on a…

Q: Air at temperature 20 C and pressure 1 atm, flow over a flat plate at 3 m/s. The surface temperature…

Q: A 1.2-in-outer-diameter pipe is to span across a river at a 115-ft-wide section while being…

A: Given: The outer diameter of the pipe is D=1.2 in. The width of the river is W=115 ft. The average…

Q: In flow over bluff bodies such as a cylinder, how does the pressure drag differ from the friction…

A: The pressure drag is generated due to the shape of the object and it depends on the flow of…

Q: Four power transistors, each dissipating 12 W, are mounted on a thin vertical aluminum plate (k =…

A: The properties of air at 40 degrees Celsius and 1 atm pressure are: The Reynolds number of the flow…

Q: Consider a snowpack of height 30.0 cm, temperature -5.0°C, and density of 420 kg/m'. Isothermal…

A: Given data, Height of snowpack, h = 0.3 m Temperature of the snow, Tsnow = -5 °C Density of snow,…

Q: The relation of flow between parallel flat plates is

Q: and Surface temperature 4. In what functions does Nusselt number in natural convection differ from…

Q: QO What are the types of convection heat transfer?

A: Heat transfer takes place in three types 1. Conduction 2. Convection 3. Radiation

Q: Explain and discuss the significance of (i) Rayleigh number and (ii) Nusselt number in natural…

Q: A large vertical plate 6.1 m high and 1.22 m wide is maintained at a constant temperature of 57+C…

A: Determine the mean film temperature

Q: Engine oil at 83°C flows over the upper surface of a 5-m-long flat plate whose temperature is 18°C…

Q: Explain, motorcycle engine is either considered as free or forced convection. Justify your answer

A: Motor cycle engine is the 4-stroke petrol engine. Large amount of heat is created from the 2-stroke…

Q: What is the effect of streamlining on (a) friction drag and (b) pressure drag? Does the total drag…

A: Effect of streamlining on:

Q: 5-39 Air at 1 atm and 300 K blows across a 50-cm-square flat plate at a velocity such that the…

Q: Calculate the heat transfer from a 60 cm x 60 cm plate on which air flows at 40 C and. The plate…

Q: Flue gases from an incinerator are released to atmosphere using a stack that is 0.6 m in diameter…

A: Given : The diameter of stack = 0.6 m The height of the stack = 10 m Surface temperature of the…

Q: A 1.2-in-outer-diameter pipe is to span across a river at a 140-ft-wide section while being…

A: Given data as per question Diameter of pipe =1.2 in Flow velocity = 10ft/s

Q: Hot carbon dioxide exhaust gas at 1 atm is being cooled by flat plates. The gas at 220oC flows in…

Q: A Gasoline engine operating on an air standard condition has a clearance volume of 15cm^3 and a…

A: Given data Clearance volume = 15 cm³ Displacement volume = 100 cm³

Q: average wind velocity. & A 1.8-m-diameter spherical tank of negligible thickness contains iced water…

Q: A 2m by 3m flat plate is suspended in a room, and is subjected to air flow parallel to its surfaces…

Q: The local atmospheric pressure in Denver, Colorado (elevation 1610 m), is 83.4 kPa. Air at this…

A: (a) The average temperature is written as, The properties of air at this temperature are given as,…

Q: Q2: Explain, motorcycle engine is either considered as free or forced convection. Justify your…

A: Heat transfer is carried out by three phenomenon 1) Conduction 2) Convection 3) radiation Convection…

Q: What is lift? What causes it? Does wall shear contribute to the lift?

A: given: What is lift? What causes it? Does wall shear contribute to the lift?

Q: How is convection caused? Explain with an example?

A: When any fluid is heated, then its lower layer will get heated first, which makes the molecules at…

Q: QUESTION 3 a) During a cold winter day, wind at 55 km/h is blowing parallel to a 4-m-high and…

A: Dear student, According to the guidelines I am allowed to answer only one…

Q: Air flows over a l-meter-wide flat plate at a constant velocity of 20 m/s and ambient conditions of…

Q: What is the difference between streamlined and bluff bodies? Is a tennis ball a streamlined or bluff…

A: If bodies subjected to fluid,flow can be classified as sreamlined or bluff body. a body is said to…

Q: Two 10-cm x 40-cm boards are mounted 2.5 cm apart as shown in Figure 7.29. Air at 20°C enters the…

A: Given: H=2.5 cm L=40cmm˙=0.04 kg/sTm,i=20oC Bulk mean temperature of fluid at…

Question

Explain, motorcycle engine is either considered as free or forced convection. Justify your answer.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, mechanical-engineering and related others by exploring similar questions and additional content below.

Similar questions

Explain, motorcycle engine is either considered as free or forced convection. Justify your answer
Explain and discuss the significance of (i) Rayleigh number and (ii) Nusselt number in natural convection
An average person generates heat at a rate of 84 W while resting. Assuming one-quarter of this heat is lost from the head and disregarding radiation, determine the average surface temperature of the head when it is not covered and is subjected to winds at 10°C and 25 km/h. The head can be approximated as a 30-cm-diameter sphere. Assume a surface temperature of 15°C for evaluation of ms. Is this a good assumption?
Question No. 3: During a cold winter day, wind at 55 km/h is blowing parallel to a 4-m-high and 10-m-long wall of a house. If the air outside is at 5°C and the surface temperature of the wall is12°C, determine the rate of heat loss from that wall by convection. What would your answer be if the wind velocity was doubled
A 4-m x 4-m flat plate maintained at a constant temperature of 80°C is subjected to parallel flow of air at 1 atm, 20°C, and 10 m/s. The total drag force acting on the upper surface of the plate is measured to be 2.4 N. Using momentum heat transfer analogy, determine the average convection heat transfer coefficient, and the rate of heat transfer between the upper surface of the plate and the air
A 10-cm shaft rides in a 10.03-cm sleeve and 12-cm long, the clearance space (assumed to be uniform) being filled with lubricating oil (? = 0.11 ?? − ?). Calculate the rate at which heat is generated when the shaft turns at 100 rpm in Watts (W). (Rate of energy = Frictional force/resistance x Velocity)
During a cold winter day, wind at 55 km/h is blowing parallel to a 4m high and 10m long wall of a house. If the air outside is at 5 degrees Celsius and the surface temperature of the wall is 12 degrees Celsius , determine the rate of heat loss from the wall by convection. What would your answer be if the wind velocity has doubled? From Table A-1:thermal conductivity, k = 0.0246 W/m degrees Celsiusviscosity, v = 1.4 x 10^-5 m^2/sPrandtl no. Pr = 0.717
A Gasoline engine operating on an air standard condition has a clearance volume of 15cm3 and a displacement volume of 100cm3 . Determine the theoretical thermal efficiency of the engine.
Q3: Air flows across a 20-cm-square plate with a velocity of $ m/s. Free-stream conditions are 10-C and 0.2 atm. A heater in the plate surface furnishes a constant heat-flux condition at the wall so that the average wall temperature is 100-C. Calculate the surface heat flux and the value of h at an x position of 10 cm. Answers: Q= 1414 W, b= 13.3 Wm?.C
What is natural convection? How does it differ from forced convection? What force causes natural convection currents?
Flue gases from an incinerator are released to atmosphere using a stack that is 0.6 m in diameter and 10.0 m high. The outer surface of the stack is at 40°C and the surrounding air is at 10°C. Determine the rate of heat transfer from the stack assuming (a) there is no wind and (b) the stack is exposed to 20 km/h winds.
Q6: A large vertical plate 6.1 m high and 1.22 m wide is maintained at a constant temperature of 57+C and exposed to atmospheric air at 4°C. Calculate the heat lost by the plate. Answers: Q=1907 W