Answered: explain the relationship between the…

explain the relationship between the refractice index of a mixture and the molar fractions of the соmponents *refractive

Fundamentals Of Analytical Chemistry

9th Edition

ISBN:9781285640686

Author:Skoog

Publisher:Skoog

Chapter25: Instruments For Optical Spectrometry

Section: Chapter Questions

Problem 25.4QAP

See similar textbooks

Related questions

Q: It is observed that the critical micelle concentration of sodium dodecyl sulfate in aqueous solution…

A: A micelle is an aggregate of molecule in colloidal solution such as those formed by detergents. The…

Q: In stationary chromatography, the distribution (K) is the main criterion for the division of species…

A: Solution - stationary chromatography - Chromatography is a separation process involving two phases,…

Q: 9. R. Aveyard & co-workers (J. Chem. Soc., Farad Trans., 86, 211 ( 1990 ) have measured the surface…

A: The surface excess concentration Γ is the area-related concentration of a surfactant at the surface…

Q: Distinguish between voltammetry and amperometry

A: 1) Voltammetry is an analytical technique in which variable potential is applied to the working…

Q: 1.13 Which of the following is a parameter that cannọt be obtained by a typical DLS experiment? O…

A: Please find your solution below : Dynamic light scattering (DLS) also known as Photon correlation…

Q: Calculate the density of Tungsten(W) with miller indices [1 1 0 ]

A: Given plane is (110). a = 0.3165 nm Since tungsten crystallize in BCC unit cell. Usethe below…

Q: Which of the following parameter correlate inversely with surfactant penetration into skin? Micelle…

A: As per the rules only the first question can be answered:

Q: The diffusion coefficient of I2 in hexane at 25 °C is 4.05 × 10−9 m2 s−1. Estimate the time required…

Q: When the Si—OH groups on a silica capillary wall are converted into Si—O(CH2)17CH3 groups, the…

A: Electro-osmosis is a kinetic process in which the transport of bulk fluid through a porous membrane…

Q: .

A: Dilute solution viscosity measurement for polymer molecular weight determination: Dilute solution…

Q: The diffusion coefficient of CCl4 in heptane at 25 °C is 3.17 × 10−9 m2 s−1. Estimate the time…

A: Diffusion coefficient tells about relation about molar flux and gradient in concentration of the…

Q: At 25 °C the molar ionic conductivities of Li+, Na+, and K+ are 3.87 mS m2 mol−1, 5.01 mS m2 mol−1,…

A: Mobility "u" formula is: Substitute the given conductivities of the given ions in this formula to…

Q: How long is a macrocentury, if a lecture period (50.0 min) is close to 1.00 microcentury?

A: Given: 1.00 microcentury = 50.0 min approx.

Q: What is the gravimetric factor if a weight of cl is to be determined from a weight of PbCl2?

A: A gravimetric factor converts grams of a compound into grams of a single element. Example-…

Q: When 10 mL of water at 20oC is placed in an Ostwald viscometer, it takes 136.5 s for the liquid…

A: Formula to calculate the viscosity of hexane as follows: ηC6H14 = ηH2OηC6H14tC6H14 / ρH2OtH2O Here,…

Q: Why in microstructure visualization etchants are used? Explain

A: Etchants selectively corrode some of those elements, which show up as darker regions. This is…

Q: What do you mean by Critical Micelle Concentration (CMC)?

A: Surfactants comprise chemicals that seem to be interfacially active. A polar head cluster as well as…

Q: You are making orange soda from an orange flavor emulsion. The density of the orange oil is 0.85…

A: Given: density of orange oil = 0.85 g/cm3 density of 10% sugar solution = 1.04 g/cm3 radius = 3 mm u…

Q: The following tests are used for control of organic impurities in organic medicinal substances,…

A: Option B is correct.

Q: Why does the glass transition for a polymer yield no exothermic or endothermic peak?

A: The glass transition for a polymer yield no exothermic or endothermic peak.

Q: 3) Figure below shows an x-ray diffraction pattem for single crystal scandium nitride (ScN), having…

Q: 4. Determine the expected diffraction angle for the first-order reflection from the (113) set of…

Q: At 25 °C the molar ionic conductivities of F−, Cl−, and Br− are 5.54 mS m2 mol−1, 7.635 mS m2 mol−1,…

A: To determine the mobilities of the ions F−, Cl−, and Br− if their conductivities are 5.54 mS m2…

Q: It is usually recommended to clean the glass surfaces of a refractometer with ethanol or isopropyl…

A: Refractometer is a device that measure the degree to which light changes direction called as angle…

Q: When the distribution coefficient increases, the extraction efficiency increases or decreases

A: Distribution coefficient is the ration of concentration of solute in organic phase over…

Q: The radius of gyration of a three-dimensional partially rigid polymer of 1500 units each of length…

A: The radius of gyration around an axis is known as a radial distance to a point where moment of…

Q: Molar absorptivity is a constant dependent on the following except: a. wavelength. b. solvent. c.…

Q: A solution consisting of isobutyl bromide and isobutyl chloride is found to have a refractive index…

A: According to the given problem a solution consisting of isobutyl bromide and isobutyl chloride is…

Q: What is the valency factor (n-factor) of sodium oxalate?

A: The question is based on the concept of valency factor. we have to determine valency factor of…

Q: A student performed the fractional distillation of a cyclohexane/toluene mixture. The refractive…

A: Mole fraction is the ratio of moles of solute to that of total moles of solution. Mole percentage of…

Q: Do the conclusion to polymer molecular weight determination by dilute solution viscosity…

A: Dilute Solution Viscosity measurement is the viscosity measurement of dilute solutions of polymer…

Q: The diffusion coefficient of hemoglobin in water at 20°C is equal to 6.9 x 10-11 m2 s-1. Assuming…

A: Since you have asked multiple questions, and the first question is incomplete, we will solve the…

Q: The following data were obtained for four compounds separated on a 20 m capillary coloumn. Compound…

A: We can calculate the number of theoretical plates , average Number of theoretical plates, and…

Q: The following data apply to a 1g sample of a granular powder Volume of the solid alone = 1 cm3/2g…

A: Given: Volume of the solid alone = volume of grain = 1 cm3/2g Volume of intraparticle pores = pore…

Q: Two commonly used chromatography methods in labs are Nickel and streptavidin resin based colums.…

A: it

Q: A student performed the fractional distillation of a cyclohexane/toluene mixture. The refractive…

Q: Calculate the surface excess of solute given the following data:Molar concentration in bulk solution…

A: The volume of 1.0 dm3 to 1000 cm3. The surface excess of the solute is calculated as shown below.

Q: What factor(s) will affect the magnitude of hysteresis of sorption isotherm? I. The nature of food.…

A: factor(s) will affect the magnitude of hysteresis of sorption isotherm

Q: Obtain the linear attenuation coefficient of PVC (C2H3Cl)3 with a density of 1.4 g/cm^3.

A: The attenuation coefficient is a measurement of how strongly a chemical species attenuates light at…

Q: It requires 40 sec for a volume of water, density 1.0 g/ cm³, to flow through a capillary viscometer…

A: Given that, Viscosity of water = 0.01 poise. Time taken by water = 40 sec. Time taken by glycerin…

Q: Describe principles of separation by capillary isotachophoresis (CI) using a diagram

A: Isotachophoresis is a technique used for selective separation and concentration of ionic analytes.…

Q: Write the Lineweaver–Burk (doublereciprocal) equation and describe thefeatures of a Lineweaver–Burk…

A: A double-reciprocal or Lineweaver Burk plot is a graphical representation of the Lineweaver burk…

Q: -forming density gradients in respect of the following: I. Type of gradient material used. II. The…

A: Rate-zonal separation and isopycnic separation will be the two primary forms of density gradient…

Question

explain the relationship between the refractice index
of a mixture and the molar fractions of the
соmponents
*refractive

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step 3

VIEW

Step by step

Solved in 3 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, chemistry and related others by exploring similar questions and additional content below.

Similar questions

3.Explainthethin-layerchromatographicpuritycheckprocedureforanalysisofanunknownorganic compound.
A student performed the fractional distillation of a cyclohexane/toluene mixture. The refractive index of the distillate was measured at 1.4301 with an ambient temperature of 22.0oC. What is the mole percentage of cyclohexane (to 3 sf)?
Which composite or chemical wouldyou prefer to capture infrared lighton the beryllium surface mirrors?
Calculate the molar refraction of CCl4.when it's density is 1.595gcm3 and refractive index is 1.4574.
A solution consisting of isobutyl bromide and isobutyl chloride is found to have a refractive index of 1.3931 at 20°C. The refractive indices at 20°C of isobutyl bromide and isobutyl chloride are 1.4368 and 1.3785, respectively. Determine the molar composition (in percent) of the mixture by assuming a linear relation between the refractive index and the molar composition of the mixture.
What is the maximum number of unpaired delectrons that anatom or ion can possess? Give an example of an atom and an ionthat have this number.
The polarizability volume of H2O at optical frequencies is 1.5 × 10−24 cm3. Estimate the refractive index of water. The experimental value is 1.33.
What happen to the separation raid (RS) I change the mobile phase from methanol/water 70/30 till methanol/water 80/20. How does polarity affect?
Briefly describe how a phase-contrast microscope work and the kind of image that itproduces. Give a specific use for this type of microscope.
What is the first-order scintillation angle of the shimmering x-rays of a crystal surface with a distance between planes of 0.204 nm and a wavelength of 0.154 nm.
It is observed that the critical micelle concentration of sodium dodecyl sulfate in aqueous solution decreases as the concentration of added sodium chlordie increases. Explain this effect.
Assuming that the density of silica gel is 2.65 g cm-3 and that the silica particle are spherical with an average radius of 5 x 10-6 cm, calculate the estimated surface area Sest. Why is there such a large difference between S and Sest?