Answered: -forming density gradients in respect…

-forming density gradients in respect of the following: I. Type of gradient material used. II. The mode of gradient formatio

Fundamentals Of Analytical Chemistry

9th Edition

ISBN:9781285640686

Author:Skoog

Publisher:Skoog

Chapter33: High-performance Liquid Chromatography

Section: Chapter Questions

Problem 33.9QAP

See similar textbooks

Related questions

Q: sely proportional to the column efficiency irectly proportional to the selectivity factor not…

A: B option is correct. Inversely proportional to column efficiency. Band-broadening is a general term…

Q: For samples with broad boiling points components in GC separations, it is important to establish…

A: The solution is given below -

Q: Smaller particles affect HPLC column efficiency in what ways? A)increase the mass transfer term.…

A: High performance liquid chromatography or HPLC is an analytical technique used to identify and…

Q: Why is gradient elution used

A: In this elution process, mobile phase strength is changed during the separation process.

Q: What other method besides conductivity can be used to determine CMC (critical micelle…

A: Critical micelle concentration (CMC) can be determined by conductometric titration.

Q: The original solution was diluted by a factor of three, and then the absorbance of the diluted…

A: According to Lambert Beer law, the absorbance of a solution is directly proportional to its…

Q: The following data were obtained for four compounds separated on a 20-m capillary column. t, (min) w…

Q: An open tubular column with an inner diameter of 0.25 mm had a volumetric flow rate of 0.95 min-1 .…

Q: The osmosis rate in these set-ups will slow down over time. Why?

A: Osmosis is the process of diffusion (movement of particles or molecules) of water across a…

Q: If the concentration in a bulk solution adjacent to a fibrous medium is at a concentration cA…

A: The relation to calculate the partition coefficient is shown below. K=CSCM Here, CM is the…

Q: Suppose that after delivery several drops of water cling to the inner wall of the pipet (because the…

A: Density is physical quantity that can be determined with the help of mass and volume of the given…

Q: The cool plasma tail needs to be removed in regular ICP-OES analysis using the axial view. Provide…

A: A question about spectroscopy, which is to be accomplished.

Q: a) In any gas chromatographic analysis, exceeding a column's maximum temperature limit will usually…

A: Gas chromatography

Q: This refers to a point wherein both liquid phases have the same composition. Hence, extraction is…

A: Answer: This question is based on the Liquid-liquid extraction where certain terms are used to…

Q: Which of the following is the correct flow of the mobile phase in HPLC? Solvent degasser>Guard…

A: The mobile phase in HPLC is used to transport the sample via seperation column and there by detector…

Q: Find the weighted adjacency matrix of the following direted graph and represent that as a CSR-marix.

A: Weighted Adjacency Matrix: It is 2-D array which represents a data structure which can say that…

Q: If the radius of column 0.25 cm, the linear.3 velocity of mobile phase 10.0 cm/min, and the fraction…

Q: Assume an organic compound has a partition cocfficient between water and ethyl acetate equal to…

Q: What is the difference between isocratic and gradient elution?

Q: Describe the mechanisms of strength at the peak hardness of a precipitation hardened alloy when both…

Q: a) The relationship between permeate weight and time with fabrics. b) The characteristic of fabrics…

Q: This is the graph for gel filtration chromatography. Can you please explain why the graph has the…

A: Gel filtration chromatography is a variant of size exclusion chromatography that can be employed to…

Q: When the distribution coefficient increases, the extraction efficiency increases or decreases

A: Distribution coefficient is the ration of concentration of solute in organic phase over…

Q: Point out TWO (2) strategies to increase selectivity in solid phase extractions.

A: A question based on analytical separations that is to be accomplished.

Q: What are the benefits of decreasing the column internal diameter? O Increased sample capacity O…

A: Answer - The correct option is (c) Increased resolution Explanation - As we lower the internal…

Q: Calculate the mole fractions of SO2•H2O, HSO3- and SO3 2- in solution at a pH of 3.0, characteristic…

A: Given: pH of 3.0 Total concentration of S(IV) in solution for 20 ppb SO2 in the gas phase.

Q: In lab two dikferent mobile phase compositions were used for column Chromatoghaphy. DiSCUSShow the…

A: The solution of the answer is given below:

Q: Small explanation needed. In reverse-phased separations, _______ column volume(S) of initial…

A: When two or more substances are mixed in a definite proportion, it yields the mixture. The…

Q: Draw a sample calibration curve for quantitative determination of phosphate using flow injection…

A: Solution The activity curve could be a plot of however the instrumental response, the questionable…

Q: a) The figure that follows is an idealized enlargement of the region near the cinnamaldehyde peak.…

Q: A dry-wet-dry oxidation cycle of 20 min – 80 min – 20 min is performed at 1100 °C. (a) What is the…

A: <100>Silicon wafer:

Q: which of the four binary mobile phase compositions (mixing ratio 1: 1) shown below will have the…

A: The polar and non-polar compounds are: Non-polar - Pentane, toluene. Polar - Methanol, acetone,…

Q: Sketch a graph of the van Deemter equation (plate height versus flow rate). What would the curve…

A: The van Deemter equation is a relationship between the height of the plate during the flow of mobile…

Q: Estimate the mixing ratio of NO in the following condition: NOx 30 ppb, 03 = 100 ppb, [M] = 2.5x1019…

Q: During Buchner filtrati on a portion of the filtrate isused for swirling the resi due into the…

A: SOLUTION: Step 1: A Buchner funnel is a piece of laboratory equipment used in filtration. It is a…

Q: Air displacement pipettes is ALWAYS MORE accurate than Mohr and serological pipettes because…

A: To determine whether the given statement is true or false and if false, determine the word that…

Q: pt: The analyte component interacting most strongly with the stationary phase faster than those with…

A: Part A: We know that, the components that adhere more strongly to the stationary phase travel more…

Q: e absolute flash-point temperature in K and R?

Q: What are the disadvantages of using a non- ideal linear velocity on the chromatographic separation…

Q: Differential migration of the components is called a of the chromatogram.

A: Differential migration is the basis of chromatography. In a mobile phase, the solutes transit…

Q: Given the volume of 0.2000 M NAOH used determine the concentration of 10.00 ml sample each from…

A: Given, Volume of NaOH for Aq layer = 12.55 mL Volume of NaOH for Or layer = 15.27 mL Concentration…

Q: draw a sample calibration curve for quantitative determination of phosphate using flow injection…

A: As per the Beer's Lambert law, A=εCL Here, A=absorbance C=concentration ε=molar absorptivity…

Q: A silver-30%gold alloy sample (cylindrical with 1 cm diameter and 0.3 cm height) is subjected to a…

A: The time can be calculated by Faraday's law, m = EitFm: mass of silveri: current (Ampere)F:…

Q: 1. Part A Solution temperature = 24 °C ce%3D Conductivity of instrument grade water = 1.043 uScm!…

Q: In Chromatography - Equilibrium Binding Isotherms, If diffusion and dispersion are negligible a)…

Question

Differentiate between preformed and self-forming density gradients in respect of the following: I. Type of gradient material used. II. The mode of gradient formation.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, chemistry and related others by exploring similar questions and additional content below.

Similar questions

What other method besides conductivity can be used to determine CMC (critical micelle concentration)?
When the distribution coefficient increases, the extraction efficiency increases or decreases
Find the weighted adjacency matrix of the following direted graph and represent that as a CSR-marix.
Why does the efficiency (decreased plate height) of liquid chromatography increase as the stationary phase particle size is reduced?
Sketch a graph of the van Deemter equation (plate height versus flow rate). What would the curve look like if the multiple path term were 0? If longitudinal diffusion were 0? If the finite equilibration time were 0?
In the following figure, which parameter of van Deemter equation is involved in these variations. Which curve of them would provide the best separation of analytes and at what linear velocity?
If the radius of column 0.25 cm, the linear.3 velocity of mobile phase 10.0 cm/min, and the fraction of the column accessible to the mobile phase 0.50, then the flow rate of the mobile phase ??
Substances A and B with capacity factors 6.3 and 11.4, respectively, are being carried by a mobile phaseflowing at a velocity of 0.53 mm/s. What is the length of a column required to separate these two substanceswith a resolution of 1? Assume that the sample zones for both A and B broaden based on the van Deemter equation H = 0.35 + 0.48/u+ 0.57u where Hand u are expressed in µm and mm/s, respectively.
hree components in a mixture have varying distribution constants between the mobile phase and the stationary phass One of the components has a very low distribution constant, Would this component likely elute first or last and how would you design an experiment or modify the components of the separation to make it perform in the opposite manner?
A water sample was analyzed for Fe content using the iron-phenanthroline method. The following data were obtained from the analysis: Determine the value of the slope (m), y-intercept (b), and the coefficient of determination (r2)
What effect will the following have on plate height (H). Make sure to explain your full and complete reasoning. Increasing stationary phase thickness. Reducing the rate of sample injection. Increasing mobile phase flow rate. Decreasing temperature. Reducing stationary phase particle size.
What effect will the following have on plate height (H). Make sure to explain your full and complete reasoning. Reducing the rate of sample injection.