f the Zn +2 and Cu +2 concentrations were both 1 M (standard conditions), the E°. qual to 1.1037 Volts. Explain why the Ecell would not be affected if the concentr oth 0.5 M (non-standard concentrations). Use a simple calculation to support- xplanation.

f the Zn +2 and Cu +2 concentrations were both 1 M (standard conditions), the E°. qual to 1.1037 Volts. Explain why the Ecell would not be affected if the concentr oth 0.5 M (non-standard concentrations). Use a simple calculation to support- xplanation.

Chemistry: Principles and Reactions

8th Edition

ISBN:9781305079373

Author:William L. Masterton, Cecile N. Hurley

Publisher:William L. Masterton, Cecile N. Hurley

Chapter17: Electrochemistry

Section: Chapter Questions

Problem 66QAP: Consider a voltaic cell in which the following reaction takes place in basic medium at 25°C....

See similar textbooks

Related questions

Q: 4. What is the capacitance of an empty parallel-plate capacitor with metal plates that each have an…

A: Capacitance is directly proportional to area and inversely proportional to distance

Q: (c) the copper ion concentration [Cu2+] in g/L. Consider the cathodic reaction only and assume…

A: Since you are asking for only part (c) so here is the answer of part (c) only.

Q: Determine the molar mass (amu) of Metal (M) if it took 2.35 minutes for a current of 1.06 A to plate…

Q: Cu| Cu2+ (x M) || Cu2+ (y M) | Cu Verify the accuracy of the cell potentials measured at 27.5°C…

A: Concentration cells are the electrochemical cells that contain same electrode and electrolyte in the…

Q: ELECTROCHEMISTRY: Calculate the required voltage (V) if an unknown metal (M) was electrodeposited…

A: Given: Current = 6.86 A Time passed = 9 hour Power = 0.1573 KWh. Current efficiency = 80 %

Q: f. if the [Ge*™] is increased to 2.0 M, will the reaction be i. More thermodynamically favored or…

Q: 3. Over the temperature range of 273-353 K-and at 1 atm. Pressure-the emf (E) of a certain galvanic…

Q: The maximum electric field in a reverse-biased semiconductor p-n junction at T-300K is to be…

Q: calculate the Standard Potential for neaction CuBris) +é e Culs) + Br2 tor CuBrksp=5.2x10 b) Give…

A: Given: Ksp= 5.2 x 10-9

Q: The resistances of a series of aqueous NaCl solutions, formed by successive dilution of a sample,…

A: Kohlrausch's Law According to Kohlrausch's Law, an electrolyte's equivalent conductivity at infinite…

Q: 11 - What is the ratio (i / ij) if nc = -0.01V for a two electrons reduction reaction at 298K?

Q: Careful measurements of the potential of the cell Pt|H2(g.pe)|NaOH(aq,0.0100 mol kg-4),NaCl(aq,…

Q: Question attached

Q: The resistances of a series of aqueous NaCI solutions, formed by successive dilution of a sample,…

A: SOLUTION: Step 1: (a) The molar conductivity Ʌm, is related to the conductivity k by the relation,…

Q: When standardised with 0.01 M KCI, a conductivity cell had a resistance of 189 n at 298 K. At same…

Q: Calculate the required voltage (V) if an unknown metal (M) was electrodeposited from an aqueous…

A: Electrical energy=0.1145 kWh

Q: An atomic beam is designed to function with (a) cadmium, (b) mercury. The source is an oven…

A: Given: Temperature, T=380 K Dimensions=1 cm×1 cm×10-3 cm Vapor pressure of Cadmium=0.13…

Q: In an experiment involving Pt electrode in H*/H2 electrode, the following data were obtained.…

Q: Calculate the required voltage (V) if an unknown metal (M) was electrodeposited from an aqueous…

A: Answer: Since, current efficiency given is 93%, therefore actual current passed…

Q: Name the advantages of glass electrode in potentiometric measurements (please write correctly and…

A: Following are the advantages of glass electrodes in potentiometric measurements.

Q: Chemistry The exchange current density for the electrode Pt(s) │|H2(g) │|H+(aq) is 0.79mA cm-2 at…

A: We have find out current density and anode current.

Q: A typical exchange-current density, that for H+ discharge at platinum, is 0.79 mA cm−2 at 25 °C. Use…

Q: Ti3+ is to be generated in 0.10 M HCIO, for coulometric reduction of azobenzene. TiO2+ + 2 H+ +e¯…

Q: Over the temperature range of 273-353 K-and at 1 atm. Pressure-the emf (E) of a certain galvanic…

A: The equation representing the emf of a certain galvanic cell over a temperature range and a constant…

Q: For the reaction Zn(s) + Cu2+(aq) - 5 Zn2+(aq) + Cu(s), ∆G° at 25°C is -212,300 Jmol-1. Calculate…

A: The value of Ecell ( electromotive force ) has to be calculated.

Q: 2. The following data was reported for the cell Ag(s)|AgBr(s)|HBr(aq)|Br,(g, latm)|Pt T('C) 538.3…

A: A numerical problem based on temperature coefficient of cell, which is to be accomplished.

Q: The corrosion potential of mild steel in a deaerated solution of pH = 2 is -0.64 V versus saturated…

A: Steel is an alloy of mainly iron and carbon, with iron being the major constituent. So, we'll…

Q: 1. Caleulate th equilibrium constant at 2s E For thereaction: 2H"+ " + Dacg) = Hzegs2D From the…

A: GIVEN:-

Q: The exchange-current density for a Pt|Fe3+,Fe2+ electrode is 2.5 mA cm−2. The standard potential of…

A: Given current density j°=2.5 mA = 2.5/1000 A = 0.0025 A transfer coefficient a = 0.58 Standard…

Q: The electromotive force of the following cell at 298 K is 1,2272 V: Zn(s) |ZnCL (0,0050 mol kg')…

A: The overall cell reaction can be written as: Zn(s)+Hg2Cl2(s)↔Zn2+(aq)+2Cl-(aq)+2Hg(l)

Q: An aqueous sodium chloride solution is electrolyzed using a current of 4.42 A. How much time (min)…

A: An aqueous sodium chloride solution is electrolyzed using a current of 4.42 A. How much time (min)…

Q: From the Nerst equation E = EO + RT/nF In a. show that for a pH electrode that an uncertainty in the…

A: The Nernst Equation enables the determination of cell potential under non-standard conditions. It…

Q: A comosion cell i made of Zn anode electrode (E0-0 762 V, -01 V and i10mAcm) and ahydrogen electrode…

A: To determine: The rate of corrosion of Zn electrode?

Q: Calculate the ionic strength of a solution that is 0.20 M in FeCl3 and 0.10 M in FeCl2 wmn mw is n

Q: The Nernst equation contains the reaction quotient Q. For cells involving solids and aqueous…

A: Solid concentration is defined as equal to 1

Q: Choose the best answer Ecell for Pt|H2 (p=1 atm)lH*(m)||Cl|Hg2Cl2[Hg|Pt is 0.398 V at 1.0 atm and…

Q: 7. In an experiment on the Pt| H2| H electrode in dilute H:SO4, the following current densities were…

Q: For tempratumes in the 400kg the eguilibrium constant for the reaction th+(e] resasonibly the…

Q: A Zn/air battery contains a Zn plate immersed in 0.644 M ZnCl2 at one ele and air passing over a…

A: pplying the Nernst equation to a simple electrochemical cell such as the Zn/Cu cell allows us to see…

Q: d) Prove that for two electrodes of the same metal coupled and immersed in electrolytes of…

A: #(d): In the given Galvanic cell, the electrode is the same in both the half-cells. But the…

Q: Calculate the G in kJ for the following cell: Al(s)|Al3+(0.0035M)||Fe3+(0.55M)|Fe(s) Eocell=+1.59 V…

A: Solving only first question in accordance with guidelines. First we will calculate Ecell using…

Q: 6. The corrosion potential of mild steel in a deaerated solution of pH = 2 is -0.64 V versus…

A: The reactions that occur in the given cell are stated below:

Q: In an experiment involving Pt electrode in H'H, electrode, the following data were obtained.…

Q: Draw and explain the cyclic voltammogram of [Pt (p-tap) (tb cat)] in CH3CN at Pt disk electrode,…

Q: 2. Determine Ecell (in V) at 298.15 K for a cell composed of a platinum electrode in a mixture of…

Q: Calculate tafel constant (b) for the electrode equilibrium: MM2+ + 2e. where the transfer…

A: Introduction : M--->M2++2e- We have to calculate tafel constant . Transfer coefficient ,a =0.34

Question

2. If the Zn +2 and Cu +2 concentrations were both 1 M (standard conditions), the E° cell Would be
equal to 1.1037 Volts. Explain why the Ecell Would not be affected if the concentrations were
both 0.5 M (non-standard concentrations). Use a simple calculation to support your
explanation.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, chemistry and related others by exploring similar questions and additional content below.

Similar questions

A metallurgist wants to gold-plate an object with a surface area of 17.21 in2. The gold plating must be 0.00200 in. thick (assume uniform thickness). (a) How many grams of gold (d=10.5g/cm3) are required? (b) How many minutes will it take to plate the object from a solution of AuCN using a current of 7.00 A? Assume 100% efficiency.
Calculate the voltages of the following cells at 25°C and under the following conditions: (a) Zn|Zn2+(0.50M)Cd2+(0.020M)|Cd (b) Cu|Cu2+(0.0010M)H+(0.010M)|H2(1.00atm)|Pt
Calculate the voltages of the following cells at 25°C and under the following conditions: (a) Cu|Cu+(0.80M)Hg22+(0.10M)|Hg|Pt (b) Cr|Cr3+(0.615M)Ni2+(0.228M)|Ni
Consider a voltaic cell in which the following reaction takes place in basic medium at 25°C. 2NO3-(aq)+3S2(aq)+4H2O3S(s)+2NO(g)+8OH(aq) (a) Calculate E°. (b) Write the Nernst equation for the cell E. (c) Calculate E under the following conditions: PNO=0.994atm,ph=13.7,[S2]=0.154M,[NO3-]=0.472M, .
What is the voltage of a concentration cell of Cl ions where the concentrations are 1.045 and 0.085 M? What the spontaneous reaction?