Consider the following waveform.Volts12t (sec)Find the RMS value of the voltage waveform. Find the average power if 8 N resistor,connected across the voltage source v(t).(a) 8.165 V, 133.3 W(b) 4.260 V, 66.65 W(c) 4.082 V, 2.083 W(d) 8.33 V, 17.36 WAnswerAВC

To solve above problem, one should know about different characteristics of waveform: Time Period:…

Answered: Find the RMS value of the voltage…

Find the RMS value of the voltage waveform. Find the average power if 8 N resisto connected across the voltage source v(t).

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter2: Fundamentals

Section: Chapter Questions

Problem 2.2MCQ: If the rms phasor of a voltage is given by V=12060 volts, then the corresponding v(t) is given by...

See similar textbooks

Related questions

Q: The effective value of the sinusoidal voltage across a certain network is 32 V rms and the peak…

A: Given data, Ip = 24 mA. Vrms = 32 V. P = 0.48 W.

Q: An audio power amplifier delivers a 30 volt RMS 1 kHz sine to a loudspeaker. If the loudspeaker…

A: Given data, RMS voltage Vr=20 V Impedance is given Z=7∠450

Q: Determine the average power that is being supplied or absorbed at each element. R, +, R$2052 100°…

A: In an AC circuit, the average power is only consumed by resistor in the AC circuit and the average…

Q: In the series-parallel circuit shown, the RMS value of the voltage across the parallel part of the…

Q: what is the average power absorbed by the load ZL in watts? Assume source is in rms.

A: The solution can be achieved as follows.

Q: 1. a) Find the rms value of the periodic voltage shown .2. b) If this voltage is applied to the…

A: From the figure time period of the graph is RMS voltage is given by,

Q: Given the AC signal: v= 200 Sin (377t-30) a) What is the RMS voltage? b) What is the period of this…

A: Given: AC signal v=200sin377t-30°

Q: Compute the rms value of the voltage waveform shown v(t) (V) 4 4 2 4 6 8 t (s)

A: Rms value of signal = sqrt(integral(v(t)2)dt) Using above integral find the rms value of the signal.

Q: The voltage and current at the terminals of a network are v = 15+400 cos 500t+100 sin 1500t V, i =…

Q: Find the average and rms value of x(t).x(t) = 2 cos(ωt) + 2.5

A: The RMS value of the function x(t) is given by the following expression. The above expression…

Q: 17 The voltage a cross a load impedance is V = 12270° V and the current through it is I = 32-20° A…

Q: 1. Let us assume the "Saw-Tooth" signal is having amplitude X. Check the Average & RMS values are…

Q: 2. Find the RMS value of the voltage waveform and the average power absorbed by the 9 ohms resistor…

A: We need to find out RMS value and power absorbed by resistor .

Q: Determine the following: (a) The components present in the circuit. (b) The rms value of the…

A: Note- Same frequency of voltage produces same frequency of current. Voltage leads current in…

Q: A current is represented by its equation 10 sin(ωt + 30degrees) and 5 sin (ωt – 30degrees). the…

Q: v(t). 2 1 2 3 4 5| -4

A: The circuit this is excited the use of alternating supply is referred to as an AC Circuit. The…

Q: An AC generator produces a sinusoidal waveform, given by the expression: (t) = -25 sin(150nt – 30°)…

Q: CALCULATE THE RMS VALUE IN V OF THIS SIGNAL SHOWN BELOW: 4v = 4 V + 6 sen wt 6 V 4 V wt

Q: Ques. 1: Determine the power and the rms value for each the given signal:(10 + 2sin3t)cos10t.

A: The given signal is: x(t) = (10+2sin3t) cos10t x(t) = 10cos10t +2sin3t cos10t x(t) = 10cos10t + sin…

Q: An AC generator produces a sinusoidal waveform, given by the expression: (t) = -25 sin(150nt – 30°)…

Q: 1. v(t) (volt) +V 10 S →t (sec.) 8s (sinusaia) V=22 (a) Determine the Average value (Vag) for the…

A: The entire waveform given is a combination of various waveforms. It is given that the peak to peak…

Q: Find the rms value of the full wave rectified sine wave in figure shown below. Calculate the average…

A: We need to find out RMS Value and power for given waveform .

Q: (Square wave) 10 V | 2 3 t (ms) -10 V

Q: the equationof alternating voltage is given by v=325.22 sin314t. find(i) RMS value (ii) frequency…

Q: Determine the rms value of the periodic waveform below. The y axis is expressed in Volts and x axis…

Q: Compute the rms value of the waveform shown over half cycle Xm

A: RMS of AC is that value which when passes through a resistor of known value for a particular…

Q: Find the RMS value of the current waveform and the average power absorbed by the 9 ohms resistor if…

A: In this question we need to find a RMS value of the given waveform and average power.

Q: Find the rms value of the voltage waveform shown below. If the voltage is applied to a 9-Q resistor,…

A: In this question we will find average power absorbed by resistor...

Q: From the figure, find the average power (Average power) supplied to the elements. When the current…

Q: 2. Find the RMS value of the voltage waveform and the average power absorbed by the 9 ohms resistor…

A: We will find out RMS value for given waveform and power for given resistor

Q: Find the RMS Voltage and Average Voltage based from the graph

A: It is given that:

Q: Find the rms value of the given waveform

A: Given waveform,

Q: Find the rms value of the given voltage wave 1 2 3 4

Q: For the circuit shown, what is the reactive power, Q, consumed by the load impedance? (Assume the…

A: The given circuit is:

Q: 1. Compute the rms value of the waveform show below. v(t). 2 14 6 8 lho t

Q: i, = 3 sin(377t + 60°) R1.2 N XL 1.20 Ω Χ. 20 Xc

Q: i(f) A Answers: 2.31 A, 10.67 W 0 1 2 3 4 5 6 t

A: The solution is given below

Q: Consider the sinusoidal voltage v(t) = 80 cos (1000nt -30°) V. A. What is the maximum amplitude of…

A: Given data, Voltage equation is given, vt=80cos1000πt-300 V Standard equation is given by,…

Q: 169sin 377t a) What is the RMS value? b) What is the Average value?

A: Given: Let V=169sin 377t

Q: Find power factor of given circuit 30/0° V rms -j22 ww

A: The cosine of the phase difference between voltage and current is known as power factor. Power…

Q: If the line voltage is 115 Vrms, a turns ratio of 5;1 means the rms secondary voltage is closest to

Q: The expression T I = i°(t)dt T defines: Select one: 1. RMS value of the current 2. Average value of…

A: We will write Expression for each of the options given in the question and than we will answer the…

Q: Compute for the value of the impedance load that will absorb a maximum average power.

Q: 1. The average value of each signal 2. The RMS value of each signal T T T/2 T/2 Sinusoidal Square…

Q: В 1 2 3 4 5 6 7 8 t [s] i. 3 V ii. 1 V iii. 2 V iv. 8 V V. 4 V W (1)A

A: The circuit this is excited the use of alternating supply is referred to as an AC Circuit. The…

Q: Find the rms value of the periodic waveform of the figure below over one full cycle. Av (V) 1 cycle…

A: Average Value of a signal: It's that steady state equivalent of a time varying signal which would…

Q: Problem 5 i(t). 10 2 6 8 10 4 -10 In the Figure shown above, find : (a) The rms value of the current…

A: Please refer the attached images for the complete answer..

Q: Compute the rms value of the voltage waveform shown in Fig. v(t) (V) ил. 10 2 4 6 8 t(s)

Concept explainers

Digital Integrated Circuit Design

Digital IC design is a procedural interaction that involves converting determinations and highlights into computerized blocks, which are then further transformed into basic circuits. A significant number of the imperatives related with advanced IC plan come from the foundry cycle and innovative restrictions.

Question

Consider the following waveform.
Volts
12
t (sec)
Find the RMS value of the voltage waveform. Find the average power if 8 N resistor,
connected across the voltage source v(t).
(a) 8.165 V, 133.3 W
(b) 4.260 V, 66.65 W
(c) 4.082 V, 2.083 W
(d) 8.33 V, 17.36 W
Answer
A
В
C

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

P-channel Metal-Oxide Semiconductor (PMOS), N-channel Metal-Oxide Semiconductor (NMOS), and Complementary Metal-Oxide Semiconductor (CMOS)

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

compute the RMS value for the current waveform and ys them to determine average power supplied to the resistor....
An AC generator having an internal resistance of 2 k*(omega) is connected to an LCR circuit in series as shown in the figure. If the generator supplies an electromotive force, E = 282 sen (100*pi*t) volt, calculate:a) the impedance of the circuitb) the rms value of the current in the circuitc) the voltage drop across L, C and R
The voltage between the ends of a load and the current through it are given by: v (t) = 20 + 60 cos100ti (t) = 1 - 0.5 sin100t Find:The rms values of the voltage and current and the average power dissipated in the load.
A voltage given by v(t) = 311 cos (311 pi t) V is applied to a 50-ohm resistance. (a.) Sketch v(t) to scale versus time. (b.) Determine the rms value of the voltage and the average power delivered to the resistance. (c.)Determine the power as a function of time and sketch to scale.
Find the following unknowns given the voltage: v(t) = 440 cos (2513t +195°) V. a.Averageb. Rms Values
C) Find the average power delivered to the circuit and Find the power factor of the circuit, and indicate whether it is leading or lagging then Write the sinusoidal expressions for the currents and voltage.
A 3 phase 10 pole 600 rpm delta connected alternator has 12 slots/pole with 8 conductors per slot. The windings are short chorded by 2 slots. The flux per pole contains a fundamental of 100 mwb, the third harmonic having an amplitude of 33% and fifth harmonic of 20% of the fundamental. Determine the rms value of the phase ,line voltages and Circulating Current Please answer in typing format please
Derive the formula for Average Power, Pavg = VI cosθ watts, where V is the root-mean-square (rms) voltage in volts, I is the root-mean-square (rms) current in ampere, and cosθ is the power factor. For the derivation, use the sinusoidal voltage and current equations. The angle between the voltge and current is angle θ
A load absorbs 72044 W at a lagging power factor of pf = 0.67. If the current flowing through the load is Ix = 0.100 A−rms, determine the impedance of the load.
A supply voltage v given by v = (240 sin 314t + 40 sin 942t + 30 sin 1570t) volts is applied to a circuit comprising a resistance of 12 ohmconnected in series with a coil of inductance 9.55 mH. Determine (a) an expression to represent the instantaneous value of the current, (b) the rms voltage, (c) the rms current, (d) the power dissipated, and (e) the overall power factor.
The three-phase average power rating of the central processing unit (CPU) on a mainframe digital computer is 20,000 W. The three-phase line supplying the computer has a line voltage rating of 144 V (rms). The line current is 88 A (rms). The computer absorbs magnetizing VARs. Calculate the total magnetizing reactive power (in VAR) absorbed by the CPU.
a. Find the average power b. Find the power factor. Is it lagging or leading? c. Find the sinusoidal expressions for the currents and voltage.