Answered: Find the slew rate of op-amp from the…

Find the slew rate of op-amp from the output waveform given below? Given: V1=12.8 V, V2= -9.8 V and T=1.24 us Vo V1- V2 T - The slew rate SR is V/uS

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter18: Resistive-inductive Parallel Circuits

Section: Chapter Questions

Problem 13PP: In an R-L parallel circuit, IT=1.25 amps, R=1.2k, and XL=1k. Find IR

See similar textbooks

Related questions

Q: 2K 8 K 4 K o Vç VgoM 100 nF

A: The gain is the ratio of the input response to the output response of the circuit.

Q: a.Realize a circuit to obtain Vo=5V1-2V2+3V2 using op-amp connected in an inverting mode, Where V1,…

Q: Given: R1, R2. Assume that the op-amp is ideal. R2 R1 R1 Given: v2 and vi = 0 V, determine the…

A: Given : Here we have mentioned the operational amplifier is ideal. The ideal characteristics of…

Q: H.W. 2: Design an inverting op-amp circuit for which the gain is -10 and the to resistance used is…

Q: Semi-ideal OpAmps – If we have an opamp with FINITE gain A, solve for the voltage gain Vout/Vin.…

A: Given semi-ideal op-amp circuit shown VOUT=AV+-V-

Q: For the Op.-Amp. circuit below, find the gain for each branch, VoUT equation, draw the resultant…

Q: QI what are the ideal characteristics of op-AMP. for the op-AMP circuit shown prove that the voltage…

A: Given We need to list out ideal opamp characteristics. And for the given opamp circuit we need to…

Q: Given a non-inverting amplifier with R = 100 kN and R¢ output voltage if the op-amp used has Ij0 =…

A: The input offset voltage of an ideal op-amp is zero, but in practical conditions, there is a small…

Q: D Problem 1. (P1) Three op-amps are connected in cascade configuration. An 80 microVolts signal is…

A: Given data, Three op-amp are cascaded. First op-amp is inverting and the other two are…

Q: For the Op.-Amp. circuit below, find the gain for each branch, VOUT equation, draw the resultant…

Q: Draw a shunt regulator and clearly show the four main elements. Derive an expression for the output…

A: A voltage Regulator which is used to maintain constant output voltage irrespective of changes in the…

Q: ov- -5V- V(vo1) 12V- ov -12V V(v2) V(vnoise) 5V- -5V- V(vo2) 12V

A: Due to the presence of noise as it can be seen from the simulation diagram given the output v01,…

Q: Use cirenit analysis to find the current (1,) through the load (R). Find gain (Ap). Assume an ideal…

Q: 4- Consider an OP amp connected to the inverting configuration to realize a closed-loop gain of -50…

Q: Q1 / Find the range of the output voltage for an inverting op - amp if the implication factor is…

A: Given, Implification factor A=0.85 Input voltage ranges from (1-6) V

Q: Assume the op amps as shown are ideal except for power supply voltages of ±12 V. (a) If the input…

A: The circuit which node number and op-amp number are shown below: From the circuit, the input…

Q: (a) The following circuit uses an op-amp to create an inverting comparator. Vin Op-Amp Vout +8 volts…

A: Given circuit shown

Q: 5K Vị o + o Vo IDEAL 8K is Rf 11K

Q: Write (T) for truc or (F) for False for the following: 1. An ideal op-amp has very high input…

Q: For ideal op amp operating with the following feedback network in the inverting configuration, what…

A: Given, The operational amplifier with inverting configuration is shown R1=10 kΩR2=50 kΩ

Q: 2. Design a circuit using op-amp which will perform the following, Vo=m(E1-E2), value of m=YZ, where…

Q: b) Draw an amplifier circuit using an ideal op-amp that computes the average of 3 input signals.…

A: According to the question, we need to draw the circuit by using OP-AMP, which can compute the…

Q: 2. A circuit containing a non-ideal op-amp is shown below. For your reference, the model for a…

Q: You are given an op-amp with fr = 1 M Hz and told that the open-loop gain follows the standard 20…

A: Operational Amplifier: Operational amplifiers, or Op-amps, are one of the most basic components of…

Q: V1 AV (CL) 99 O1000 il The above op-amp acts in a non ideal manner such that R2 R₁ 100 R1 0999 = 1…

Q: The op-amp is specified to have a slew rate (SR) of I V/us. Consider the circuit below and clearly…

A: The output of Non inverting amplifier is in phase with input. The Non inverting Amplifier is shown…

Q: | H Design OP-Amp oircwt that Poduce an out Rut an given by Uo = - (4U,+ Uz toil V3) If U, = 2 sinwt…

A: The output voltage is negative. Hence the given op-amp is inverting op-amp. There are three input…

Q: A noninverting ampliﬁer is designed with R1 = 1kΩ, R2 = 39 kΩ, and an op amp with an open-loop gain…

A: Given R1=1 kΩR2=39 kΩA=80 dB The feedback factor for the non-inverting amplifier is given by…

Q: An operational amplifier (op-amp) is shown in Figure Q2(a). Given R; = 15 k2, Rf = 100 k2 and supply…

A: Since you have posted a question with multiple sub-parts, we will solve first three sub-parts for…

Q: For the Op.-Amp. circuit below, find the gain for each branch, VoUT equation, draw the resultant…

Q: A generic op-amp circuit is shown in Figure 3. VWith the given data, answer the ollowing by showing…

Q: relationship berween Vout and Vin

Q: QUESTION 5: Figure 13.7 shows reference circuit and gain stage of 741 op-amp. Given that ß- 197 and…

A: Given,For the circuit,β=197IREF=0.771 mAVBE=0.6 VQ13B =34Q12

Q: A 741-type op-amp has a gain-bandwidth product of 1 MHz. A non-inverting amplifier using this op-amp…

Q: For the given op-amp circuit,

A: NOTE- “Since you have posted a question with multiple sub-parts, we will solve first three subparts…

Q: (a) For the op-amp circuit shown in Figure Q1(a): (i) Derive the mathematical expression for an…

A: Given the circuit: Given the values: V1=3 mV, V2=5.9 mV, V3=8.9 mV, R1=200 kΩ, R2=509 kΩ, R3=Rf=1…

Q: [4 points] The input on a non-inverting amplifier circuit consists of v = 2V and R, =102. If = 12V,…

A: Consider the op amp circuit with current directions By virtual short concept, V1=Vs

Q: For the Op.-Amp. circuit below, find the gain for each branch, VOUT equation, draw the resultant…

A: The circuit given is of inverting op amp . The total output will be the sum of individual outputs.…

Q: For the above circuit determine the Op-Anmp output current I, Amps (Note: This is not the current…

Q: Example 07:- For the circuit shown in the figure, calculate the output voltage when 1- R1 = R2 = R3…

Q: TRUE OR FALSE 1. Due to the infinite open-loop volatge gain of an ideal op-amp, its diferrential…

A: As per our company guidelines we are supposed to answer only first 3 subpart kindly repost the other…

Q: In the voltage regulator circuit shown in the figure, the op-amp is ideal. The BJT has VBE=0.7 V and…

A: The given problem is from voltage regulator. The calculation is shown in the next step

Q: 4- Consider an OP amp connected to the inverting configuration to realize a closed-loop gain of -50…

Q: 3D Problem 1. (P1) Three op-amps are connected in cascade configuration. An 80 microVolts signal is…

A: For the above given question by drawing the cascade configuration of the operational amplifiers we…

Q: For the multistage op amp circuit shown, find the output voltages vo1, vo2, vo3, and vo4, and the…

Q: ased on the measured values of V2, I+ & I- , can the op-amp be considered an ideal amplifier (Yes or…

A: Given : V2=-493.55 μVI+=-82.53 nAI-=-96.559 nA

Q: The inverting amplifier in the circuit shown has an input resistance of 400 k0, an output resistance…

Q: 4.6 Find an expression for the voltage gain of the inverting op-amp if Rin # 00, Rout = 0, A, # 00,…

Concept explainers

Operational Amplifier

An operational amplifier also called op amp is an integrated circuit or analog circuit that takes input as a differential voltage and produces output as a single-ended voltage. It is an IC that can amplify weak electric signals.An op amp has one output pin and two input pins. The basic role of an opamp is to amplify the voltage difference between the two input voltages. It is also used in filtering or to perform mathematical operations or in signal conditioning.

Question

Find the slew rate of op-amp from the output waveform given below?
Given : V1=12.8 V, V2= -9.8 V and T=1.24 uS
Vo
V1+
V2
T
The slew rate SR is
V/uS

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

In an Op-Amp Differential Amplifier, how should I find R1 and R4 when V1, V2, VOUT, and IR1 are given? Hint: R1 = R3, and R2 = R4
Based on the simulation’s results, explain the function of a differential amplifier. (Hints: comment on the shape of Vo1 and Vo2, explain what would happen if V1 and V2 were the same, reflect on why it is important that an ideal op-amp has infinite input impedance).
For the op-amp circuit shown below, find the value of vO, where R1 = 19 Ω, R2 = 14 Ω, R3 = 18 Ω, R4 = 14 Ω, Rf = 11 Ω, VS1 = 15 V, and VS2 = 3 V.
Derive the appropriate equation for an inverting amplifier with op-amp and provide the values of resistances to obtain the gain equal 3 (kvR -> infinity, Vr -> 0)
Graphically show the output voltage (Vo) and load current (IL) by simulating the difference receiving Op-Amp circuit given in the figure.(PSIM using PSpice or)R1 = R2=10kΩRL=1.5 kΩRf=14kΩ
The circuit in Figure below uses an ideal Op Amp. (a) Find I1, I2, I3 and Vx. (b) Assuming that Vo must not be less than –13 V, find the maximum expected value for RL. (c) If RL is varied in the range from 100 Ω to 1kΩ, what will be the corresponding range in IL and in VO?
Please show that gain = -(1-n)/(1+nA) , n = R1/(R1+R2) and compare to gain of ideal op amp. Calculate the input and output impedances, and lastly whats the point of the resistor R1//R2 on the non-inverting input? What would be the best value for this resistor? (pretending it wasn't given that the value is R1/R2).
Design and draw an inverting op amp with gain -10V/V . What is the input resistance of this op-amp?
Consider the following op amp configuration.(a) Choose R2 such that the ideal voltage gain is Av = 40dB and draw the amplifier’stransfer characteristic.(b) Find the amplifier’s input and output resistances.(c) If the op amp’s internal gain is Ao = 120dB, what is the expected voltage gain ofthe entire network?
The noninverting ampliﬁer shown is built with an op amp having an input resistance of 2MΩ and an open-loop gain of 90 dB. What is the ampliﬁer input resistance if R1 = 20 kΩ and R2 =510 kΩ?
kindly add notes: Topic: Op-amp The op-amps shown in thecircuit on the right are ideal. Assume neither of themare operating in saturation.Determine the values of v1 and v2 if v01 = 15 V andv02 = 10 V.
In a Differential Op-Amp, Vout = Rf/R1 (V2 - V1). What’s the formula to find Vout min in a Differential Op-Amp?