Find the voltages U₁ and v₂ for the circuit shown below by combining resistances in series and parallel. 25 V 6Ω Μ 12 Ω 20 Ω και www 35 Ω 10 Ω Μ + list U, 20 Ω

Q: TOKI 1.0 urms 1.01 JOOMI 100 mit 3 м Um? I VL! 13.3 F=1KHZ L₁=100mH L₂=100m R=1.0K1

A: Note Capacitive reactance is inversely proportional to frequency  Inductive reactance is directly…

Q: A generator with constant 1.0 p.u. terminal voltage supplies power through a step-up transformer of…

A: Given data- Generator constant terminal voltage = 1.0 p.u. Reactance=0.12 p.u. Finite bus…

Q: eter? why? 7. What current is required for full scale deflection of a galvanometer having a current…

A:

Q: Calculate the active power of a three phase 130V source operating at a leading power factor of 0.81…

A: Given: A three phase source has, Operating voltage, VL=130 V. Power factor, cosθ=0.81 leading.…

Q: Types of DC Generators 1. The armature of a separately-excited DC generator has 0.06 effective…

A:

Q: 2. Calculate the total resistance between the points A and B. A www 4 ohm www 3 ohm 1 ohm 2 ohm

A: Given data, Circuit diagram is given as,

Q: Exercise 2: In the circuit below, determine vx and ix 60 V 5 A 8 Ω M 4Ω 10 Ω www 202 Vx

A:

Q: (a) Describe the type of meter movement used in analog meters. (b) What device is used to extend the…

A: Meter The length of the path that light took in a vacuum over a time period of 1/299,792,458 seconds…

Q: 3. Solve the equivalent resistance across: a. “a” and “b” b. “c” and “d” a 32 6Ω Μ 38 b+ 3Ω Μ 4Ω C…

A:

Q: In a two-terminal network, the open-circuit voltage measured at the given terminals by an electronic…

A:

Q: For the circuit shown in Figure 2.54, use nodal analy- sis to find the current delivered by the 24 V…

A:

Q: A coil has an ac voltage of 120 V. The current through the coil is 10 -85⁰ A What is the inductive…

A:

Q: Three Phase Half-Wave Fully Controlled Rectifier when pure Resistive and highly Inductive loads are…

A: Let the circuit diagram of 3-phase Half wave full controlled rectifier with pure resistive and…

Q: For the circuit shown, the energy stored by the 2.0 µF capacitor is 0.40 mJ. Find the voltage (in V)…

A:

Q: analog television signal containing  frequencies up to 4.5MHz is to be coded by an  ADC. The…

A: We need to find out data rate for given signal .

Q: R Exercise 1: In the circuit below, determine v and v d 4 V с 36 V R₂ D + 12 V- VR2 I ♡ + 14 V- Ux b…

A: In this question,  We need to determine the voltage VR2  and Vx  .  We are solving this problem…

Q: At stand still condition the slip of the induction machine is 1 0 Infinite value none

A: Given, The induction machine is at standstill.

Q: Explain the operation of clamping circuit.  In clamping circuits, what is the effect of adding a…

A: Clamper circuit is used provide DC shift in the input AC voltage. DC shift can be negative of…

Q: An analog signal is sampled at the Nyquist rate of  8MHz and quantized into 180 levels. Find the…

A: Given that: Nyquist rate, fS=8 MHz Quantized level, L=180 Find time duration T ( in second) of 1…

Q: 2. If 750 μA is flowing through 11 kn of resistance, what is the voltage drop across the resistor?…

A: Given data: The current I=750 μA=750×10-6 A The resistance R=11kΩ=11000 Ω

Q: N₁ = h(t) = [1-e-Ju(t) No = ? to find (t). 18 N Use the convolution theoren to find

A:

Q: It converts the electrical energy collected from the catenary via pantograph into mechanical energy.…

A: The electricity is supplied to the train by the connection between the sliding contacts of the…

Q: Determine the ideal voltage source needed by three resistors connected in series R₁ = 6 ohms, R₂…

A:

Q: 1.  With the looming energy crisis in our country, as a future electrical engineer what solution (in…

A:

Q: T= RS + RS + S

A: This is a basic problem of logic gate function. The detailed solution is given in the next step.

Q: Q4: A: A string of 3 insulators and the ratio of Ce/C = 0.15, if the string is connected to 3-4 line…

A:

Q: The supply frequency to the stator of an 8-pole induction motor is 70 Hz, and the rotor frequency is…

A: We need to find out the rotor speed , slip for given  induction motor .

Q: he current drawn by the a 230 V DC motor of armature resistance 0.5 Ω and back emf 200 V is ?

A: Given: Terminal voltage, V = 230 V. Armature resistance, Ra=0.5 Ω. Back emf, Eb=200 V.

Q: Question 15 6 Rb ww Vcc Question 16 6b Rc Consider the BJT circuit shown above with the values R =…

A: We need to find out the emitter voltage and collector voltage for given circuit , first we will find…

Q: A.) A coal-powered station has a maximum demand of 30 MW, a load factor of 60%, plant capacity…

A: Given data, Load factor LF = 0.6 Maximum demand = 30 MW

Q: 4. Use the labeled in the figure. current-division principle to find the currents i, = 3A (1 R₁ = 10…

A:

Q: Hello Sir. Good Evening. I have a question in my home work related Electricity Lesson. The…

A: Given, current flowing from wire, I=15 Ampheres Voltage applied,V=220 Volts diameter of wire, d=5mm,…

Q: For the circuit below if EI=5V, D1=0, D5=0 the state of L1 to L5 will be: D E D7 D2, D3 10 5 OO OO M…

A: Given data: The IC seen here, the 74LS148, is an encoder with an 8-line input and 3 outputs. The…

Q: Please solve for 0xBC + 0x08 and specify the flag bit results in the STATUS register (C, DC & Z…

A:

Q: B-5-8. Referring to the system shown in Figure 5-75, de- termine the values of K and k such that the…

A:

Q: Calculate the active power of a three phase 130V source operating at a leading power factor of 0.81…

A: Given: A three phase source has, Operating voltage, VL=130 V. Power factor, cosθ=0.81 leading.…

Q: For the circuit shown in Figure 2.54, use nodal analy- sis to find the current delivered by the 24 V…

A: As per the question, we have to find the current delivered by 24 V source.

Q: 38mA Іг 2КЛ 4кл V, 5 КЛ 4 кл

A:

Q: What is the resistance (in ohms) of the network below as seen between terminals a and b? 9Ω a- b-…

A: The network is shown below:  In the above circuit, the resistance of 9 Ohms and 6 ohms are…

Q: What is the resistor value in ohms? Blank 1 Do not include the unit. Do not include commas.

A:

Q: If the maximum analog frequency is 50Hz, the minimum sampling frequency to avoid aliasing is 75Hz…

A:

Q: For AM with tone modulation, let us find n = of modulation index µ. H. for tone modulation total…

A:

Q: Find the voltage across the 2 V resistor in below figure by using the superposition theorem. 10 V 10…

A:

Q: Given that the magnetic flux in 0.2 m² area is 800 μWb, what is the flux density? A 160 μ. B 4000 T…

A: Given, Magnetic flux, φ=800 μWb. Area, A=0.2 m2. Magnetic flux density, B =?

Q: Using Nodal analysis and following the given figure, write the equation at node B under this…

A: Given a circuit  Asked to write nodal equation at node B at the given condition.

Q: . In the transformer shown in the below figure, the inductance measured across the terminal 1 and 2…

A: Given data- A transformer as shown in the figure. It is needed to find the Coefficient of coupling…

Q: For the arrangement shown in Figure below, find the current Ix

A: Given circuit:

Q: Question 11 Not yet answered Marked ou estion step-up transformer, with turns ratio a 1/2, if we…

A: Given a step-up transformer with, Turns ratio, a=12. Primary side voltage, V1=220 V. Secondary side…

Q: Solve the problems below. Show your solution. 1. A 5-kW AC motor has a power factor of 65% lagging…

A:

Q: * The voltage Vout in the circuit shown is

A: Given data, Circuit diagram is given as,