Answered: Five forces are acting on the…

Five forces are acting on the cantilever beam AB. Find the resultant or a couple acting on the cantilever beam. 1400 N 1000N 800 N 500. N 900 N A 8, 1.2 m 0.6m 0.9m 1.5m 0.6m

Glencoe Physics: Principles and Problems, Student Edition

1st Edition

ISBN:9780078807213

Author:Paul W. Zitzewitz

Publisher:Paul W. Zitzewitz

Chapter5: Displacement And Force In Two Dimensions

Section: Chapter Questions

Problem 82A

See similar textbooks

Related questions

Q: 100 N 120 N 260 N 0.4 m B. 0.5 m A 0.3 m 0.2 m 0.2 m

A: Force is a vector quantity and it is added algebraically if all the forces are in parallel with each…

Q: The drawing shows a person (weight, W= 584 N) doing push-ups. Find the normal force exerted by the…

Q: A block is resting on an incline of slope 5:12. It is subjected to a force F =1 KN on a slope of…

Q: 30 N 20 N 40 N 45° 250 60° 30 P 60 N The forces are in equilibrium. Find the value of force Q in…

Q: 17. Four forces act on a point as shown. N 5N 5N W 5N E 5N The resultant of the four forces is (1)…

A: Net force on the point is,

Q: Five forces are acting on the cantilever beam AB. Find the resultant or a couple acting on the…

A: Given,five forces acting on cantilever beam and creating couple five forces are 1000, 1400, 800, 500…

Q: 12. Adding the vectors using force table, at what angle should the fourth mass be suspended to…

Q: 2 Two masses are attached to a uniform meter stick as shown in the figure below. The masses of m1…

Q: The figure below shows a bird feeder that weighs 152.3 N. The feeder is supported by a vertical…

A: This is clear from the given conditions that the bird feeder is static so let us assume T1 Bottom…

Q: Calculate the resultant of the three forces acting on a point as shown in the figure. Y F1(100N) x…

A: F1 = 100 Nθ1 = 25°F2 = 500 Nθ2 = 0°F3 = 200 Nθ3 = 50° Fx = F cos θFy = F sin θ

Q: Two people are carrying a 16.3-kg uniform wooden board that is 3,00 m long. One perSon applies an…

Q: Determine F, and F2 by setting up equations based on the following: Figure 5.3-F, and…

Q: 0.4 m 1.5 m 0.4 m 0.8 m 1.5 m 1.5 m Three vertical wires are used support a rectangular plate which…

Q: A wniform ladder 15 ft long is leaning against a frnctionless wall at an angle of 53° above the…

A: At equilibrium, the net moment of force is zero. Therefore,

Q: The resultant of the 50-N and 30-N forces is R. If R = 65 N, determine the angle ß. D 85° D 106° D…

Q: To lift a heavy crate, a man uses a block and tackle attached to the bottom of an I beam at hook B.…

Q: A diver of mass 73.1 kg stands on one end of a diving board of mass 30.9 kg, as shown in the…

A: Given: The mass of the diver is 73.1 kg. The mass of the board is 30.9 kg.

Q: 3. Two masses are attached to a uniform meter stick as shown in the figure below. The masses of m1…

Q: 1. Draw the free-body diagram of the beam which supports the 80-kg load and is supported by the pin…

A: Free body diagram is given,∑mA=0-T2-T4+809.81=0T=178.4 N

Q: Five forces are acting on the cantilever beam AB. Find the resultant or a couple acting on the…

A: As per our guidelines, we are supposed to answer only first one question in case of multiple…

Q: The two conditions for equilibrium often result in a system of equations such as F1 + F2 = 42.0 N…

A: F1 + F2 = 42.0 N and 5.00F1 − 9.00F2 = 0

Q: Find the magnitude of the sum of two forces, one 20.0 N and the other 7.0 N, when the angle between…

A: Given Magnitude =a2+b2+2ab cos θ a=20 N b=7 N θ=30°

Q: Which one of the following statements is true regarding the normal force? At any instance there can…

A: Correct option is Normal force always points perpendicular to the surface the object is in contact.…

Q: If the two cords are connected to the vertical cord supporting the 200-kg chandelier. Calculate F_A…

A: Given,Mass of the chandelier, m= 200 kg

Q: 1.25 Resolve the 200-lb force into components along (a) the x- and y-axes and (b) the x'- and…

A: Part (a) We have to resolve a force (F) of 200 lbs along x and y-axes. Since both x and y-axes are…

Q: For the uniform hanging bridge carrying a mass of 2.50 x 10 raised to 3 power kg as shown, determine…

Q: At what angle must the 800-N force be applied in order that the resultant Rof the two forces has a…

Q: Four forces act at point A and point A is in equilibrium. Select the correct force vector P. F3 = 10…

Q: ver of mass 74.6 kg stands on one end of a diving board of mass 27.6 kg, as shown in the diagram.…

A: Given Mass of diver, mD=74.6 kg Mass of board, mB=27.6kg

Q: 2.5m 450 6m 1. A 500N person stands 2.5m from a wall against which a horizontal beam is attached.…

Q: 1. Six identical blocks weighing 100-N are placed on a leveled table as shown in the drawing below.…

Q: 19. Statics is the study of: A. Forces and moments B. Acceleration C. Inertia D. Weight and torque…

A: The answers are below

Q: The forces acting on the box as shown below are in a state of balance (g = 10 m/s) %3D The tension…

Q: Given: The four forces and F = 200 N geometry shown. 6 m F2 = 600 N Find: The force F5 required to…

A: Given are the magnitudes of the following forces : F1= 300 N ; F2= 600 N ; F3 = 900 N ; F4 =…

Q: 65.0 N 30 30.0 N- 20 20.0 N What is the magnitude of the resultant of these three forces? a. 27.0 N…

A: By the given data the of the vectors the resultant of the three vectors we resolve them into X and Y…

Q: the man pulls upward with a force F whose direction makes an angle of 30.0° with the ramp (Fig.…

A: The free body diagram is given as follows: Here Fy=Fsin30∘ and Fx=Fcos30∘

Q: The forces F1 = 500 N, F2 = 40O N, and F3 = 700 N all of which act on point A of the bracket, are…

A: At the point A forces F1 =500 N F2 = 400 N F3 = 700 N consider F1x = 500 cos 35 =…

Q: A 1350N window washers platform, 3.5 m long is suspended by two vertical wires at its ends. A 600N…

Q: If the two cords are connected to the vertical cord supporting the 200-kg chandelier. Calculate F_A…

A: Given data: Weight of chandelier (W) = 1960 N Angle with horizontal (θ) = 60° Required: Tension…

Q: Upward force question Jim and Mary are carrying Bob on a horizontal stretcher. The uniform stretcher…

Q: Determine the resultant of the four forces and one couple that act on the plate shown. 2 m Y 70 N 5m…

A: Solution: (2) Determine the sum of the forces in x-direction.…

Q: Two rods and one cable are attached to the supports at O. If two of the forces are as shown,…

Q: ÖDEV-1/A 240 kN .15. F1 F2 400 85 .kN F3 880 O3 = ( 25 .kN F4= O4 = ( 25 760 kN The resultant force…

A: F1= 240 kN F2= 400kN F3= 880kN F4= 760kN 15°, 85°, 25°, 25°

Q: Calixta whose mass is 60 kg stands 1.5 m away from one end of a uniform 6.0-m-long plank of mass…

Q: The figure below shows a bird feeder that weighs 199.9 N. The feeder is supported by a vertical…

Q: 40 kg If a force P=19ON was applied to lower the cylinder, what is the coefficient of static…

A: Given : Force P = 190N The coefficient of static friction is 0.23

Q: The homogeneous 18-kg pulley is attached to the bar ABC with a pin at B. The mass of the bar is…

A: Angle at C,

Q: 0.20 L 0.40 L 3. The foot of a ladder rests against a wall and its top is he rope, as shown in the…

Q: 66. A cable can support only a compressive or “pulling” force. True False 67. In…

Q: The system as shown is in equilibrium. Determine the force exerted by cable AB. 45° 30° | 100 lb. c.…

Concept explainers

Nuclear Reactions

Nuclear reactions are processes in which the fundamental characteristics of a nucleus changes. They change into a completely different nucleus. These processes occur naturally in an unstable nucleus. Bombarding an energetic particle can induce nuclear reactions. In this article, both the naturally occurring nuclear reactions are termed as radioactive decay and the induced nuclear reactions are further categorized as nuclear fission and nuclear fusion.

Question

complete solution pls with fbd

Five forces are acting on the cantilever beam AB.
Find the resultant or a couple acting on the
cantilever beam.
I TTI It
1400 N
1000N
800 N
900 N
500 N
A
8.
1.2 m
0.6m 0.9m
1.5 m
0.6m

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.

Similar questions

The leg and cast in Figure P4.40 weigh 220 N (w1). Determine the weight w2 and the angle needed so that no force is exerted on the hip joint by the leg plus the cast. Figure P4.40
Two forces of F ⃗ 1 = 75.0 /√2(i ^− j ^) N and F ⃗ 2 = 150.0 /√2(i ^ − j ^) N act on an object. Find the third force F ⃗ 3 that is needed to balance the first two forces.
A uniform plank of length 2.00 m and mass 28.0 kg is supported by three ropes, as indicated by the vectors in the figure below. Find the tension in each rope when a 710-N person is d= 0.500 m from the left end. Solve for magnitude of T1, T2, and T3.
An object is subjected to three forces as shown in the figure. Assume F1 = 50.0 N and F2 = 95.0 N, what is T if the object is in static equilibrium? Enter a number with three significant digits.
If there is a net force of 250N [W30S] what force would you need to apply in order for the system to be in equilibrium? (a) 250 [E30N] (b) 250 [W30N] (c) 250 [E30S] (d) 250 [S30W]
A 160-N child sits on a light swing and is pulled back and held with a horizontal force of 120 N.The magnitude of the tension force of each of the two supporting ropes in newtons is: Answer must be according the correct signifcant numbers.
A hungry bear weighing 700. N walks out on a beam in an attempt to retrieve a basket of goodies hanging at the end of the beam. The beam is uniform, weighs 200. N, and is 6.00 m long, and it is supported by a wire at an angle of 60°. The basket weighs 80.0 N. a. Draw a force diagram for the beam. b. When the bear is at 1.00 m, find the tension in the wire supporting the beam and the components of the force exerted by the wall on the left end of the beam. c. If the wire can withstand a maximum tension of 900. N, what is the maximum distance the bear can walk before the wire breaks?
1) necessary condition for Rigid Body Static Equilibrium or Particle Static Equilibrium requires that the Rigid Body or the Particle experiences_________. A. only small forces B. only large forces C. no balanced forces D. no unbalanced forces 2. Given three force vectors P, Q and R where:P = 300 N ?Q = 400 N ?R = 500 N ?What is the Magnitude of the Resultant of these three vectors? A. 768 N B. 430 N C. 707 N D. 1200 N
The leg and cast in Figure P4.20 weigh 220 N (w1). Determine the weight w2 and the angle α needed so that no force is exerted on the hip joint by the leg plus the cast.
A 145 N sign is supported by two ropes. One rope pulls up and to the right ?1=29.5∘ above the horizontal with a tension T1 , and the other rope pulls up and to the left ?2=47.5∘ above the horizontal with a tension T2 , as shown in the figure. Find the tensions T1 and T2 respectively
The box B weighs 50 lb. The coefficients of friction between the cable and the fixed round supports are μs= 0.40 and μk= 0.30. What is the minimum force F required to support the box? What force F is required to move the box upward at a constant rate?
You wish to help the child carry the backpack. Find the magnitude of force you should apply to the backpack with weight 34 lb and the angle to minimize the amount of force the child needs to provide if a is fixed at 20.1°. B = Child B W y α O You X