Follow the procedures in troubleshooting the defects and faults of an electric fan by filling in the missing steps. Doesn't rotate 1.___________ 2.____________ Check for Open AC cord or wiring 3. ___________4.___________ Defective switch/electronic system control 5. _____________Defective module (system control).

Follow the procedures in troubleshooting the defects and faults of an electric fan by filling in the missing steps. Doesn't rotate 1._____ 2. Check for Open AC cord or wiring 3. _4._ Defective switch/electronic system control 5. _______Defective module (system control).

EBK ELECTRICAL WIRING RESIDENTIAL

19th Edition

ISBN:9781337516549

Author:Simmons

Publisher:Simmons

Chapter30: Swimming Pools, Spas, Hot Tubs, And Hydromassage Baths

Section: Chapter Questions

Problem 14R

See similar textbooks

Similar questions

Airframe Electrical System Question: What is the maximum acceptable voltage drop from the voltage source to the utilization equipment's ground in a 28 volt system? (Source: FAA AC 43.13-1B/2B)
Assume a bank of heating strips is rated at 22 KW and is connected to 240 volts. The heat strips operate for 4 hours at a time and are located in an area with an ambient temperature of 86 degrees F. The termination temperature rating of the heat disconnect lugs are unknown. Copper conductors with type THWN-2 insulation are to be used because of the environment of the installation to connect the heaters. What size conductors should be used?
Which of the following must be notified prior to equipment shutdown for repair? a. Director of facilities b. Electrical department c. Affected employees d. Environmental, Health and Safety Office
Refer to the specifications in the back of this text following Chapter 33. a. What electrical codes must be conformed to? ________________________________________________________________________ ________________________________________________________________________ ________________________________________________________________________ b. What is the wiring method to be used in the workshop? ________________________________________________________________________ c. What size conductors are to be used for the lighting branch circuits? ______________________ AWG the small-appliance branch circuits? ______________________ AWG d. What section of the specifications tells us the size of the service entrance to be installed for this residence?
Which of the following installations for a kitchen waste disposal that operates on a 15-ampere, 120-volt branch circuit requires AFCI protection? (Circle the correct answer.) a. The disposal operates by a switch that is installed above the kitchen counter. b. The disposal operates by a switch that is installed under the counter next to the disposal. c. Both (a) and (b) d. Neither (a) nor (b).
Show the connections for a ceiling outlet that is to be controlled from any one of three switch locations. The 120-volt feed is at the light. Use colored pens or pencils. Assume the installation is in cable.
What is the 277-volt–single-phase–60-hertz system used for? Select one: A. RECEPTACLE BRANCH CIRCUITS B. LIGHTING BRANCH CIRCUITS C. MOTOR BRANCH CIRCUITS D. RESIDENTIAL BRANCH CIRCUITS
What section of the NEC covers grounding?
The recessed fluorescent luminaires installed in the ceiling of the recreation room of this residence are connected with trade size flexible metal conduit. These flexible connections are commonly referred to as fixture whips. Does the flexible metal conduit provide adequate grounding for the luminaires, or must a separate equipment grounding conductor be installed? ________________
9. How is equipment containing ungrounded electrical systems required to be marked? A. With green wiresB. With a sign reading "Caution: Ungrounded System Operating at _______ Volts Between Conductors" C. With a red X D. With a sign reading "Danger: Do Not Touch Ungrounded System, Operating at _______ Volts"
In order to wire a post light, a homeowner purchased some single-conductor cable that was marked as suitable for direct burial in the ground. A separate equipment grounding conductor to the post light was not carried. Instead, the bottom of the metal post, buried 2 ft (0.6 m) into the ground, was used as a ground for the post light. The inspector red tagged (turned down) the installation. Who is rightthe homeowner or the electrical inspector? Explain. ___________________ ___________________ ___________________
The NEC is very strict about securing anything to electrical raceways. Name the Code sections that prohibit this practice. NEC _____________