For a damped simple harmonic oscillator, the block has a mass of 2.0 kg and the spring constant is 13 N/m. The damping force is given by -b(dx/dt), where b = 170 g/s. The block is pulled down 16.2 cm and released. (a) Calculate the time required for the amplitude of the resulting oscillations to fall to 1/7 of its initial value. (b) How many oscillations are made by the block in this time? | Rigid support Springiness, k Mass m -Vane Damping, b (a) Number i Units (b) Number i Units

For a damped simple harmonic oscillator, the block has a mass of 2.0 kg and the spring constant is 13 N/m. The damping force is given by -b(dx/dt), where b = 170 g/s. The block is pulled down 16.2 cm and released. (a) Calculate the time required for the amplitude of the resulting oscillations to fall to 1/7 of its initial value. (b) How many oscillations are made by the block in this time? | Rigid support Springiness, k Mass m -Vane Damping, b (a) Number i Units (b) Number i Units

Classical Dynamics of Particles and Systems

5th Edition

ISBN:9780534408961

Author:Stephen T. Thornton, Jerry B. Marion

Publisher:Stephen T. Thornton, Jerry B. Marion

Chapter3: Oscillations

Section: Chapter Questions

Problem 3.1P

See similar textbooks

Similar questions

Give an example of a simple harmonic oscillator, specifically noting how its frequency is independent of amplitude.
Show that, if a driven oscillator is only lightly damped and driven near resonance, the Q of the system is approximately Q2(TotalenergyEnergylossduringoneperiod)
If the amplitude of a damped oscillator decreases to 1/e of its initial value after n periods, show that the frequency of the oscillator must be approximately [1 − (8π2n2)−1] times the frequency of the corresponding undamped oscillator.
Most harmonic oscillators are damped and, if undriven, eventually come to a stop. Why?
The amplitude of a lightly damped oscillator decreases by 3.0% during each cycle. What percentage of the mechanical energy of the oscillator is lost in each cycle?
The mechanical energy of an undamped block-spring system is constant as kinetic energy transforms to elastic potential energy and vice versa. For comparison, explain what happens to the energy of a damped oscillator in terms of the mechanical, potential, and kinetic energies.
For a damped, driven oscillator, show that the average kinetic energy is the same at a frequency of a given number of octaves* above the kinetic energy resonance as at a frequency of the same number of octaves below resonance.
Refer to the problem of the two coupled oscillators discussed in Section 12.2. Show that the total energy of the system is constant. (Calculate the kinetic energy of each of the particles and the potential energy stored in each of the three springs, and sum the results.) Notice that the kinetic and potential energy terms that have 12 as a coefficient depend on C1 and 2 but not on C2 or 2. Why is such a result to be expected?
Consider a damped harmonic oscillator. After four cycles the amplitude of the oscillator has dropped to 1/e of its initial value. Find the ratio of the frequency of the damped oscillator to its natural frequency.
If a car has a suspension system with a force constant of 5.00104 N/m , how much energy must the car’s shocks remove to dampen an oscillation starting with a maximum displacement of 0.0750 m?
A simple harmonic oscillator has amplitude A and period T. Find the minimum time required for its position to change from x = A to x = A/2 in terms of the period T.
An automobile with a mass of 1000 kg, including passengers, settles 1.0 cm closer to the road for every additional 100 kg of passengers. It is driven with a constant horizontal component of speed 20 km/h over a washboard road with sinusoidal bumps. The amplitude and wavelength of the sine curve are 5.0 cm and 20 cm, respectively. The distance between the front and back wheels is 2.4 m. Find the amplitude of oscillation of the automobile, assuming it moves vertically as an undamped driven harmonic oscillator. Neglect the mass of the wheels and springs and assume that the wheels are always in contact with the road.