For a given reaction C2H6 + Cl2 → C2H5Cl + HCl Assume that the percentage conversion of the limiting reactant is 60% and the feed composition in mole percent is 50% C2H6, 40% Cl2 and 10% N2. (a) What is the mole percent of HCl in the product? (b) What is the mole percent of N2 in the product?

Q: An unknown pentahydrate salt is known to release water when heated according to the following…

A: Given: Mass crucible = 24.3365 g Mass crucible + hydrate = 29.6115 g Mass crucible + residue after…

Q: Benzoic has been proposed as a primary pollutant from vehicular exhaust and a secondary product from…

A: The given chemical reaction is: C6H5COOH + aO2 + bNH3   -----> cC5H7NO2 + dH2O + eCO2  We have to…

Q: 4. Methylamine, stored in a 2000-gallon tank is to be transferred in drums. Each drum is to be…

A:

Q: ethylene oxide is produced by oxidation of ethylene 100 kmol of ethylene and 100 kmol of o2 are…

A: Given,% conversion of ethylene=85%% yield of ethylene oxide=94.12%Moles of O2=100kmolMoles of…

Q: Lactic acid is an important pharmaceutical product that is manufactured by fermentation of glucose.…

A: Given : Initial flow rate of mixture = 6456 Kg/hr. Initial concentration of lactic acid in mixture =…

Q: #3 acid via the oxidation of ammonia is: The first step in the reaction sequence for the production…

A: Balanced chemical equation, 4 NH3 +5 O2 ⇔4 NO + 6H2O

Q: An experiment on the growth rate of certain organisms requires an environment of humid air enriched…

A: Specific growth rate represents dynamic behaviour of microorganisms. Specific growth rate is used as…

Q: A gasification plant of MSW produces syngas of the following Component Composition (dry volume %)…

A:

Q: .40. Ammonia is burned to form nitric oxide in the following reaction: 4NH3 + 502 - 4NO + 6H2O (a)…

A:

Q: Consider the following heterogeneous reaction where a solid product B is formed: ` `A (g) ↔ B (s) +…

A: Given: A (g) ↔ B (s) + 2 D (g)

Q: For the reaction: A-> products: What are the units for k if m=2? *The answer must be in the form…

A: 1M.time  or  dm3mol.time  or Lmol.time

Q: C22H4(g) + H2(g) --> C2H6(g) C22H4 flows into a catalytic reactor at 25.0 atm and 300°C with a flow…

A: Ethene is converted into ethane by the following reaction  C22H4(g) + H2(g) --> C2H6(g)

Q: A liquid mixture containing 40.0% benzene (B) and 60% toluene (T) by mass to the distillation…

A: Given Liquid feed contains 60% of toluence and 40% benzene by mass. Feed volumetric flow = 2500L /…

Q: Use the References to access important values if needed for this question. In a study of the…

A:

Q: The amount of oil and grease from the rivers beside mining sites are quantified by solvent-solvent…

A: The amount of oil and grease from rivers beside mining side quantified by liquid liquid extraction.…

Q: a feed containing equimolar amounts of methanol and water is mixed with 10 moles of a 40% mol…

A: The flow sheet for given question is shown below, The overall material in mixer unit is calculated…

Q: A mixture containing 42 wt% benzene (B) and 58 wt% toluene (T) is fed to a distillation column at a…

A: Solution

Q: A 500 m2 botanical garden which harvest 1000 flowers per day of 15 variations, in a year the average…

A: You have posted multipart of question as per the guidelines i have solved first three subparts…

Q: The oxidation of ethylene to produce ethylene oxide proceeds according to the equation2C 2H 4 +O 2 !…

A: Given that the feed reactor contains 100 kmol C2H4 and 100 kmol O2. To find the limiting reactant.

Q: dentify the effect of the condition on the parameter. Write increase, decrease, or no effect. And…

A: Answer - A) No effect  According to the question - The actual concentration of the sodium hydroxide…

Q: A circular lake of diameter 2.5m is receiving wastewater with a flow rate of 25 L/sec from a village…

A:

Q: What is the mole fraction of magnesium nitrate, Mg(NO3)2, in an aqueous solution that is 5.549 wt %…

A:

Q: Ethane is chlorinated in a continuous reactor: C2H6 + Cl2 à C2H5Cl + HCl Some of the product…

A: In a continuous reactor, ethane is chlorinated as: Further the product mono-chlorinated is…

Q: specifications and material balance calculations lead to the following flowchart. (1/5) 36.45 mol/s…

A:

Q: Methane is burned with air in a continuous combustion reactor that is at steady state. The feed to…

A: Given information,       The feed to the reactor contains 7.80 mole % CH4, 19.4 mole % O2, and 72.8…

Q: 2.5. The off-gases from a gasoline stabilizer are fed to a steam reforming plant to produce…

A: In order to solve this question, we will calculate moles of H2 formed from both reactions and then…

Q: For the dissolution of LiCl in water, ΔHsoln = -37 kJ/mol.Which term would you expect to be the…

A: The enthalpy change of solution is -37 kJ./mol which is the negative value that means its a…

Q: Cyclohexane (C6H12) can be made by the reaction of benzene (Bz) (C6H6) with hydrogen according to…

A:

Q: The volume of HCI is 100 mL , mass of solid added is 1.008g, moles of solid 0.0276 Mol, mass of HCI…

A: Given: Volume of HCl = 100 mL Mass of solid Added = 1.008 g moles of solid  = 0.0276 Mol mass of HCI…

Q: Solid calcium (CaF2) reacts with sulfuric acid to form solid calcium sulfate and gaseous hydrogen…

A: The molecular weight of water is 18g/mol (H=1g/mol ; O=16g/mol ) The molecular weight of…

Q: A schematic flow sheet of a process is shown in figure below. The following table gives the…

A:

Q: What is meant by Centrifugation and How to calculate a desire RCF and rpm for the separation of…

A: Following are the appropriate answers of the given questions.

Q: 2. In an ethanol production plant, a separator produces a 99% ethanol product from a feedstock…

A: Given:-   The mass flow rate of feedstock stream mF = 450 lb/min   Mass fraction of ethanol in feed…

Q: A gaseous fuel containing methane and ethane is burned with excess air. The fuel enters the furnace…

A:

Q: Solid calcium (CaF2) reacts with sulfuric acid to form solid calcium sulfate and gaseous hydrogen…

A: Given the mass of the required 60 wt% HF = 1 metric ton or 1000 Kg  Mass of HF in the required 60…

Q: Carbonic anhydrase of erythrocytes (Mr 30,000) has one of the highest turnover numbers known. It…

A:

Q: Propane (g) and oxygen (g) are introduced into a container at 300°C to produce carbon dioxide (g)…

A: Due to technical error ,unable to provide you the solution. Please resubmit the question once again

Q: The student then determined ΔH neutralization for the reaction of sodium hydroxide and acetic acid,…

A: First calculate moles of each reactant by multiply MOLARITY and volume  then find out limiting…

Q: Stoichiometry is a significant part of chemical engineering. In industrial practice, stoichiometry…

A: 1) Industrial process: It is the complete process in which raw materials is converted into valuable…

Q: For the reaction bellow: CnH(2n+2) + a(0₂ +3.76 N₂) → nCO₂ + (n + 1)H₂0 +3.76a N₂ If the heat of…

A:

Q: An underfeed stoker feeds coal to a boiler at the rate of 100 kg/hr. The ultimate analysis of coal…

A:

Q: Carbonic anhydrase of erythrocytes (M, 30,000) has one of the highest turnover numbers known. It…

A: Solution is given below in next step

Q: Methanol (CH3OH) is produced in the reaction of carbon dioxide and hydrogen via the reaction and…

A: Detailed answer in step 2 and 3.

Q: Chemical process industries use complex equipments. Some of these are fractional distillation…

A:

Q: 4. A feed stream containing C8 and C10 hydrocarbons is split into 3 product streams: an overhead…

A: The flow diagram given is,

Q: The following gas-phase reaction takes place in a closed, constant-volume batch reactor at…

A: We have given a reactor contains nCO = 0.564 kmol =  564 mole nO2 = 1 kmol =  1000 mole nCO2 = 1…

Q: A/ Ethane (C2H6) is burned with atmospheric air that contains 22.87 kmole of 02 and N2, and the…

A: Given data,  Moles of air = 22.87 (O2+ 3.76 N2)  Percentage of dry products of combustion are 10%…

Q: A furnace is charged with 100 kmols of fuel gas, the composition of which is: 50% CO, 30% H2, 5%…

A: Total number of moles of fuel gas = 100 kmols % CO = 50 %, % H2 = 30 %, % CH4 = 5 %, % C2H2 = 5 %,%…

Q: Question Completion Status The following process describes the complete combustion reaction of…

A: