For complete combustion of octane (C3H18) with 100% dry air. (a) write the balance mol equation (b) calculate the specific heat, enthalpy and internal energy of dry flue gas at 373 K. From Table A-1 specific heats in kJ/kg K: for CO, Cp = 0.8452 ; for N2, Cp = 1.0414

For complete combustion of octane (C3H18) with 100% dry air. (a) write the balance mol equation (b) calculate the specific heat, enthalpy and internal energy of dry flue gas at 373 K. From Table A-1 specific heats in kJ/kg K: for CO, Cp = 0.8452 ; for N2, Cp = 1.0414

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

A fuel mixture of 60 percent by mass methane (CH4) and 40 percent by mass ethanol (C2H6O), is burned completely with theoretical air. If the total flow rate of the fuel is 10 kg/s, determine the required flow rate of air.
Calculate the enthalpy of combustion of propane C3H8 at 25 oC in both kJ/kg and kJ/mole under the following conditions:- 1- gaseous propane with H2O liquid in the products. 2- gaseous propane with H2O vapor in the products 3- liquid propane with H2O liquid in the products 4- liquid propane with H2O vapor in the products note: the enthalpy of evaporation of propane at 25 oC is 425 kJ/kg
Liquid octane is burned steadily with air in a jet engine. If the air–fuel ratio is 18 kg air/kg fuel, determine the percentage of excess air used during this process.
The reactant side has the following volumetric analysis for fuels burned simultaneously: CH₄= 68% and C₂H6= 32%. Assume a complete combustion with 15% excess air at 101.325 kPa, what is the partial pressure of water vapor in kPa.
Forty kilograms of methane gas per minute is burned with dry air in heating furnace. The volumetric analysis of the products on a dry basis is 5.20% carbon dioxide, 0.33% carbon monoxide, 11.24% oxygen, and 83.23% nitrogen. Calculate the minimum duct diameter, in mm, used to supply the combustion air at 1 bar and 27 deg C and at a flow velocity of 15 m/s.
If one mole of air/fuel mixture (rigid diatomic gas) is initially at 20◦C, is compressed and expanded 7-fold as part of the Otto cycle, and 4 kJ of heat is generated by burning the air/fuel mixture, calculate: (i) the temperature after each stage of the Otto cycle; (ii) the heat absorbed/expelled during each stage of the cycle; and (iii) the efficiency of the Otto cycle.
The exhaust gas analysis of an engine using octane as fuel gives equal volumes of CO, and unused O, Computer actual and stoichiometric air-fuel ratio. For equivalence ratio of 1. Calculate The volume of mixture per kg of fuel at pressure of 100 kPa and temp 70°C., (i) The volume of combustion products per kg of fuel when femp. of products is127°C at 1 bar.
A gaseous fuel has the following percentage of composition by volume:N2: 10% ; H2: 50%CH4: 25% ; O2: 3.5%CO: 9% ; CO2: 2.5%(a) Estimate the minimum volume of air required for complete combustion of 1.0 m3of the gas.(b) If 60% excess air is supplied, give the volumes of each of the dry constituents ofthe flue gas. Air contains 21 % by volume of oxygen. Solve this problem in Tabulated Form.
A sample of coal was found to have the following percentage composition C=75 %, H2 = 5.2 %, O2 = 12.8 %, N2 = 1.2 % and the rest ash. Calculate the amount of air needed for the complete combustion if 1 kg of the coal is burnt with 30 % excess air.
Thirty kilograms of butane gas per minute burns with dry air inside a combustion chamber, giving products having the dry molar analysis of 11.0% carbon dioxide, 1.0% carbon monoxide, 3.5% oxygen, and 84.5% nitrogen. Calculate the minimum duct diameter, in mm, used to supply the combustion air at 1 bar and 27 deg C and at a flow velocity of 15 m/s.
The exhaust gas analysis of an engine using octane as fuel gives equal values of CO, and unused O. Computer actual and stolchlometric air-fuel ratio. For equivalence ratio of 1. Calculate (1) The volume of mixture per kg of fuel at pressure of 100 kPa and temp 70°C.. () The volume of combustion products per kg of fuel when temp, of products is 127 c at 1 bar.
* The molar analysis of producer gas is N; 50.9%, CO 27.0%, [Example| H; 14.0%, CO, 4.5%, CH,4 3.0%, and O, 0.6%. Determine the stoichiometric air fuel ratio of producer gas. ((A/F)y = 1.443)