Answered: For the vessel containing glycerin…

For the vessel containing glycerin under pressure as shown in Fig. 2-2, find the pressure at the bottom of the tank. 2.2 S0 LP I Glycerin Fie. 22

International Edition---engineering Mechanics: Statics, 4th Edition

4th Edition

ISBN:9781305501607

Author:Andrew Pytel And Jaan Kiusalaas

Publisher:Andrew Pytel And Jaan Kiusalaas

Chapter8: Centroids And Distributed Loads

Section: Chapter Questions

Problem 8.121P: One side of the container has a 03-m square door that is hinged at its top edge. If the container is...

See similar textbooks

Related questions

Q: Q2) for the given gate find the force and it center of pressure, If H=2 m and K=3 m. Oil s.g =0.9…

Q: Consider an object that sinks to the bottom of a beaker of liquid. The object is a block with a…

Q: 3.22 The manometer shown contains water and kerosene. With both tubes open to the atmosphere, the…

A: GIVEN:Density of Kerosene= 810 Kg/m3 Density of Water= 1000 kg/m3 ρk=Density of Kerosene ρw=Density…

Q: The pressure of water in a pipeline was measured by means of a simple manometer containing mercury.…

Q: A hiker is carrying a barometer that measures 101.3 kPa at the base of the mountain. The barometer…

Q: Figure Q2 shows two tanks which contain the solvent used for plastic manufacturing. Tank A contains…

Q: Determine the reading h in meter based on Fig. 2-22 for a pressure of 52 kPa vacuum at point A if…

Q: A closed tank having a volume of 2 ft3 is filled with 0.30 lb of a gas. A pressure gage attached to…

Q: H-W 2 Q1/ Compute the horizontal and vertical components of the hydrostatic force on the…

Q: 7. An open tank contains 5.7 m of water covered with 2.8 m of kerosene (y=8.0 kN/m³ ). Find the…

Q: A solid block having SG = 3.47 is placed in a cylinder containing mercury having SG = 13.6. If the…

Q: An open tank contains 5.8 m of water covered with 3.2 m of kerosene (y = 8). Find the pressure (kPa)…

A: Given Data - In Open tank Water up to a depth of 5.8m cover with kerosene with a depth of 3.2m The…

Q: The pressure of water in a pipeline was measured by means of a simple manometer containing mercury.…

Q: 3.24 Determine the gage pressure in kPa at point a, if liquid A has SG = 1.20 and liquid B has SG…

A: To solve this type of problems, use Pascal law and Hydrostatic law. Pascal law states that the…

Q: Figure Q2 shows two tanks which contain the solvent used for plastic manufacturing. Tank A contains…

Q: A container is filled with oil. A pipe is connected to the container at point C and the owner left…

Q: 2.18 What is the change in the viscosity and density of water be- tween 10°C and 70°C? What is the…

Q: 2. An open tank contains water up to a depth of 2 m and above it an oil of sp. gr. 0.9 for a depth…

Q: The pressure of water in a pipeline was measured by means of a simple manometer containing mercury.…

A: Solution: The given the manometeric reading in the question is as shown in the figure, with,…

Q: A closed box with horizontal base of 6x6 m and height of 2 m is half filled with water. It is given…

Q: A container is filled with oil. A pipe is connected to the container at point C and the owner left…

Q: 4. A vessel of cylindrical shape is 50 cm in diameter and 75 cm high. It contains 4 kg of a gas. The…

A: Given Data: Mass of the gas, m=4 kg Diameter of the cylinder, d=50 cm Height of the cylinder, h=75…

Q: he Titanic ship’s lost sister named Britannic sank off the coast of Greece 400 ft below the sea…

A: Givendepth H=400ft =400×0.3048 m=121.92mdensity ρ=63.9 lbm/ft3 =63.9×16.0185 kg/m3=1023.58 kg/m3

Q: Determine the pressure in a vessel of mercury at a point 400mm below the liquid surface, expressing…

A: Given: h = 400 mm

Q: 2.41 For the inclined manometer containing mer- cury, shown in Figure P2.41, determine the pressure…

Q: For a vertical rectangular gate, one side has linseed oil (0.938) and the other has two…

A: Calculate the magnitude and direction of the net force acting on the gate.

Q: 3. A container shown is at 90 deg F, The pressure at point A w. the pressure at point B, C and D in…

A: Temperature = 90°FPressure at point A (pA)=41 in of Hg = 2900 lbf/ft2 To-Find:- Pressure at point…

Q: 4. Determine the pressure in a vessel of mercury at a point 400mm below the liquid surface,…

Q: A closed vessel is divided into two compartments. These compartments contain oil and water as shown…

Q: The flat surface shown is submerged vertically in water. Find the fluid force against the surface.…

Q: 3-49 The pressure difference between an oil pipe and water pipe is measured by a double-fluid…

A: GivenDiffrential manometer as shown below

Q: The pressure of water in a pipeline was measured by means of a simple manometer containing mercury.…

Q: Q2: A 2 mm diameter clean glass tube is inserted in water at 20 °C. Determine the height that the…

Q: Find the mass of ammonia in the 306 ft tank having a pressure of 239 psi at 505 F? (Ammonia = NH3).…

Q: 2. Given the two compartment vessel as shown in the figure. Gage A reads 85 psig, gage B inside the…

A: Given Data Gage pressure A reads =85 psig Gage pressure B reads=25 Psig Barometer reads in Hg…

Q: For the dam shown in Fige 2-1, find the borizontal pressure acting at the face of the dam at 20-ft…

A: Given:- Depth (h) = 20 ft The weight density of water (γ) =62.4 lb/ft3 To Find:- Pressure at the…

Q: Q2) for the given gate find the force and it center of pressure, If H=2 m and K=3 m. H Oil s.g =0.9…

A: Given: Specific gravity of oil is, S=0.8 . Width of the plate surface, b=90 cm. Depth of the plate…

Q: 1. Containers of various liquids are connected to a U-shaped tube as shown (the surface of the oll…

A: A manometer is a device that measures liquid pressure in relation to an external source, which is…

Q: A cargo truck with a weight of 289kN was raised using a hydraulic press. If oil acts on piston with…

Q: what type of pressure is generated from the formula of hydrostatic pressure? explain.

Q: Determine the hydrostatic force on the bottom of a tank 3 x 3,6 x 3 m if filled vith vater to a…

Q: For a vertical rectangular gate, one side has linseed oil (0.938) and the other has two…

Q: 3.14 Determine the pressure p, in the bulb for the manometer readings shown. Oil (SG 0.85) 30 in.…

Q: Q2: A cubical tank has sides of 3.75m which contains three immiscible liquids at same depths. A…

A: Given data Side length of the cube L = 3.75m Height of water Hw = 1.25m from base Height of liquid…

Q: If the added mass on the lid was 50 kg, a total mass of 60kg would exert pressure on the gas inside…

A: Given Data mlead=50 kg

Q: If the bottom pressure is 1.27 [Kg/cm2.abs], find the height of the liquid with a density of 0.642…

A: Given data, P= 1.27 kg/cm2 = 124544.5 Pa. P is absolute pressure. D= 0.642 g/cm3 =642 kg/m3 Let…

Q: A rigid tank contains 2 kg of water In the question that follows, select the answe

A: given:mass m=2kgquality x=0.6temperature t=100 c

Concept explainers

Work and Heat Transfer

It is generally related to thermal engineering which tells about the use, creation, conversion and transfer of heat energy between the systems. It is also considered that to transfer heat from one source to another, transfer of masses is also required. There are various mechanisms by which, transfer of heat takes place i.e. thermal conduction, convection, radiation or by change of phase. All these mechanisms have their own specific features which sometimes occur simultaneously within the same system.

Question

100%

Find the pressure of glycerin in tank with 2meters high with 50 kpa.

For the vessel containing glycerin under pressure as shown in Fig. 2-2, find the pressure at the bottom of the
tank.
2.2
S0 LP
Glycerin
Fie. 22

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2-Solutions

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, mechanical-engineering and related others by exploring similar questions and additional content below.

Similar questions

A circular plate of diameter 1.5 m is vertically placed in water in such a way that the centre of the plate is 3.35 m below the free surface of water. Find the following. Total Pressure on the circular plate (in N) Answer for part 1 Centre of Pressure on the circular plate (in m) Answer for part 2
For a vertical rectangular gate, one side has linseed oil (0.938) and the other has two fluids—castor oil (0.96) and water. Considering a unit-width of the gate, apply the PRESSURE PRISM CONCEPT (Illustrate and label the pressure diagram/prism) to calculate the magnitude and direction of the following when z = 7m. FIND: A. The hydrostatic force due to linseed oil F1. B. The hydrostatic force due to castor oil F2. C. The hydrostatic force due to water. D. The net hydrostatic force acting on the gate Fnet
The cylinder and tubing shown in Fig. 2-26 contain oil, sp gr 0.902. For a gage reading of 31.2 psi, what is the total weight of piston and weight W? The answer was given please show the solution. Answer: 136,800 lbs
A glass tube of internal diameter 3 mm is immersed in mercury. The angle of contact of mercury with glass can be taken as 130°. What will be the level of Hg in the tube relative to the free surface of the liquid outside the tube? Take surface tension of liquid = 0.48 N/m.
Determine the reading h in meter based on Fig. 2-22 for a pressure of 52 kPa vacuum at point A if the liquid is kerosene (s.g.=0.83).
A glass tube of internal diameter 3mm is immersed in mercury. The angle of contact of mercury with glass can be taken as 130°. What will be the level of Hg in the tube relative to the free surface of the liquid outside the tube? Take surface tension of liquid = 0.48 N/m.
2. A spherical balloon containing Oxygen (initially at sea level) has a diameter of 8in. If the uniform density of air is 0.07498lb/ft3 and that the pressure at sea level is 14.7psia, determine the new diameter (inch) of the balloon if it has been brought above sea level by 6000ft. Draw a figure or FBD that will support the problem. Explain each step by step formula.
The container shown contains water and air. What is the pressure inA, B, C and D in psi and in pascals? (see img 1)
Need quick handwritten solution. The gauge pressure in the air container in Fig. P1-83 is 80kPa . Calculate the differential height h of the column of mercury.
Water in a tank is pressurized to 85 cmHg (Fig. 3-29). Determine the hydrostatic force per meter width on panel AB.
(Please no hand writing solution) What is the pressure at the bottom of 10,000 feet of methane (MW =16) if the surface pressure is 400 psia and the temperature is 640 R.
Bottle was filled with water and a hole is punched in the bottle.When the bottle is closed, water does not come out of the hole. However, when the bottle is open, water comes out of the hole. Other information would be - Atmospheric pressure is 1 atm (101325 Pa) - Assume bottle is 20 cm and the hole is on the 10 cm above the bottom of the bottle (use it as reference level) Define the pressure(s) acting at the hole when the bottle is open and calculate total pressure. Define the pressure(s) acting at the hole when the bottle is closed and calculate total pressure. Using the results from part a and b, why does water come out when the bottle is open and why does not it come out when the bottle is closed?