Given the circuit below and the associated set of voltages and currents, the real Power delivered by theindependent voltage source isV310j2 N +j3 N12ΩΕV1.39 I,-j16 NV, = 150 /0° VVi (78 - j104) VV2 (72 + j104) VI, = (-26 – j52) AI, = (-2 + j6) AI = (-24 - j58) AV3 = (150- j130) VCopyrighe 201st Peirse Ecation inc putlishing as Piene HalNote: The given values are not RMS values. V1= (78-j104) Vk = (-26 – j52) AI, = (-2+ j6) AI = (-24 – j58) AV2 = (72 + j104) VV, = (150 – j130) VCopyright 0 2011 Pearson Education, Inc. publishing as Prensice HallNote: The given values are not RMS values.Select one:a.1990 WO b. 3900 WC.2050 Wd.1950 W

Answered: Image /qna-images/answer/f1fdccb4-0bed-4515-bc4d-9660f71d0948.jpg

Given the circuit below and the associated set of voltages and currents, the real Power delivered by the independent voltage source is +. V3 j2 N j3 N 12 03 V, 39 I, -j16 0 V, = 150 /0° V Vi (78- j104) V %3D I, = (-26 - j52) A

Given the circuit below and the associated set of voltages and currents, the real Power delivered by the independent voltage source is +. V3 j2 N j3 N 12 03 V, 39 I, -j16 0 V, = 150 /0° V Vi (78- j104) V %3D I, = (-26 - j52) A

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

A series circuit of RLC with following parameters, R=15 ohm, L=20 m H & C=100 micro Farad. VT=169.7 sin (337t-30) Volt. Find the following: Zt, , It, Voltage across each element, Power factor, apparent power, real or average power and reactive power and the total phasor diagram and power phasor diagram
Given the voltage υ(t) = 120 cos (314t + π/4) V, determine the frequency of the voltage in Hertz and the phase angle in degrees. (Answer: 50 Hz ; 45°) 2- Three branch currents in a network are known to be i1(t) = 2 sin (377t + 45°) A i2(t) = 0.5 cos (377t + 10°) A i3(t) = - 0.25 sin (377t + 60°) A Determine the phase angles by which a) i1(t) leads i2(t) b) i1(t) leads i3(t).
A circuit branch is found to have an equivalent impedance of Z=120−j45Ω. It is given that this impedance is a series combination of a 120Ω resistor and another passive component. If the circuit has a sinusoidal voltage source whose frequency is 120 Hz. What is the value of the component in series with the 120Ω resistor? (Note: Express the value assuming a metric scaling of μ(10-6). Provide your answer in decimal form, up to 3 decimal places.)
The RMS voltage and RMS current associated with the black box below are: V(t) = 0.8 COS (1200t+85) V; I(t) = 12 COS (1200t+60) mA a. Find the content and value(s) of the circuit element(s) in the black box and calculate real, reactive and apparent power. Build the circuit validate your solution(s) using Multisim. b. If the current associated with the black box is replaced withI(t) = 12 COS (2400t+85) mA, would the content of the box change? If so; what would be inside? Justify your answer?
InclassofENG100youwereaskedtoconnectacoilofresistance50Ωand inductance0.318Hwithacircuitcomprisinga75Ωresistorinserieswitha 159µFcapacitor.Andyouconnectedyourresultingcircuittoa240v,50HzAC supply. Calculate: (a)the supply current of your circuit; EV(7) (b)the circuit impedance, resistance and reactance; CR(7) (c)the phase angle of the resulting current,use (sine) as your reference and explain your result. AN(6) Question2
Three branches having impedances of 3+j4 Ω, 16−j12 Ω, and−j4 Ω, respectively, are connected in parallel. What are the equivalent(a) admittance, (b) conductance, and (c) susceptance of the parallelconnection in millisiemens? (d) If the parallel branches are excited froma sinusoidal current source where i=8 cosωt A, what is the maximumamplitude of the current in the purely capacitive branch?
Two equal voltages are out of phase with respect to each other by 90 electrical degrees. If the resultant is 311 Volts, what is RMS value of each one?-write legibly-show the complete solution
given The sinusoidal current source produces the current 8*cos(20,000t) A. L = 40 uH C = 1 uF R1 = 10 ohms R2 = 5 ohms R3 = 6 ohms a. what is inductor impedance ZL? b. what is capacitor impedance ZC? c. what is admittance Y1 in the branch on the left? d. what is admittance Y2 in the branch in the middle? e. what is admittance Y3 in the branch on the right? f. what is the equivalent admittance to the right of the current source? g. what is the equivalent impedance to the right of the current source? h. what is the source voltage, v? i. what is the phasor current I across the capacitor? Please all subparts in short like it definitely don't reject in shorts please..
An impedance draws a current i = 10 cos (wt – 30°) Amp from a voltage v = 220 sin (wt + 30°) Volts. What is the impedance of the circuit? a. 15.6 – j15.6 ohms c. 19.1 – j11 ohms b. 15.6 + j15.6 ohms d. 11 + j19.1 ohms
Determine the following for the network below. Find the total impedance |ZT| = [Z] ∠ [Z_degrees]° units [Z_units] Find the total current |IS| = [I] ∠ [I_degrees]° units [I_units] Find the total complex power in rectangular and polar form ST = [Pt] units [Pt_units] + j [Qt] units [Qt_units] ST = [Smag] ∠ [S_degrees]° units [St_units] Find the total apparent power |ST| = [S] units [S_units] Find the power factor pf = [pf] lagging or leading [lag_lead] On your hand written work sketch the power triangle for the total complex power.
1. A 70-Vac source has the following waveform. Determine: a. Vpkb. Vpk-pkc. Vrmsd. Periode. Frequencyf. Angular Velocityg. Phase Angle h. equation of the waveform (in time domain)i. the instantaneous voltage when t = 120 msj. the angle (1st occurrence) after t = 0 when the voltage is +80 Vk. the time (2nd occurrence) after t = 0 when the voltage is –10 VAnswers:a. 98.9949 Vb. 197.9899 Vc. 70 Vd. 100 mse. 10 Hzf. 20π rad/secg. 54.9124°h. v(t) = 98.9949sin(20πt - 54.9124°)i. 29.0880 Vj. 108.8253°k. 66.8639 msGive the solution for K ONLY Ans: 66.8639 ms
Determine the rms values of each of the following (a) v(t) = 100 sin(ωt) V Vrms = 70.7V (b) i(t) = 8 sin(377t) A Irms = 5.656V(c) v(t) = 40 sin(ωt + 40o) V Vrms = 28.28V (d) i(t) = 120 cos(ωt) mA Irms = 84.84A Can you double check if my answer is correct?