Given written specifications, develop the note for a threaded fastener. With the following specifications, develop the note for this threaded fastener. The threaded fastener has: • a major diameter of 3/4 inch, • a pitch length of 0.050 inches, • a unified coarse thread form, • which has a class of fit of 2, • it is an internal thread, and has a length of thread engagement of 2 1/2 inches.

Given written specifications, develop the note for a threaded fastener. With the following specifications, develop the note for this threaded fastener. The threaded fastener has: • a major diameter of 3/4 inch, • a pitch length of 0.050 inches, • a unified coarse thread form, • which has a class of fit of 2, • it is an internal thread, and has a length of thread engagement of 2 1/2 inches.

Precision Machining Technology (MindTap Course List)

2nd Edition

ISBN:9781285444543

Author:Peter J. Hoffman, Eric S. Hopewell, Brian Janes

Publisher:Peter J. Hoffman, Eric S. Hopewell, Brian Janes

Chapter5: Turning

Section5.4: Manual Lathe Threading

Problem 1RQ: The distance of actual contact of two mating threads measured along the length of the two threads...

See similar textbooks

Similar questions

1(a) Draw and label any screw thread and a fastener separately.
The distance of actual contact of two mating threads measured along the length of the two threads the ____.
What dimension of the thread is measured by using a thread micrometer or the three-wire method?
3) To provide a clamping force of 48,000 lb between two components of a machine (Tensile load, ignore bending), A set of six screws is used. The load is equally shared among three screws. Specify suitable standard screw, including grade of the material (Use Table 10.1 and 10.4 from the book to select the standard size screw. SAE Grade 7 type fasteners with UNC thread need to be used.). Clearly write down all the assumptions, and the details of the screw selected. Calculate the torque prescribed.
A metric thread of pitch 2 mm and thread angle 60° is inspected for its pitch diameter using 3 wire method.calculate the diameter of the best size wire.
A power screw is 25 mm in diameter and has a thread pitch of 5 mm.(a) Find the thread depth, the thread width, the mean and root diameters, and the lead, pro-vided square threads are used.(b) Repeat part (a) for Acme threads.
In using the formula for measuring an American Standard Unified Screw Thread by the three-wire method, why should the constant 0.86603 be multiplied by the pitch before subtracting from measurement M, even if not enclosed by parentheses? E=M+0.86603P+3W ?
Screw threads are often designated by omitting the screw tolerance symbols. Explain the meaning of the following thread designations:a) 3/8-16UNC __________________________________________________________________________b) M16X2 __________________________________________________________________________
Design of the Screw Jack. Lifting load – W, kN is 70. Hight of lifting– H, mm is 500 Types of threads is Square Material of nut is Cast iron
Question No.16: A double threaded power screw with ISO metric trapezoidal threads with 15° semi-angle of thread is used to raise a load of 300 kN. The nominal diameter is 100 mm and pitch is 12 mm. the coefficient of friction at screw threads is 0.15. Neglecting collar friction, calculate; (i) torque required to raise the load, (ii) torque required to lower the load and (iii) efficiency of the screw.
Explain the major diameter of a thread.
what types of stress acting on screw thread and a fastener separately