How much will an air leak cost during three monthes? the hole has a diameter 6.35mm at line pressure 690 kPa, use the cost of electricity 7 cents per kWh. a. all of the answers are not correct b. 1620 JD C. 5390 JD d. 935 JD e. 2390 JD

How much will an air leak cost during three monthes? the hole has a diameter 6.35mm at line pressure 690 kPa, use the cost of electricity 7 cents per kWh. a. all of the answers are not correct b. 1620 JD C. 5390 JD d. 935 JD e. 2390 JD

Refrigeration and Air Conditioning Technology (MindTap Course List)

8th Edition

ISBN:9781305578296

Author:John Tomczyk, Eugene Silberstein, Bill Whitman, Bill Johnson

Publisher:John Tomczyk, Eugene Silberstein, Bill Whitman, Bill Johnson

Chapter40: Typical Operating Conditions

Section: Chapter Questions

Problem 10RQ: The seasonal energy efficiency ratio (SEER) includes the energy used in the _____and _____cycles.

See similar textbooks

Related questions

Q: me final value of y(t) wl

A: need to determine Value of y(t)

Q: thermal efficiency. 64.59% amount of heat added. 556.7054 kJ the maximum gas pressure and…

A: Given: Dual cycle Compression ratio= 14 cutoff ratio= 1.2 pressure ratio = 1.5 P1= 80 kPa T1=20oC…

Q: Kerosene, SG=0.82 Air, SG=0.0012 Benzene, SG= 0.88 100mm B 200mm 150mm 90mm Water Hg 400mm

A: Given Data: The specific gravity of mercury, SG=13.6

Q: A thrust B journa 350N 0.25m B 0.35m 0.35m 0.15m 0.2m 0.Im P draw fbd

A: Draw free body diagram.

Q: OC will be 0.05 m

A: (a) Draw a free-body diagram of the system. Apply force equilibrium in a horizontal direction.…

Q: kj/kg, ochange in eafrey ky/My k solve coorte

Q: A vessel in Latitude 17- 45'N, Sails to Latitude 15 - 15'N, Find the difference o Latitude made?

Q: The coal consumption per hour is the ratio of heat of combustion and calorific value.

A: True

Q: A-20 in Oil SG 0.86 51t 0.8 t A-50 in. SG 2.5

Q: Identify the main sources of environmental pollution in the village/town/city

A: Pollution: The introduction of any harmful thing or material into the environment is known as…

Q: A flue from an oil furnace to the chimney is made from 9 pieces of pipe. Afterbeing fitted together,…

A: Solution:

Q: Find the efficiency

A: Given data : Input power=I Output power=O Required : Efficiency

Q: Define the site for a wind farm?

A: A suitable site for wind farms is the one where airflow at a constant high speed and less turbulence…

Q: from a vertica is found to be °C, all other p Nusselt numb

A: solution of given problem is below:

Q: Find h

A: Given: PA-PB=-27 kPa To determine: h

Q: coefficient of discharge=

A: Given: h1=314 mm h2= 286 mm Q=165 ltter/s A1=338.6 mm2 A2=84.6 mm2 To determine: The coefficient of…

Q: Madde P (kPa) T ('C) Faz tanımı H,O 10000 100 300 Dovmuş sıVI

A: From the steam table, At P=10000 kPaTsat=310.997 °CAnd the given T=100 °C,T<TsatHence At P=10000…

Q: What is the static pressure at A? Pa 32 cm 10 cm P2 Take: Patm = 100 kPa P1- 400 kg/m P2= 1000 kg/m?…

Q: ral efficiency

Q: Show the temperature distribution in degree Celsius in an exhaust valve of IC Engines.

A: Internal combustion engines usually consists of two types of engine valves Inlet valves and exhausts…

Q: 2. Compute por the torce in mem bers DD, Dx, and Ao 2000 Ib 3000 b B 60° A b00 C 4000 llb REV

A: ca

Q: To 212 F Water at 65 F flows nto a boiler at 5 gal min. It is converted to steam at 212 F Find the…

A: Given Data State 1: Saturated water, 65°F State 2: Steam, 212°F V= 5 gal/min

Q: 10. L[e * cos(√2t)]=

A: As per our guidelines we are supposed to answer only one question in case of multiple questions…

Q: Place the correct formula in the blank %To determine Generated Power Output of Wind turbine

A: Given:- Wind turbine:- To find- Power formula

Q: E. How far is the ship from the port at 11:00 A.M.? C) 32.78 km

A: Need to find the distance

Q: ne shear stress in

Q: 02.Comlete the following Table for R134a

A: Using Property table of R-134a and P-h chart the required data is tabulated below.

Q: el ratio at 6000 m altit sea level where air ter

Q: a generic 2.5MW

Q: 30N/m 0.4kg Wwww

A: For solution refer below images.

Q: 12 Find maX. W=? if of530Mpa Ś GoMpa い Joomm 2m An 30 そaん 500

A: Stress When body is subjected to any load then body resist that load and the resistance is called as…

Q: G Determine the equillalent. tiffness for the dreegreem

A: Solution:

Q: W = 15kg %3D B 1.5m Im VHA 5m

Q: p = 2 psi SG = 0.9 Air 1 ft 4 ft 2 ft A Water

Q: OIL Sp. gr. 0.8 30 сm 100 cm 50 cm EB

Q: QUESTION 3 When valve A is closed, the pressure difference between A and B is -27 kPa. (11) Find h…

A: Pascal's law states that on a given horizontal plane of static fluid, a fluid particle experiences…

Q: 400mm Kerosene, SG 0.82 Air, SG=0.0012 Benzene, SG= 0.88 100mm 200rn 150mm 90mm Water Hg What is the…

A: It is required to determine the pressure difference between pipes of air(A) and pipes of benzene(B)

Q: QUESTION 4 4.1 Write the expression used to define the following: (a) volumetric efficiency (b)…

A: (a) To define: The volumetric efficiency with the expression. Explanation: The ratio of the actual…

Q: A wind generator is installed. It is determined that the capacity factor of the installation is 29%…

Q: Question 1 Ia. You want to draw water from a stream running down a hill behind your hoūse at a rate…

A: We are suppose to solve only one question. Please post other question as a separate question.

Q: dinder with draft 2 m and radius 1 m, as below.

Q: On F2, how to identify the if we need to multiply it by "(4/5) and (3/5) slopes"?

A: To find: How the vector form of the force F2 is obtained.

Q: Disadvantage of constantan.

A: Solution: Constantan: It is an alloy made from 55% Copper and 45% Nickel.

Q: Tx=/25 Mea HW #3 due date. wednesde T2=? uncler Novolume cheye? do 10cm 20=0 ( For novalmachaye) Fx…

A: Given data: Diameter, d = 10 cm Initial length, l=50 cm Increase in length, δl = 55-50 = 5 cm…

Q: Fluid Force. A swimming pool is filled with fresh water to a depth of 7 feet measured at the deep…

Q: The net power imput

Q: H.W.: As shown in figure below, determine the pressurt point A. Hg Ans. : (2.164 Kla Vacuum Water…

A: As per the given data and the standard values of density, the answer I got is absolutely correct.…

Concept explainers

Free undamped vibrations

Whenever an object/system displaces in either side of its equilibrium position with the help of an external/internal means, then the object/system moves regularly or randomly on both sides of its equilibrium position. This motion is called vibration. Generally, there are three types of vibration: longitudinal vibration, transverse vibration, and torsional vibration.

Question

How much will an air leak cost during
three monthes? the hole has a diameter
6.35mm at line pressure 690 kPa, use the
cost of electricity 7 cents per kWh.
a. all of the answers are not
correct
b. 1620 JD
C. 5390 JD
d. 935 JD
e. 2390 JD

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step 3

VIEW

Step by step

Solved in 3 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, mechanical-engineering and related others by exploring similar questions and additional content below.

Similar questions

V3kg=3.025 m/s Wt=8.644 rad/s
ANSWERS: NPW= 0.34 NFW= 0.54 AW= 0.09 PI= 1 IRR i%= 10% = M.A.R.R. ERR i%= 10% = M.A.R.R. PAYBACK Simple= 4.6 years and Discounted= 5 years B/C Conventional= 1 and Modified= 1
From a test of an air compressor driven directly by a steam engine , the following data and results were obtained: capacity, 800 cfm; suction at 14.7 psia; discharge at 110 psia; indicated work of the compressor, 155 hp; indicated work of steam engine, 172 hp. Calculate (a) the compression efficiency and (b) the overall efficiency. Ans. (a) 90.06%; (b) 81.16% with step by step please! thanks
w=25kn/m a=1m
considet m kg out of 1gk id taken to the feed henter
Pls. answer thank you! A steam turbine of 6 MW capacity has a Willan's line equation of ms = 5.52 + 3.200 kg/hr. Determine the steam consumption at 63% load, kg/hr.
A wind generator is installed. It is determined that the capacity factor of the installation is 29% over the course of a 90-day period. In that period, it produced 1566 MWh. What is the size of the installation (MW)?
Show that Rankine=Kelvin(1.8)
HANDWRITTEN AND FINAL ANSWER MUST BE IN ENGLISH UNITS. Show solution. An experimental gas turbine engine is under development to increase its mechanical efficiency. It has a turbine efficiency of 95% and compressor efficiency of 85%. The following parameters are provided: P1 = 550 kPa, T1 = 25 deg C, rp = 5.5, T3 = 1450 deg C, Wnet = 5500 kW. Compute for the (a) flow rate and (b) mean effective pressure. Consider Ethane as your working fluid.
Pls. answer thank you! The indicated efficiency of a steam engine is 65%. The engine entrance is 2600 KJ/kg and exit is 2100 KJ/kg. if steam consumption is 3500 kg/hr and mechanical efficiency is 90%, what is the brake power of the engine in Kw?
Explain Correctly asap. Answer :234 kpa
A two-stroke cycle internal combustion engine has a mean effective pressure of 6 bar. The speed of the engine is 1000 rpm. If the diameter of piston and stroke are 110 mm and 140 mm respectively, find the indicated power developed. a. 25.4 kW b. 20.1 kW c. 15.6 kW d. 13.3 kW