Hydroxyapatite, Ca,,(PO,),(OH), , has a solubility constant of Kp = 2.34 x 10–59, and dissociates according to Ca1, (PO,),(OH), (s) = 10 Ca²+(aq) + 6 PO (aq) + 2 OH-(aq) Solid hydroxyapatite is dissolved in water to form a saturated solution. What is the concentration of Ca²+ in this solution if [OH¯] is fixed at 5.30 × 10-4 M? (Cca**] = M

Hydroxyapatite, Ca,,(PO,),(OH), , has a solubility constant of Kp = 2.34 x 10–59, and dissociates according to Ca1, (PO,),(OH), (s) = 10 Ca²+(aq) + 6 PO (aq) + 2 OH-(aq) Solid hydroxyapatite is dissolved in water to form a saturated solution. What is the concentration of Ca²+ in this solution if [OH¯] is fixed at 5.30 × 10-4 M? (Cca**] = M

Chemistry

10th Edition

ISBN:9781305957404

Author:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Publisher:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Chapter1: Chemical Foundations

Section: Chapter Questions

Problem 1RQ: Define and explain the differences between the following terms. a. law and theory b. theory and...

See similar textbooks

Similar questions

To compute the solubility product (Ksp) of barium nitrate (Ba(NO3)2), an excess amount of Ba(NO3)2 was added to 2 liters of water at 25 degrees celcius until the solution is saturated. Ba(NO3)2 is only slightly soluble in water. It was observed in their experiments that the solution boils at 100.15 K. Barium nitrate dissociates via the process: ?a(NO3)2(s) ⇄ Ba2+(aq) + 2NO3- (aq) Ksp = [Ba2+][NO3-]2 What is the solubility product Ksp and vapor pressure of the solution?
The hardness of water (hardness count) is usually expressed in parts per million (by mass) of CaCO3. What is the molar concentration of Ca2+ ions in a water sample with a hardness count of 175mg CaCO3il? How many milliliters of concentrated sulfuric acid, 94.0% (w/w), specific gravity of 1.831 are required to prepare 1 liter of a 0.100 M solution? The solubility-product constant for Ce(IO3)3 is 3.2x1010. What is the Ce3+ concentration in a solution prepared by mixing 50.0 ml of 0.0250 M Ce3.. with 50.00 ml of water?
As part of the analysis of water samples, the hardness of water is commonly measured and calculated. It is commonly expressed in ppm by mass (parts per million) of CaCO3. Parts per million is also equivalent to milligrams of CACO3 per liter of water. In a sample taken by an environmentalist, he was able to observe a hardness count of 205 mg CacO3/L. Given this hardness count of the sample, what is the molar concentration of Ca2+ ions in the water sample?
Consider the titration illustrated in Figure 8.] Anhydrous sodium carbonate (Na₂CO₃) is a primary standard. When 0.364 grams of the substance is placed in a conical flask, then 20.00 cm³ of sulphuric acid (H₂SO₄) solution is required to reach the end point of the titration. What is the concentration in mol·dm⁻³ of the sulphuric acid solution? [Give the answer to 3 decimal places. Do not type in the unit. Use a decimal point.] *
Potassium acid phthalate, KHC8H4O4 ( MM=204.2 ), reacts with sodium hydroxide on a 1:1 molar basis. A sample of the acid weighing 0.4823 g was titrated with NaOH, requiring 24.35 mL to reach the endpoint. Calculate the molar concentration of the sodium hydroxide solution.
Pseudogoutis caused by the formation of calcium diphosphate (Ca2P2O7) crystals in tendons, cartilage and ligaments, usually occurring if diphosphate levels in blood plasma 7 become very If the [Ca2+] in blood plasma is 9.2 mg/dL and Ksp for Ca2P2O7 is 8.64 x 10-13, what is the minimum concentration of diphosphate P2O 4- necessary for precipitation?
To determine the fluoride content in an aqueous and chloride-containing preparation of ammonium fluoride, the following analysis was performed. 105.2 mg of the preparation was dissolved in 100.0 mL of water. Then a 300 mL 40 mM lead chloride solution was added, whereby all fluoride ions were precipitated out of the solution in the form of the sparingly soluble salt PbClF (s). The precipitate was separated and washed at 15 degrees with a lead fluoride chloride saturated solution and dried at 130 degrees. The precipitate weighed 651.3 mg. a) Calculate the fluoride content (as % by weight F) in the preparation.b) Determine the purity of the ammonium fluoride preparation
In the laboratory, a student was tasked to prepare a stock solution of HCl for titration. The available analytical grade HCl solution in the stock room was labelled 35% w/v HCl. The student proceeded to prepare the stock solution by mixing 10mL of the HCl solution with 490mL of analytical grade water. Then, the solution was further diluted by adding 5mL, since the total volume of the solution did not reach the 500mL etched mark on the volumetric flask. To prepare the titrant, the student mixed 10mL of the stock solution, then added 40mL of analytical grade water. The titrant was subsequently used to determine the concentration of two titrand. *Use the table as a reference 1. What is the normality of the available HCl reagent in the stock room?* 5.08 N 10.15 N 20.3 N 11.0 N None of the choices 2. What is the normality of the stock solution of HCl?* 0.09N 0.10N 0.11N 0.12N None of the choices 3. What is the normality of the titrant?*…
A first-stage recovery of magnesium from seawater is precipitationof Mg1OH22 with CaO:Mg2+(aq) + CaO(s) + H2O(l)---->Mg(OH)2(s) + Ca2+(aq) What mass of CaO, in grams, is needed to precipitate 1000lb of Mg(OH)2?
As part of a soil analysis on a plot of land, a scientist wants to determine the ammonium content using gravimetric analysis with sodium tetraphenylborate, Na+B(C6H5)4−. Unfortunately, the amount of potassium, which also precipitates with sodium tetraphenylborate, is non‑negligible and must be accounted for in the analysis. Assume that all potassium in the soil is present as K2CO3 and all ammonium is present as NH4Cl. A 5.095 g soil sample was dissolved to give 0.500 L of solution. A 150.0 mL aliquot was acidified and excess sodium tetraphenylborate was added to precipitate both K+ and NH4+ ions completely. B(C6H5)4-+K+⟶KB(C6H5)4(s) B(C6H5)4-+NH4+⟶NH4B(C6H5)4(s) The resulting precipitate amounted to 0.269 g. A new 300.0 mL aliquot of the original solution was made alkaline and heated to remove all of the NH4+ as NH3. The resulting solution was then acidified, and excess sodium tetraphenylborate was added to give 0.129 g of precipitate. Find the mass percentages of NH4Cl and…
The precipitation of Al(OH)3 (Ksp = 1.3 x 10-33) is sometimesused to purify water. (a) Estimate the pH at whichprecipitation of Al(OH)3 will begin if 5.0 lb of Al2(SO4)3is added to 2000 gal of water. (b) Approximately howmany pounds of CaO must be added to the water toachieve this pH?
A Medical Technology student was given a capsule of a multivitamins and she was asked to determine the % by mass (w/w) of ascorbic acid present in the capsule. The student analyzed the 2.001 g sample using volumetric titration. The following data was generated in the analysis: KIO3 + 5KI + 6H+ → 3I2 + 6K+ + 3H2O C6H8O6 + I2 → C6H6O6 + 2I- + 2H+ Table 1. Standardization of KIO3 Molarity of Ascorbic Acid Standard Solution 0.03542 M Volume of Ascorbic Acid 25.00 mL Volume of KIO3 8.70 mL Molarity of KIO3 ______________M Table 2. Determination of Ascorbic Acid Concnetration Initial burette reading, KIO3 0.00 mL Final burette reading, KIO3 33.60 mL Volume consumed, KIO3 33.60 mL MM of Ascorbic Acid 176.12 g/mole choices 7.30% 30.1% 33.6% 32.5%