I have these buffer solutions HCL(acidic component) and NaOH(basic component) in a simulation. 1. Refer to the components of the buffer solution above. Write the (net ionic) neutralization reaction that occurs when OH- is added to the buffer through the addition of NaOH 2. Refer to the components of the buffer solution above. Write the (net ionic) neutralization reaction that occurs when H3O+ is added to the buffer through the addition of HCl

I have these buffer solutions HCL(acidic component) and NaOH(basic component) in a simulation. 1. Refer to the components of the buffer solution above. Write the (net ionic) neutralization reaction that occurs when OH- is added to the buffer through the addition of NaOH 2. Refer to the components of the buffer solution above. Write the (net ionic) neutralization reaction that occurs when H3O+ is added to the buffer through the addition of HCl

Chemistry: The Molecular Science

5th Edition

ISBN:9781285199047

Author:John W. Moore, Conrad L. Stanitski

Publisher:John W. Moore, Conrad L. Stanitski

Chapter14: Acids And Bases

Section: Chapter Questions

Problem 127QRT

See similar textbooks

Similar questions

Consider the acids in Table 13-2. Which acid would be the best choice for preparing a pH = 7.00 buffer? Explain how to make 1.0 L of this buffer.
Consider the following reactions:(1) HA + OH- = A- + H2O(2) HA + H3O+ = H2A+ + H2O(3) HA + H2O = H3O+ + A-(4) HA + OH- = H3O+ + A-(5) A- + H3O+ = HA + H2O(6) A- + H2O = HA + OH-(7) A- + OH- = HA + O2-Which one of these reactions (enter only the reaction number, 1 to 7) is mainly responsible for the fact that base added to the buffer solution causes only a very small change in pH?
Students Mola and Rity were tasked to analyze the acidity of a 10.0-mL fermented milk sample diluted with water in a 250-mL volumetric flask. Mola obtained a 15.0-mL aliquot of this solution, diluted it to 50.0 mL, and then titrated this diluted sample. Titration data were given to Rity and she found out that the 50.0-mL diluted sample contains 0.21 mmol of lactic acid. MW: Lactic Acid (90.08) a. What is the lactic acid concentration (in M) of the titrated sample? b. Determine the lactic acid content (in M) of the 10.0-mL fermented milk sample. c. What is the lactic acid concentration (in %w/v) of the 10.0-mL fermented milk sample?
Bicarbonate Buffer a. Prepare 100 mL of 0.200 bicarbonate buffer, pH 10, by calculating the mass of sodium bicarbonate and sodium carbonate. b. Use the Henderson-Hasselbalch equation to calculate the volume of each stock solution needed. pH = pKa + log [conjugate base] / [weak acid]1 c. Check your calculations with other students. See the instructor if there is uncertainty. d. Make the solution and check the pH of a portion of your buffer solution using the pH meter. L = 245μL Preparation of Bicarbonate Buffer Calculated Volume: CH3COOH = _______________ KH2PO4 = ________________ Actual pH of the buffer: _____12.65_____ NOTE: Please answer letter A, I need the volume. I already know how to calculate the actual pH. Thank you.
Q1. In Part B of the lab, you are going to see how the pH of the buffer will change after adding some HCl to it. If you added 1.0 mL of 2.0 M HCl to the buffer, how many moles of HCl did you add? Select one: a) 0.20 moles b) 2.0 moles c) 1.0x10-3 moles d) 2.0x10-3 moles
In each of the following questions, assume that there is no volume change when HCl is added to water in part (a) or the phosphate buffer in part (c). (a) Calculate the pH when 0.091 moles of HCl are added to 1.000 liter of water. (b) What is the difference between the pH of pure water (pH 7.00) and the pH of the solution after HCl was added? (c) Calculate the pH when 0.091 moles of HCl are added to 1.000 liters of a buffer containing 0.352M KH2PO4 and 0.321 M K2HPO4. (d) The pH before the HCl was added is equal to 7.168. What is the difference between the pH before adding the HCl and after adding the HCl?
Consider the below reaction, where you have 20.0ml of .18M C5H5N, which has a kB of 1.42x10^-9 C5H5N(aq) + HCl(aq) -> C5H5NH+(aq) + Cl-(aq) A. What is the pH at equivalence point using .069M HCl solution? What is the pH instead If you add 37 mL of .069M HCl solution?
A 5.00 L solution is 0.100 M in benzoic acid (Ka = 6.3 x 10-5) and 0.200 M in calcium benzoate. What is the pH of this solution after 5.00 mL 10.0 M HCl are added? A. 4.75 B. 4.80 C. 4.65 D. 4.79 Keywords: buffer, neutralization, weak acid, conjugate acid, conjugate base, Ka, pH, Henderson-Hasselbach Equation, strong base, grams, moles, molar mass, Bronsted-Lowry acid, Bronsted-Lowry base Please explain using the keywords, I dont understand how they fit into answering the question.
In the spooky chemistry lab, you spot a 50mL solution of 6.0M hydrochloric acid. What is the pH of this acid? Yeouch...that sure would hurt if it spilled on you! You remember from when we learned about dilutions that adding water reduces the concentration of a solution. Sweet. You decide to add 950mL of water to the solution. What is the new pH of the hydrochloric acid solution? Ok, weird one here, but this is Honors Chem, so challenges are always welcome. Yippee. So, let’s rewind back to the 50mL solution of 6.0M HCl. Let’s say that you want to dilute this solution so that it has a pH equal to exactly 7. How much water would you need to add to it in order to achieve this goal? (HINT: This is so unrealistic...which is why no chemist would ever do it...but it’s still fun to do the math & determine why it’s so crazy!)
Calculate the change in pH when 8.00 mL of .100 M HCl(aq) is added to 100.0 mL of a buffer solution that is 0.100 M in NH3(aq) and 0.100 M in NH4Cl(aq). Consult the table of ionization constants as needed. ΔpH= Calculate the change in pH when 8.00 mL of 0.100 M NaOH is added to the original buffer solution. ΔpH= The last person to help me on here got it wrong so please help me to understand how to do it
Acid-base Titration Assignment solves questions in end. if necessary use notebook to make the curve.A student conducted the following experiment in the lab. 50.00 mL of acetic acid (of unknown concentration) was pipetted into a 150 mL Erlenmeyer flask. An indicator was added and the pH of the solution was recorded. 0.1 M NaOH (a strong base) was added to the Erlenmeyer flask from a buret. The contents of the flask were continuously stirred and the pH was recorded every 2 mL using a pH meter.Data Collected: Volume of NaOH added (mL) pH 0.0 2.87 10.0 4.14 25.0 4.74 40.0 5.35 50.0 8.72 60.0 11.96 75.0 12.30 1. The chemicals involved in the titration are NaOH (a strong electrolyte) and CH3COOH (aweak electrolyte). Predict the shape of the titration curve that would be obtained from thedata above. Also predict what the pH at the equivalence point will be.2. What is the volume of NaOH at the equivalence point?3. What is the pH at the equivalence point?4. What does the…
a 200 mL of 0.05 F hydrogen sulfide solution is added to 25 mL 1.5 F acetic acid solution. Compute the sulfide ion concentration of the solution. please help me