(i) State the meaning of ppm. (ii) A sample of 3.25 cm of bromine vapour leaks into a laboratory. Calculate the minimum volume, in dm', of the laboratory for the resulting concentration of bromine to be at a safe level.

(i) State the meaning of ppm. (ii) A sample of 3.25 cm of bromine vapour leaks into a laboratory. Calculate the minimum volume, in dm', of the laboratory for the resulting concentration of bromine to be at a safe level.

Chemistry

10th Edition

ISBN:9781305957404

Author:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Publisher:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Chapter1: Chemical Foundations

Section: Chapter Questions

Problem 1RQ: Define and explain the differences between the following terms. a. law and theory b. theory and...

See similar textbooks

Related questions

Q: Discuss the distinction between the mole fraction the composition of the liquid phase and the mole…

A: Mole fraction is the ratio of number of moles of one component to the total number of moles of all…

Q: 5. Arrange the following compounds in order of decreasing volatility: acetone, methanol,…

Q: The concentration of water vapour in the Martian atmosphere is very low - only about 210 ppm (by…

A: Parts per million is a method of expressing the concentration of a component in a mixture. It is…

Q: Determine the mole fraction of ethanol in a 10% by volume aqueous ethanol solution. Given: Methanol…

A: A numerical problem based on mole fraction, which is to be accomplished.

Q: Determine the effect of crystal diameter on the solubility of KCl in water at 25oC.

A: To determine the effect of crystal diameter on the solubility of KCl:

Q: P4B.9 The vapour pressure, p, of nitric acid varies with temperature as follows: 20 40 50 70 80 90…

A: The graph between ln (p) versus 1/Θ is drawn below.

Q: A solution is prepared by dissolving 2.33 g of C60 (buckminsterfullerene)in 100.0 g of toluene…

Q: At 25 °C, the mass density of a 50 per cent by mass ethanol–water solution is 0.914 g cm−3. Given…

A: Mass of ethanol present in 100 g of solution = 50 g Mass of water present in 100 g of solution = 50…

Q: The concentration of O2 in water required to support aerobic aquatic life is about 4 .0 mg dm-3 .…

A: The minimum partial pressure of oxygen in the atmosphere that can achieve this concentration of…

Q: Derive the relationship between relative lowering of vapour pressure and molar mass of the solute.

A: It is known that the vapour pressure of pure solvent is higher than the vapour pressure of same…

Q: The vapour pressure of benzene at 20 °C is 10 kPa and that of methylbenzene is 2.8 kPa at the same…

A: 4

Q: Calculate the molar concentration of the polycyclic aromatic hydrocarbon (PAH), anthracene (178.23…

A: We have to calculate the molar concentration of water .

Q: Nuclear magnetic resonance can be used to determine the mobility of molecules in liquids. A set of…

A: For a molecule to move in a liquid, it must acquire at least a minimum energy to escape from its…

Q: The mobility of a chloride ion in aqueous solution at 25 °C is 7.91 × 10−8 m2 s−1 V−1. Calculate the…

Q: 5B.11(a) The vapour pressure of pure liquid A at 300K is 76.7kPa and that of pure liquid B is…

Q: The vapour pressure, p, of nitric acid varies with temperature according to the following data…

A: Please find the answer attached here as handwritten note.

Q: Suppose that on another planet the atmosphere consists of17% Kr, 38% CH4, and 45% O2. What is the…

A: Given information: Composition of Kr = 17 % Composition of methane = 38% Composition of O2 = 45%

Q: Determine the mole fraction of C3H8O and H2O in a solution prepared by dissolving 15g of alcohol in…

A: Given-> Weight of alcohol (C3H8O) = 15 gm Weight of H2O = 100 gm

Q: Under constant T and P, a polynomial fit to measurements of the total volume V (in cm3) of a binary…

Q: what is molar conductivity? what are its units?

A: Molar conductivity:The conducting power of ions produced by dissolving one mole of an electrolyte in…

Q: Calculate the permeability coefficient P of LDPE and PP at 45 Celcius, given that Ep= 40 kJ mol^−1…

A: The permeability coefficient of small gas molecule in polymer PM = PM0 exp (-QpRT)

Q: Suggest an explanation for the observations that propanol, C3H7OH, is miscible with water and that…

A: According to concept of like dissolve like, polar molecule will miscible in polar solvent and…

Q: The vapor pressures of two volatile organic compounds, compound 1 and compound 2, at 20 °C are 82.2…

Q: Estimate the effective radius of a glycine molecule in water at 25 °C given that its diffusion…

A: Given: Diffusion coefficient, D=1.055×10-9 m2 s-1 Viscosity of water, η=1 cP=0.001 kg m-1 s-1…

Q: Explain how osmotic pressure measurements can be used to determine the molar mass of a polymer.

A: The properties that depend on the number of solute particles are called colligative properties. When…

Q: Explain the origin of colligative properties.

A: To study the colligative properties

Q: In what pressure range and in what temperature range must H2O exist in order for H2O1s2 to sublime…

A: The conversion of a solid directly into gas is called as sublimation. For example: Camphor and solid…

Q: A polynomial fit to measurements of the total volume of a binary mixture of A and B isv = 987.93 +…

A: Given: The equation, v=987.93+35.6774x−0.45923x2+0.017325x3 where, v=V/cm3 x=nB/mol nB=the amount of…

Q: In a closed, insulated system, the vapour pressure of water at 15.37 °C is 2687 Pa. What percentage…

A: The force per unit area by atmospheric column is equivalent to atmospheric pressure. It is also…

Q: Calculate the molar concentration of the polycyclic aromatic hydrocarbon (PAH), anthracene (178.23…

A: Given: Concentration of well water sample = 2.18 ppb Density of well water sample =1.00 g/mL To…

Q: The energy of the vacancy formation in the Ge crystal is about 2.0 eV/atom. Calculate the fractional…

Q: Determine the final concentration in mol dm–3 of K+ and SO42– when the following three solutions in…

A: Their are three volumetric flask of volume 500cm3 contain 0.20 mol/dm3 KAl(SO4)2 and second flask of…

Q: Estimate the vapour pressure of sea water at 20 °C given that the vapour pressure of pure water is…

Q: By how much does the chemical potential of carbon dioxide at 310 K and 2.0 bar differ from its…

Q: How do I estimate the mean ionic activity coefficient of a 0.00125 mol/kg CuBr2 at 25°C and how do I…

A: Welcome to bartleby ! Introduction : We have to calculate mean ionic activity coefficient .

Q: Suppose that in a phase diagram, when the sample was prepared with the mole fraction of component A…

A: The lever rule can be defined as a rule which is used for the determination of the mole fraction of…

Q: Suppose that in a phase diagram, when the sample was prepared with the mole fraction of component A…

A: The lever rule can be defined as a rule which is used for the determination of the mole fraction of…

Q: What is the vapor composition of an equal molar mixture of acetone (Pvap = 285 mmHg @ 30 °C) and…

A: Given, The vapor composition of an equal molar mixture of acetone (Pvap = 285 mmHg at 30 °C) and…

Q: What would be the vapor pressure for a mixture of 15 mL of benzene (f.w. = 78.1 g/mol, d=0.878 g/mL,…

A: The vapor pressure of the mixture can be obtained by the summation of partial pressure due to each…

Q: The following temperature-composition data were obtained for a mixture of octane (O) and…

A: In the given question, temperature-composition data for a mixture of octane (O) and methylbenzene…

Q: The limiting molar conductivities of KF, KCH3CO2, and Mg(CH3CO2)2 are 12.89 mS m2 mol−1, 11.44 mS m2…

Q: Calculate the difference in slope of the chemical potential against pressure on either side of (a)…

A: a) To calculate the difference in slope of the chemical potential against pressure on either side of…

Q: At 90 °C the vapour pressure of 1,2-dimethylbenzene is 20 kPa and that of 1,3-dimethylbenzene is 18…

A: Raoult's Law of Partial Pressure : This law states that the partial pressure of any volatile…

Q: What is the change in chemical potential of glucose when its concentration in water at 20.0 °c is…

A: Chemical Potential : It tells about the ability of a molecule to perform work. Chemical Potential…

Q: The H2 produced in a chemical reaction is collected through water in a eudiometer. If the pressure…

A: Total pressure in audiometer = 101.3kPa Vapour pressure of water = 2.34kPa H2 gas is collected…

Q: The distribution constant (K) is the main criterion for dividing the species of a sample between two…

A: Here we have to say on what factor distribution constant depend on-

Q: Why are there two separate H2O exchange rates observed for [Cu(H 2 O)6]^ 2+ in aqueous solution ?…

A: Two separate H2O exchange rates are due to Jahn Teller Distortions.

Question

Bromine vapour in the atmosphere can cause irritation to the eyes at a
concentration of 1.1 ppm and to the lungs at a concentration of 10 ppm.
() State the meaning of ppm.
(ii) A sample of 3.25 cm' of bromine vapour leaks into a laboratory.
Calculate the minimum volume, in dm', of the laboratory for the resulting
concentration of bromine to be at a safe level.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1: Meaning of ppm

VIEW

Step 2

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Molecular Motion in Electrolyte Solutions

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, chemistry and related others by exploring similar questions and additional content below.

Similar questions

What partial pressure of hydrogen results in a molar concentration of 1.0 mmol dm-3 in water at 25 °c?
Glucose from molasses is fermented to alcohol using S. cerevisiae where 500 ml of CO2 (at standard temperature and pressure) is produced. If the volume of the fermentation medium is 500 ml, what is the concentration of ethanol in g/ml?
The vaporization of water is one factor that contributes to the raising of baked goods. When 1.0g of water is vapourized inside a cake at 150c and 105kPa what volume in L of vapour is produced?
The maximum solid solubility of carbon in ferrite occurs at 0.022 wt% C and 727 ° C, the eutectoid composition is 0.76 wt% C, the maximum solid solubility of carbon in austenite occurs at 2.14 wt% C and 1147 ° C, and the cementite composition is 6.7 wt% C. For 2122 g of a 3.2134 wt% C steel at 726 ° C, what will be the mass of carbon present as part of a compound?(a) 67.9 g(b) 74.2 g(c) 58.7 g(d) 83.5 g
How many mole of chromium are present in 845,25kg Cr2O3, calculate the mass fraction
The partial pressure of water vapour at 30.0 °C is 4.25 kPa. What is the maximum mass of water that can be present in vapour form in a 243 m3 room at the indicated temperature?
The vapour pressures of benzene and methylbenzene at 20 °C are 75 Torr and 21 Torr, respectively. What is the composition of the vapour in equilibrium with a mixture in which the mole fraction of benzene is 0.75?
The osmolarity of physiological saline solution is 0.300 osmol/L. Assuming a membrane that is permeable only to water, what % (w/v) chromium(II) nitrate, Cr(NO3)2, solution is isotonic to physiological saline?
In the following balanced reaction: 2Al(s) + 6HCl(aq) → 2AlCl3(s) + 3H2(g) 2.32 g of Al react with excess HCl to produce hydrogen gas which is passed through water and collected at 25oC and a barometric pressure of 7.40 x 102 Torr. The vapour pressure of water at 25oC is 23.770 Torr. Calculate the minimum amount of HCl (in mol) required to completely react with Al.
The vapor pressures of two volatile organic compounds, compound 1 and compound 2, at 20 °C are 79.2 torr and 194.7 torr, respectively. What is the gas phase mole fraction of compound 2 above a solution containing an equimolar mixture of the two compounds?Please enter your response in standard notation to three significant figures.
20.7 cm3 of a pure vapour, at 1.136 atm, and 98.3 °C has a mass of 0.0603 g.Calculate the molar mass of the substance.
The average concentration of chloride ion in seawater is 19.353g Cl-/kg. The world health organization recommends that the concentration of Cl- ions in drinking water not exceed 250ppm. How many times as much chloride ion is there in seawater than in maximum concentration allowed in drinking water?