If Giorno Giovanna measured the mass of a product in order to calculate the amount of analyte present in the sample, what type of analytical method did he use? Volumetric method Gravimetric method Electroanalytical method Spectroscopic method

If Giorno Giovanna measured the mass of a product in order to calculate the amount of analyte present in the sample, what type of analytical method did he use? Volumetric method Gravimetric method Electroanalytical method Spectroscopic method

Chemistry & Chemical Reactivity

10th Edition

ISBN:9781337399074

Author:John C. Kotz, Paul M. Treichel, John Townsend, David Treichel

Publisher:John C. Kotz, Paul M. Treichel, John Townsend, David Treichel

Chapter11: Intermolecular Forces And Liquids

Section11.6: Properties Of Liquids

Problem 1.2ACP

See similar textbooks

Related questions

Q: 3. Rank the following in order by the rate in which they could participate in an SN1 reaction ("1" b...

A: An SN1 reaction is proceed by the formation of a carbocation (an ion that contains a positive charge...

Q: The concentration (M) of an aqueous methanol produced when 0.200 L of a 2.00 M solution was diluted ...

A: Given, Volume of concentrated solution = 0.200 L Strength of concentrated solution = 2.00 M Volume o...

Q: 1. Which of the following pairs of substances in the liquid state, would have greater vapor pressure...

Q: atom ratio between C and H in C2H5OH? O 1/5 O 2/1 O 2/6 O 2/5

A: Given molecule ethanol (C2H5OH)

Q: What is the major product of the following reaction? HCI III IV.

Q: 1pentanol + NaBr/H2SO4 -> 1-bromopentane Limiting reagent: 1-Pentanol Percent Yield: 64.5% The ty...

Q: Consider the cell reaction: Determine the following a. Balanced oxidation half-reaction b. Balanced...

A: Oxidation means loss of electrons and reduction means gain of electrons.

Q: Be sure to answer all parts. Use the data in the following table to determine the activation energy ...

Q: E2C.8(b) Estimate AH®(750 K) for the reaction N,(g) + H,(g) → NH,(g) from the listed value of the st...

Q: type: name: type: name:

A: According to the question, we need to determine the name and type of the molecules. (A) ((NH4)2)O...

Q: A 0.18-M solution of a weak acid is 2.4% dissociated. Calculate K.. K.

Q: XPERIMENTAL DATA he initial concentrations of SCN after dilution were calculated as part of the Prel...

A: Answer is attached below

Q: True or False. Write the word “reducing” if the statement is correct, otherwise write “non-reducing”...

Q: 1. NaCN, HCN (а) 2. HСІ, Н20, Нeat

Q: What type of solid is white phosphorus, P4? Group of answer choices ionic molecular metallic network...

A: In white phosphorus molecules 6 P-P Sigma bond present and four lone pair electron present. Angle ...

Q: 2. Draw and label a reaction energy diagram for the following reaction: NO + CO Things to label in d...

A: The progress of a reaction can be represented by the reaction energy diagram. In a reaction energy d...

Q: subscripts must be conserved. When one coefficient is doubled, the rest of the coefficients in the b...

A: Balanced chemical equation is that equation in which number of atoms on right hand side and left han...

Q: The balanced reaction for the combustion of ethane is shown in the table. You allow 3.2 mol of ethan...

Q: Given the chemical equation: 2H₂ + O₂ → 2H₂O, how many moles of H₂O is produced to balance the equat...

A: When hydrogen (H2) gas burns in oxygen (O2) water(H2O) is produced.

Q: -OH Age O Ci

A: The product is as follows:

Q: A chemist measures the enthalpy change AH during the following reaction: H,O(1)→H,O(9) AH=44. kJ Use...

Q: To determine the concentration of these analyte ions in a mixture, the mixture absorbance is analyze...

A: This is application of the Lambert beer law . Here we are required the molar concentration of X3+ an...

Q: ct the product f

Q: Give the number of peaks expected in the 'H NMR for the indicated protons in each of the following s...

A: Spin multiplicity =2nI+1 where n=no of hydrogen and I=nuclear spin ,for hydrogen nuclear spin...

Q: What is the hybrid orbital of each of the following molecules or ions? Briefly explain your answer. ...

A: Since you have posted a question with multiple sub-parts, we will solve first three sub-parts for yo...

Q: 2.050g of an unknown sample contains H, S, and O. If the compound contains 0.0500 g H and 0.800 g of...

A: The mass of the unknown compound is = 2.050 g The mass of hydrogen in this compound is = 0.0500 g Th...

Q: What is Ka for the conjugate acid of NH₃ (Kb = 1.8 × 10⁻⁵)?

Q: A compound that is composed of only carbon and hydrogen contains 85.7% C and 14.3% H by mass. What i...

Q: CH3CH2NH2 (с) 2 eq CH3CH2OH (d) H30* (е) -CH2-CH2-C-H КKMnOд, cold dilute

A: The given reactions are some of the well established reactions exhibited by carbonyl functionality.

Q: What is the mass of 4.63 x 1012 atoms of Fe? O 8.96 x 10-10 g O 4.29 x 10-10 g O 2.73x 10-10g O 1.62...

Q: Use a Fischer projection to describe the stereochemistry of (R)-2-dhkorobutane by dragging the funct...

Q: Which of the following compounds are oxidizers and which ones are reducing agents (Hint: oxidizing c...

A: Oxidising Agent- The reagent which is used for removed of hydrogen Or addition of oxygen. Reducing ...

Q: A certain reaction has an equilibrium constant of 10.1 at 25oC. A ⇄ B Determine its ΔG, in kJ/mol,...

Q: Given the chemical equation: B₂H₆ + 6H₂O → 2H₃BO₃ + 6H₂, how grams of water is 30 mole of hydrogen?

A: According to the given chemical reaction, 6 moles of H2 is given by 6 moles of H₂O. 1 mole of H2 is ...

Q: Consider two containers of H2 and CO2 at the indicated temperature, pressure, and volume: H2 CO2 T =...

Q: A. What is the principle behind the assay?

Q: 21.33 g of an ideal gas in a 2L container at 300K has a pressure of 2 atm What is the identity of th...

Q: Consider again the equilibrium: H2 (g) + I2 (s) → 2HI (g) This reaction is endothermic (absorbs heat...

Q: Compare and contrast the bonding present in each of the following: O2, CO, and MgO. Identify the typ...

Q: when the following equation is balanced using the smallest possible integers, what is the number in ...

A: Balanced chemical equation is that in which numbers of atoms on left hand side and right hand side a...

Q: What is the order of a reaction where each successive half life gets shorter and is dependent upon i...

A: ★ Answer : Zero order

Q: CI OH Agz O

A: The product would be:

Q: Which of the following statements are true with regards to a supersaturated solution? W) it contain...

A: A solution is a homogeneous mixture which contains solute (less quantity) dissolved in the solvent( ...

Q: A chemist added 40 ml of pure acetic acid to 100ml of 20% v/v solution of acetic acid in water. What...

Q: amount

A: Since you have asked multiple questions, we will solve the first question for you. If you want any s...

Q: 3. Assuming that C and N have similar electronégativities raw the mueular orbital diagrams for CN an...

A: As C and N have similar electronegativity, then there atomic orbitals will remain at same energy lev...

Q: At a certain temperature the rate of this reaction is first order in NH, with a rate constant of 5.3...

A: Order of reaction = 1 Rate Constant, k = 5.31 s-1

Q: A liquid and a solid of the same substance coexist in a flask as shown in the diagram below. The sys...

A: A question based on matter that is to be accomplished.

Q: What is the expected product of the reaction shown? HBr он Br Br II Br IV O II O IV O none of these

Q: 1. To determine the potassium content of a sample, 1.275 g of the sample was dissolved in water and ...

Question

If Giorno Giovanna measured the mass of a product in order to calculate the amount of analyte present in the sample, what type of analytical method did he use?

Volumetric method
Gravimetric method
Electroanalytical method
Spectroscopic method

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, chemistry and related others by exploring similar questions and additional content below.

Similar questions

If Giorno Giovanna measured the mass of a product in order to calculate the amount of analyte present in the sample, what type of analytical method did he use? a.Gravimetric method b.Electroanalytical method c.Spectroscopic method d.Volumetric method
If Jotaro Kujo measured the amount of current that passes through a sample to measure the amount of analyte in the sample, what kind of method did he use? c.Volumetric method b.Electroanalytical method c.Gravimetric method d.Spectroscopic method
Convert the amount of spiperone in each sample to the concentration in the 1 ml total volume of assay tube. Express this concemtration in molar in standard form.
Explain the use of plans and their importance in assessing the quality of pharmaceutical products. Provide a step-by-step design of a sampling plan based on a normal inspection for a 75,000 tablets with an AQL of 0.12% using the attached table (at the end of exam paper).
The following 2-step experiment was conducted as shown in the image provided. Given that: MrH = 1 g/mol; MrC = 12 g/mol; MrN = 14 g/mol; MrO = 16 g/mol; MrCl = 35 g/mol. The following volumes of reagents were used: A = 7.5 ml (Density = 1.33 g/cm3)B = 10.0 ml (Density = 1.06 g/cm3)C = 10.0 ml ( Density = 0.99 g/cm3)E = 7.0 ml (Density = 1.51 g/cm3) Question: Calculate the limiting reagent (show all calculations).
The spay used to develop the chromatogram is a solution of Group of answer choices a.) Ferrocyanide, ammonia, and iodide b.) Ammonia c.) Potassium permanganate d.) Potassium ferrocyanide
Assuming all other values are accurate, what would happen to the experimental value of Rif the Mg was not completely consumed? R=PV/nT
A student dissolves a Jefferson nickel to make 100.00 mL of solution in a volumetric flask. The student takes a 5.00 mL5.00 mL aliquot of the first solution and dilutes it to make 100.00 mL100.00 mL of a second solution. The student places a sample of the second solution in a cuvette for analysis using spectrophotometry. The molarity of the copper solution in the cuvette was determined by spectrophotometric analysis to be 2.90×10−2 M Cu.2.90×10−2 M Cu. Calculate the mass of copper in the Jefferson nickel used to make the first solution.
Use the following information and data to answer the next a through c questions. A student is performing a paper chromatography experiment. He spots two sample compounds (compound A and compound B) on the origin line at the bottom of his paper. He then places the paper into a beaker with a centimeter or so of liquid solvent and allows it to develop until the solvent front is near the top of the paper. Compound A eluted 8.23 cm up the paper. Compound B eluted 4.77 cm up the paper. The solvent front (distance solvent eluted) was measured at 10.46 cm from the origin. Part a) In the above experiment what component of the system is referred to as the stationary phase? a) the solvent b) the samples c) the paper d) none of the above Part b) Why is a pencil and not a pen used to draw the origin line upon which the samples are placed during the experiment? a) Pencil marks are more visible after the chromatogram has dried. b) Ink will react with the metal ions in the samples. c) Pencil marks…
In the determination of the concentration of chloride ion in water five experiments were done: 254.3 ppm, 254.7 ppm, 249.9 ppm, 252.5 ppm, and 253.4 ppm. What is the relative average deviation of this experiment? (ppm=mg/L
You have finished two trials of the sample analysis for the experiment and you noticed that the burette is almost empty (~5 mL remaining). Should you add more titrant before the next sample analysis or not? Why or why not? Select one: YES. It will not affect the calculations and not cause error NO. It will affect the calculations and cause error Neither A nor B Cannot be determined
Use the following information and data to answer the question. A student is performing a paper chromatography experiment. He spots two sample compounds (compound A and compound B) on the origin line at the bottom of his paper. He then places the paper into a beaker with a centimeter or so of liquid solvent and allows it to develop until the solvent front is near the top of the paper. Compound A eluted 8.23 cm up the paper. Compound B eluted 4.77 cm up the paper. The solvent front (distance solvent eluted) was measured at 10.46 cm from the origin. In terms of the properties of the two samples (A and B) it can be said: a) sample A has the highest affinity for the paper b) sample B has the highest affinity for the paper c) the affinities of the samples are the same d) sample B has the lowest affinity for the paper