II Review I Constants I Periodic Table Part C Many gases are shipped in high-pressure containers. Consider a steel tank whose volume is 55.0 gallons and which contains O2 gas at a pressure of 16,500 kPa at 25 °C. At what temperature would the pressure in the tank equal 160.0 atm? Express the answer in atmospheres to three significant figures. ΑΣφ ? T = K Submit Request Answer Part D What would be the pressure of the gas, in kPa, if it were transferred to a container at 24 °C whose volume is 55.0 L? Express the answer in kilopascals to three significant figures.

II Review I Constants I Periodic Table Part C Many gases are shipped in high-pressure containers. Consider a steel tank whose volume is 55.0 gallons and which contains O2 gas at a pressure of 16,500 kPa at 25 °C. At what temperature would the pressure in the tank equal 160.0 atm? Express the answer in atmospheres to three significant figures. ΑΣφ ? T = K Submit Request Answer Part D What would be the pressure of the gas, in kPa, if it were transferred to a container at 24 °C whose volume is 55.0 L? Express the answer in kilopascals to three significant figures.

Introductory Chemistry: An Active Learning Approach

6th Edition

ISBN:9781305079250

Author:Mark S. Cracolice, Ed Peters

Publisher:Mark S. Cracolice, Ed Peters

Chapter4: Introduction To Gases

Section: Chapter Questions

Problem 67E: The compression ratio in an automobile engine is the ratio of the gas pressure at the end of the...

See similar textbooks

Similar questions

Methane (CH4) gas flows into a combustion chamber at a rate of 200. L/min at 1.50 atm and ambient temperature. Air is added to the chamber at 1.00 atm and the same temperature, and the gases are ignited. a. To ensure complete combustion of CH4 to CO2(g) and H2O(g), three times as much oxygen as is necessary is reacted. Assuming air is 21 mole percent O2 and 79 mole percent N2, calculate the flow rate of air necessary to deliver the required amount of oxygen. b. Under the conditions in part a, combustion of methane was not complete as a mixture of CO2(g) and CO(g) was produced. It was determined that 95.0% of the carbon in the exhaust gas was present in CO2. The remainder was present as carbon in CO. Calculate the composition of the exhaust gas in terms of mole fraction of CO, CO2, O2, N2, and H2O. Assume CH4 is completely reacted and N2 is unreacted.
The gas in the discharge cell of a laser contains (in mole percent) 11% CO2, 5.3% N2, and 84% He. (a) What is the molar mass of this mixture? (b) Calculate the density of this gas mixture at 32C and 758 mm Hg. (c) What is the ratio of the density of this gas to that of air (MM=29.0g/mol)at the same conditions?
5-54 Automobile air bags are inflated by nitrogen gas. When a significant collision occurs, an electronic sensor triggers the decomposition of sodium azide to form nitrogen gas and sodium metal. The nitrogen gas then inflates nylon bags, which protect the driver and front-seat passenger from impact with the dashboard and windshield. What volume of nitrogen gas measured at 1 atm and 27°C is formed by the decomposition of 100. g of sodium azide?
The compression ratio in an automobile engine is the ratio of the gas pressure at the end of the compression stroke to the pressure in the beginning. Assume that compression occurs at constant temperature. The total volume of the cylinder in an automobile is 350 cm3, and the displacement the reduction in volume during the compression stroke is 309 cm3. What is the compression ratio in that engine?
49 mL of a gas are collected over water at 748 mm Hg and 298 K. If the vapor pressure of water at that temperature is 29 mm Hg, how many moles of the gas generated from the reaction were collected? (Express your answer using exponential notation (ex. 1.23e-3, or 1.23e3) to 3 significant figures, and don't round any calculations along the way!) moles
In your combustion of butane at 105 kPa and 292 K 2 C4H10 (g) + 13O2 (g) ---> 10 H2O (g) + 8CO2 (g) What volume of carbon dioxide would be produced from 350 grams of oxygen and 6.0 litres of butane? Select final answer from the following options: - 3.0 L - 24 L - 156 L - None of the above
A gas of pure N2i s confined to a cylinder with a movable piston at one end. The initial pressure of gas is 1.2 x 105 N/m2, the initial volume is 1.0 x 10-3m3, and the initaltemperature is 30oC. (a) How many moles of the gas are in the container? If the piston is compressed so that the pressure is increased to 4.20 x 105 N/m2 and volume is decreased to 5.10 x 10-4m3, what is the new temperature of the gas?
The ideal gas law is a limiting law, in that it is expected to hold as pressure approaches zero. Suppose the following measured values have been obtained for oxygen gas at 273.15K. Based on the data, calculate R for each pressure value and create a table of pressure and R values (i.e. you are treating R as a variable rather than a constant at this point). Then create a plot R vs p and find the “best value” of R by determining the y-intercept of a straight line fit. (Be sure to label your axes including units).
P1A.6 The molar mass of a newly synthesized fluorocarbon was measured in a gas microbalance. is device consists of a glass bulb forming one end of a beam, the whole surrounded by a closed container. e beam is pivoted, and the balance point is attained by raising the pressure of gas in the container, so increasing the buoyancy of the enclosed bulb. In one experiment, the balance point was reached when the fluorocarbon pressure was 327.10Torr; for the same setting of the pivot, a balance was reached when CHF3 (M = 70.014 g mol−1) was introduced at 423.22 Torr. A repeat of the experiment with a di erent setting of the pivot required a pressure of 293.22 Torr of the uorocarbon and 427.22 Torr of the CHF3. What is the molar mass of the fluorocarbon? Suggest a molecular formula.
Chemistry 1. 150 Liter/min of gas (carbon monoxide) is emitted from a process at T= 45°C and P=1.05 atm. Calculate the mass flow rate of carbon monoxide if the gas stream contains 40 ppmv CO 2. What is the volume occupied by one mole of propane (C3H8) at STP? [b] The propane is burned in dry air and under stoichiometric conditions. An exhausted gas is formed, cooled, and captured. What volume of exhaust gas is produced by one mole of exhaust gas at STP? [c] What volume of exhaust gas is produced under stoichiometric conditions?
10 mol of NH3 (g) were placed in a previously evacuated 20-L container. After a sudden temperature rise to 961.4 K, 80% of ammonia dissociated into hydrogen and nitrogen according to the reaction: 2/3 NH3 (g) --> 1/3 N2 (g) + H2 (g) What is the total pressure of the mixture if all gases are ideal? (Answer in sig figs)
The volume V of an ideal gas variesdirectly with the temperature T and inversely with the pressureP. Write an equation relating V, T, and P using k as theconstant of proportionality. If a cylinder contains oxygen at atemperature of 300 K and a pressure of 15 atmospheres in avolume of 100 liters, what is the constant of proportionality k?If a piston is lowered into the cylinder, decreasing thevolume occupied by the gas to 80 liters and raising thetemperature to 310 K, what is the gas pressure?