In a hot air balloon launch, it was known that the material used in the construction amounts to 200kg and that the loading capacity of the cage was 250kg. If the hot air balloon has to travel in air where the ambient temperature and pressure was 25°C and 101.325kPaa, determine the minimum diameter (meters) of the balloon (assume to be spherical) needed to course the air if the setting temperature of hot air inside the balloons is 80°C. Assume pressure inside the balloon to be atmospheric. Draw a figure or FBD that will support the problem. Explain each step by step formula

Q: When the tire temperature is 30 degrees Celsius, the gage pressure reading on a vehicle tire is 240…

A:

Q: A Newtonian fluid is in the clearance between a shaft and a concentric sleeve. When a force of 600 N…

A: Concept of newtons law fluid used

Q: piston fits inside a 30-cm-diameter vertical pipe and is pulled up to a height of 6.1 m. The pipe's…

A:

Q: A walnut with a mass of 50 g requires a force of 200 N applied continuously for 0.002 s to be…

A: Write the expression of the force applied.

Q: Example 3 The drag coefficient of a car increases when the sunroof is open, and it requires more…

A:

Q: Two plates are placed at a distance of 15 mm apart. The lower plate is fixed while the upper plate…

A:

Q: EX: A system consisting of a stone of mass 10 (kg) and a container containing water. The stone was…

A: Given that, Mass of stone, m=10 kg,Height of stone above the surface of water, h=2 m,   1) At state…

Q: The initial volume of air is 100L in a cylinder fitted with a piston at a pressure of 150 kPa and a…

A:

Q: A compressed air tank is designed to contain 50 standard cubic feet of air when filled to a gauge…

A: Given data Interior volume of the tank = 0.253 ft3 Interior length of cylinder = 1 ft We have to…

Q: he extrusion die for a polyethylene parison used in blow molding has a mean diameter of 20 mm. The…

A: Given data: Dp=22 mmDd=20 mmtd=1.5 mmDm=160 mm Need to determine the wall thickness of the container…

Q: fan is used to force air having a temperature of  20°C through the 200-mm diameter galvanized sheet…

A:

Q: he clear plastic bottles used for carbonated beverages (sometimes also called “soda,” “pop,” or…

A: Given Inside pressure = 570 kPa Outside pressure = 7 kPa Permeability Constant bottle = 0.23 x 10-13…

Q: One of the common procedures in fitness programs is to determine the fat-to-muscle ratio of the…

A: Given Data: The density of the muscle part of the body is ρmuscle. The volume fraction of the body…

Q: 18 m (Another review problem) A helicopter of mass 10,000 kg hovers at sea level while carrying a…

A: Solution: Let F be the force which is impacting due to reaction of the air which blades forced due…

Q: A solid block slides at an incline of 15 with a surface coating of oil of 3 millimeters thick. With…

A: Given, Angle of inclination = θ = 15o Thickness of oil coating = h = 3 mm = 0.003 m Surface area in…

Q: Figure 1 shows a box of mass m that is supported on a surface inclined at angle 0 to the horizontal.…

A:

Q: On a very cold day at the South Pole, the temperature of air is –60oF. Assuming that the air remains…

A:

Q: (b) A 10-kg block is pulled up on a smooth inclined surface by force F as shown in Figure Q1 (b).…

A:

Q: The 500 kg load on the hydraulic lift is to be raised by pouring oil (p = 780 kg/m^3) into a thin…

A: for the given system    the density of oil (ρ) = 780 kg/m3 mass of load (m) = 500 kg   To determine…

Q: 1.25 A vertical clean glass tube of uniform bore is to be used as a piezometer for measuring…

A:

Q: value of the pressure coefficient for an airplane flying at 170m/s in air at 2

A:

Q: A compressed air tank is designed to contain 50 standard cubic feet of air when Ölled to a gauge…

A: INTRODUCTION:  The volume occupied by the gas will be equal to the volume of the tank when the tank…

Q: The shear stresses in the fluid flow are caused by     Pressure     Temperature     Friction…

A: Friction is the correct answer.

Q: A wooden barge of rectangular cross-section is 8 m wide, 4 m high, and 16 m long. It is transporting…

A:

Q: Q5/B) bulk temperature increase over a 3-m length of the tube? Take rt 023 Re0.8 Prn

A:

Q: 3- Assuming that the velocity distribution in the laminar boundary layer: U sin 28 Determine the…

A:

Q: The power generated by a wind turbine is proportional to the cube of the wind velocity. Inspired by…

A: Solution:

Q: A hydraulic lift is to be used to lift a 2500 kg weight by putting a weight of 25 kg on a piston…

A: Given Data  Lift weight is 2500Kg weight on piston = 25Kg Diameter of piston is D1 = 10cm Diameter…

Q: Question 1: The plate in side Figure rests on top of the thin film of water, which is at a…

A:

Q: A mountain climbers observed that the pressure on top of the mountain is 500 mm Hg. At the same time…

A:

Q: A water well is 9.5 meters deep. If an air bubble from the bottom of the water well rises slowly to…

A:

Q: A spherical container fitted with a stirrer traps air with a volume equal to 5 cubic meters. The…

A: Since there is no heat transfer in/out of the system on the process, thus the process is adiabatic…

Q: The clear plastic bottles used for carbonated beverages (sometimes also called “soda,” “pop,” or…

A: To Find : The shelf life in days for a bottle of pop . Given :  The 20-oz bottle of pop has a CO2…

Q: 1. If the specific gravity of a given liquid is 1.3, determine its (a) specific weight (b) specific…

A:

Q: 1.The density P Determine how the density varies with pressure along the depth h. The density at the…

A: As per our guidelines, experts can provide solution to only one problem in case of multiple…

Q: A. Check whether the lumped system analysis is suitable. B. Determine the temperature of the copper…

A: For solution refer below images.

Q: surface temperature (in K) of the rod is

A: Given; A cylindrical uranium fuel rod;  radius=5 mm  heat genration rate =4×107W/m3  Heat transfer…

Q: he area of the inner cross section of a horizontal tube (fixed) is A, while the area of cross…

A:

Q: Nutrients dissolved in water are carried to upper parts of plants by tiny tubes partly because of…

A: To solve this problem for calculating the value of height of water solution rise, we have used…

Q: Air is flowing parallel to the plate at U∞=5 m/s and T∞=300 K over the flat plate of length L=0.1 m…

A: Given data: The velocity of the air is U∞ = 5 m/s. The temperature of the air is T = 300 K. The…

Q: A cylinder glass tubing is 4.4ft long with one end closed and is immersed vertically with the open…

A: Given Data Length of glass tube is :L=4.4 ft=52.8 in Specific gravity is :S.G=0.83 Atmospheric…

Q: d determine: a) The drag force acting on the plate. b) The rate of heat loss from the plate.

A:

Q: Air bubble from the bottom of the water well, 9.5 meters' deep rises slowly to the Water surface…

A:

Q: Oxygen supply for a lung related deficiency is supplied to patients from bottled oxygen in gaseous…

A:

Q: Problem 1: The difference in mercury level of a pitot static tube connected to a submarine is 20 cm.…

A: Given:

Q: A rectangular duct whose cross sectional area has a width of 6m and a height of 3.5m is used to…

A: Width, b= 6 m Height, h= 3.5 m   To find: Equivalent diameter of the duct, d

Q: A tank of 10ft3 capacity is half filled with glycerin. The weight density of glycerin is 78.6…

A: