In a whole-cell patch-clamp experiment at 32 degrees C, the intracellular solution contains 16 mM NaCl, 150 mM K-gluconate, and 1µM Ca(NO3)2, and the extracellular solution contains 150 mM NaCl, 3 mM KCI, 25 mM NaHCO3, 2 mM MgCl2, and 1.5 mM CaCl2. The below graph is a current-voltage (I-V) curve generated by measuring the current fluy thrOUgh a spocific jon chappel over

In a whole-cell patch-clamp experiment at 32 degrees C, the intracellular solution contains 16 mM NaCl, 150 mM K-gluconate, and 1µM Ca(NO3)2, and the extracellular solution contains 150 mM NaCl, 3 mM KCI, 25 mM NaHCO3, 2 mM MgCl2, and 1.5 mM CaCl2. The below graph is a current-voltage (I-V) curve generated by measuring the current fluy thrOUgh a spocific jon chappel over

Fundamentals Of Analytical Chemistry

9th Edition

ISBN:9781285640686

Author:Skoog

Publisher:Skoog

Chapter22: Bulk Electrolysis: Electrogravimetry And Coulometry

Section: Chapter Questions

Problem 22.28QAP

See similar textbooks

Similar questions

A 0.2g sample of toothpaste containing fluoride was treated with 50 cm3 of a suitable buffer solution and diluted to 100 cm3. Using a fluoride ion-selective electrode, a 25.00 cm3 aliquot of this solution gave cell potentials of –155.3 mV before and –176.2 mV after spiking with 0.1 cm3 of a 0.5 mg/cm3 fluoride standard. Calculate the pF– corresponding to each cell potential and the percentage by weight of fluoride in the toothpaste.
When measured with a F− ion-selective electrode with a Nernstian response at 25°C, the potential due to F− in unfluoridated groundwater in a nearby city was 40.7 mV more positive than the potential of tap water in a distant city. The distant city maintains its fluoridated water at the recommended level of 1.00 ± 0.05 mg F−/L. What is the concentration of F− in mg/L in groundwater in the nearby city? (Disregard the uncertainty. Assume that the Nernst potential is 0.05916 V.)
An ion selective electrode is utilised to determine the concentration of Ca2+ in the presence of Mg2+. The selectivity coefficient for the electrode kij is 0.015. If the concentrations of Ca2+ and Mg2+ are 50 and 500 ppm, respectively, calculate the change in potential (in mV) when the temperature of the measurement cell is increased from 20oC to 40oC.
Create a calibration curve. Electrode potential (mV) vs. log [Ca2+]. (complete with, the equations of the best fit line, and the correlation coefficient) log[Ca 2+] Electrode potential (mV) -5 -105.4 -105.1 -106.5 -6 -120.9 -120.3 -120.6 -4.4 -96.6 -97.2 -96.5 -4 -85.5 -85.8 -85.2 -3 -56.6 -56.2 -56.4 -2 -26.6 -27.1 -27.1
1. IOn selective electrode utilizing pCO2 is used fro the measurement of the electrolyte a. Phoisphate b. bicarbonate c. Magnesium d. chloride e. sodium 2. The confirmatory method for the measurement of Calcium and Magnesium A. Turbidimetry b. FES c. none d. colorimtery e. AAS 3. the electrolyte is found as component of phospholipids, nucleic acids, creative phosphate and ATP a. magnesium b. calcium c. phosphate d. bicarbonate e. chloride
A bare silver wire electrode is dipped into a solution 0.05M in KNO3 (supporting electrolyte) and saturated in AgBr (Ksp = 5.0 x 10-13), and connected to the back of an mV/pH meter along with a saturated calomel reference electrode. Calculate the potential of the silver indicator electrode. Calculate the cell potential.
The following data were obtained with a cadmium-selective solid-state electrode. The ionic strength of each solution was 0.30 M, and the reference electrode was a saturated calomel electrode. Determine the concentration of the unknown cadmium ion in the sample. [Cd2+], M 1.00x10-1 8.75x10-3 1.00x10-3 3.16x10-5 3.16x10-6 Unknown E, V -0.115 -0.150 -0.175 -0.213 -0.242 -0.200
2) Name the advantages of glass electrode in potentiometric measurements (please write correctly and concisely).
By employing a given conductivity cell with 0.1N potassium chloride at 18pC, an observed conductance of 0.025 mho was obtained. What is the cell constant if the specific conductance of KCL at 18°C is 0.0112 mho.
In a polarographic experiment of a 60 mL of 0.08 M Cu2+solution, a limitingcurrent was left on for 15 minutes. If the average current during the time of theexperiment is 6.0 μA, what fraction of the copper is removed from the solution? TheFaraday constant is 96485 C/mol of electron.
Given that ΔrG⦵ = −212.7 kJ mol−1 for the reaction Zn(s) + Cu2+(aq) → Zn2+(aq) + Cu(s) in the Daniell cell at 25 °C, and b (CuSO4) = 1.00 × 10−3 mol kg−1 and b (ZnSO4) = 3.00 × 10−3 mol kg−1, calculate (a) the ionic strengths of the solutions, (b) the mean ionic activity coefficients in the compartments, (c) the reaction quotient, (d) the standard cell potential, and (e) the cell potential. (Take γ+ = γ− = γ± in the respective compartments. Use the Debye–Hückel limiting law.)
An unknown cadmium(II) solution was analyzed polarographically by the method of standard additions. A 25.00-mL sample of the unknown solution produced a diffusion current of 1.86 mA. Following addition of a 5.00-mL aliquot of 2.12x10^23 M Cd2+ standard solution to the unknown solution, a diffusion current of 5.27 mA was produced. Calculate the concentration of Cd2+ in the unknown solution.