In the circuit below, consider that all capacitors are identical. Which one of the following circuits has an equivalentcapacitance that is different from the other four circuits?Case 14HPCase 4Case 2HHHHH4HPCase 5Case 3HAHO Case 3O Case 2O Case 1O Case 4O Case 5

in figure we can clearly seen that the in the circuit diagram case 1 is different from the other…

In the circuit below, consider that all capacitors are identical. Which one of the following circuits has an equivale capacitance that is different from the other four circuits? Case 1 4HP Case 4 Case 2 Case 5 4HP Case 3

In the circuit below, consider that all capacitors are identical. Which one of the following circuits has an equivale capacitance that is different from the other four circuits? Case 1 4HP Case 4 Case 2 Case 5 4HP Case 3

Principles of Physics: A Calculus-Based Text

5th Edition

ISBN:9781133104261

Author:Raymond A. Serway, John W. Jewett

Publisher:Raymond A. Serway, John W. Jewett

Chapter20: Electric Potential And Capacitance

Section: Chapter Questions

Problem 48P

See similar textbooks

Similar questions

Show that if two resistors R1and R2are combined and one is much greater than the other (R 1 >>R 2 ): (a) Their series resistance is very nearly equal to the greater resistance R 1. (b) Their parallel resistance is very nearly equal to smaller resistance R2.
Some camera flashes use flash tubes that requite a high voltage. They obtain a high voltage by charging capacitors in parallel and then internally changing the connections of the capacitors to place diem in series. Consider a circuit that uses four AAA batteries connected in series to charge six 10-mF capacitors through an equivalent resistance of 100 . The connections are thenswitched internally to place the capacitors in series. The capacitors discharge through a lamp with a resistance of 100 . (a) What is the RC time constant and the initialcurrent out of the batteries while they are connected in parallel? (b) How long does it take for the capacitors to charge to 90% of the terminal voltages of the batteries? (c) What is the RC time constant and the initial current of the capacitors connected in series assuming it discharges at 90% of full charge? (d) How long does it rake the current to decrease to 10% of the initial value?
Consider the circuit shown below. The terminal voltage of the battery is V = 18.00 V. (a) Find the equivalent resistance of the circuit, (b) Find the current through each resistor, (c) Find the potential drop across each resistor, (d) Find the power dissipated by each resistor, (e) Find the power supplied by the battery.
Calculate the power delivered to each resistor in the circuit shown in Figure P21.43. Figure P21.43
Consider the circuit shown below. The terminal voltages of the batteries are shown, (a) Find the equivalent resistance of the circuit and the current out of the battery, (b) Find the current through each resistor, (c) Find the potential drop across each resistor, (d) Find the power dissipated by each resistor, (e) Find the total power supplied by the batteries.
The rather simple circuit shown below is known as a voltage divider. The symbol consisting of three horizontal lines is represents “ground” and can be defined as the point where the potential is zero. The voltage divider is widely used in circuits and a single voltage source can be used to provide reduced voltage to a load resistor as shown in the second part of the figure, (a) What is the output voltage Vout of circuit (a) in terms of R1,R2,andVin (b) What is the output voltage Vout of circuit (b) in terms of R1,R2,RLandVin
When the current in the portion of the circuit shown in Figure P32.65 is 2.00 A anti increases at a rate of 0.500 A/s, the measured voltage is Vab = 9.00 V. When the current is 2.00 A and decreases at the rate of 0.500 A/s. the measured voltage is Vab = 5.00 V. Calculate the values of (a) I. and (b) R
When resistors with different resistances are connected in series, which of the following must be the same for each resistor? Choose all correct answers, (a) potential difference (b) current (c) power delivered (d) charge entering each resistor in a given lime interval (e) none of those answers
A battery with an internal resistance of 10.0 produces an open circuit voltage of 12.0 V. A variable load resistance with a range from 0 to 30.0 is connected across the battery. (Note: A battery has a resistance that depends on the condition of its chemicals and that increases as the battery ages. This internal resistance can be represented in a simple circuit diagram as a resistor in series with the battery.) (a) Graph the power dissipated in the load resistor as a function of the load resistance. (b) With your graph, demonstrate the following important theorem: The power delivered to a load is a maximum if the load resistance equals the internal resistance of the source.
When resistors with different resistances are connected in series, which of the following must be the same for each resistor? Choose all correct answers. (a) potential difference (b) current (c) power delivered (d) charge entering each resistor in a given time interval (e) none of those answers
In Figure P21.47, show how to add just enough ammeters to measure every different current. Show how to add just enough voltmeters to measure the potential difference across each resistor and across each battery.
Consider the circuit shown in Figure P18.11. Find (a) the potential difference between points a and b and (b) the current in the 20.0- resistor. Figure P18.11