In the molecular weight determination by the Dumas method, several grams of an organic liquid was drawn into a bulb. The bulb was then immersed in a water bath at 87 degrees C and kept there until all the liquid was vaporized and the air in the bulb was replaced by the vapor. The tip was then sealed shut and the bulb removed from the vapor was 36.127g; the weight of the empty (evacuated) bulb was 35.427g; the bulb’s volume was 200.0mL; room temperature was 25 degrees C, and the barometric pressure was 720 mm Hg. Calculate the molecular weight of the organic liquid. Calculate the molecular weight of the organic liquid.

In the molecular weight determination by the Dumas method, several grams of an organic liquid was drawn into a bulb. The bulb was then immersed in a water bath at 87 degrees C and kept there until all the liquid was vaporized and the air in the bulb was replaced by the vapor. The tip was then sealed shut and the bulb removed from the vapor was 36.127g; the weight of the empty (evacuated) bulb was 35.427g; the bulb’s volume was 200.0mL; room temperature was 25 degrees C, and the barometric pressure was 720 mm Hg. Calculate the molecular weight of the organic liquid. Calculate the molecular weight of the organic liquid.

EBK A SMALL SCALE APPROACH TO ORGANIC L

4th Edition

ISBN:9781305446021

Author:Lampman

Publisher:Lampman

Chapter13: Isolation Of Eugenol From Clov

Section: Chapter Questions

Problem 9Q

See similar textbooks

Similar questions

The procedure for the synthesis of menthone indicates that you should use 10 cm³ of 6M sulphuric acid. Suppose that only sulphuric acid with concentration 1.5M is available in the laboratory. What volume in cubic centimetres of this solution do you need to add to the reaction mixture to replace the solution originally specified? [Do not type in the unit. Round the answer to a whole number.] *
Volumetric analysis of the products of combustion of an unknown hydrocarbon, measured on a dry basis, gives 10.4% CO2 1.2% CO 2.8% O2, and 85.6% N2 Determine: a): the complete actual combustion equation, with coefficients of O2 and N2 separately in the reactants, b): the composition of the hydrocarbon and tell that whether such specie exists in nature. c): the percent theoretical air. Take oxygen in air as: 23.3% by mass and 21% by mole. NOTE: Do not solve this problem in tabulated form, otherwise your answer will be considered totally wrong.
A sample containing chlorophenol, C6H4ClOH, was analysed by gravimetric analysis. A 0.783-g of this sample goes through a chemical process allowing the chlorine in the chlorophenol to precipitate as silver chloride, weighing 0.271 g. Calculate the % (wt/wt) of the chlorophenol in the sample, assuming that chlorophenol is the only source of chlorine in the sample. Provide your answer to two decimal places and without units. Avoid using scientific notation.
Find the mass of hydrogen gas produced by the reaction of 4.0g Al with excess sulfuric acid by using dimensional analysis. 2Al+3H2SO4-> Al2(SO4)3 +3H2
The aluminum in a 1.200 g sample of impure ammonium aluminum sulfate was precipitated with aqueous ammonia as the hydrous Al(OH)3.xH2O. The precipitate was filtered and ignited at 10000C to give anhydrous Al2O3 which weighed 0.1798 g. Express the result of this analysis in terms of % Al2O3.
Suppose you reacted 0.500 g of Mg powder mixed with several acid-inactive substances and obtained 246 ml of hydrogen gas under S.T.P. conditions.What percentage by weight of the model is magnesium?
A concentration of toxic metals in plant tissue is often found by combusting the material in a furnace and then dissolving the ash in concentrated acid. A 0.5124-gram sample of leaves was combusted to ash and transferred to a 150-mL beaker. A 25-mL portion of concentrated HCl was added and the mixture was heated on a hot plate. Three 5-mL portions of concentration HCl were added over approximately 10 minutes with continued heating in between additions. The resulting mixture was cooled to room temperature and filtered into a 50-mL volumetric flask, which was brought to volume using distilled water and mixed well. From this stock solution, a 10-mL portion was pipetted into a clean 50-mL volumetric flask, brought to volume with distilled water, and mixed. This final solution was analyzed and found to contain 12.1 ppm lead. What are the mass percent of lead in the original plant tissue?
A core sample is saturated with an oil (?o = 35oAPI), gas and water. The initial weight of the sample is 224.14 g. After the gas is displaced by water (?w = 1 g/cm3 ), the weight is increased to 225.90 g. The sample is the placed in a Soxhlet distillation apparatus, and 4.4 cm3 water is extracted. After drying the core sample, the weight is now 209.75 g. The sample bulk volume, 95 cm3 is measured in a mercury pycnometer. Find the porosity, water saturation, oil saturation, gas saturation and lithology of the core sample.
Stock iron(II) solution (200Ug mL-1 Fe) ferrous ammonium sulfate hexahydrate mass= 0.1437g, transfer it to a 100 ml beaker. add 15 ml approx of water and 15m1 'approx of dilute sulphuric acid (2M H2SO.). then transfer FeII to 100 ml flask makeup to the mark with water. calculate the moles of ferrous ammonium sulfate hexahydrate solution in unit ug/mL.
Concrete is prepared by roasting the mineral calcium carbonate, CaCO3, to drive off CO2 and produce calcium oxide, CaO. The chemical equation for this reaction is: CaCO3 ==> CaO + CO2 The Grand Coulee Dam on the Columbia River in Washington State was built using a volume of concrete of approximately 1.0 x 107 m3. If concrete has a density of 2.4 x 103 kg/m3, and assuming concrete is 100% by volume CaO, how much CO2 was released producing the concrete used to build the dam?
A stock solution of potassium permanganate (KMn04) was prepared by dissolving 13.0g KMn04 with DI in a 100ml volumetric flask and diluting to the calibration mark. Determine the molarity of the solution.
10.5mL (mw 106) of benzaldehyde and 2.9g(3.63mL, mw 40) of acetone react with 5g of NaOH and 25mL of Ethanol to form 6.7g of Dibenzalacetone. What is the theoretical, actual and percent yield?