Answered: j of air in the pipe is limited to 10…

Name: 2. A cast iron pipe is to carry 60 m³ of compressed air per minute at
Uploaded: 2024-03-20T06:56:55.000Z
Channel: Bartleby
Description: 2. A cast iron pipe is to carry 60 m³ of compressed air per minute at a pressure of 1 N/mm². The velocityof air in the pipe is limited to 10 m/s and the permissible tensile stress for the material of the pipe is14 MPa. Find the diameter of the pipe

Engineering

Mechanical Engineering

j of air in the pipe is limited to 10 m/s and the permissible tensile stress for the material of the pipe is 14 MPa. Find the diameter of the pipe and its wall thickness. [Ans. 360 mm; 22 mm]

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

1. For a given pump, the diameter, the gauge pressures at the inlet and outlet are −30 × 103 P a and 200 × 103 P a, respectively. If the flow rate is 0.1 m3/s, and the power required is 25 kW, find the efficiency. The intake and discharge are at the same height. 2. The impeller of a radial-flow turbine has an outer radius of 4 f t, turning at 200 rpm. The volume flow rate is 1000 ft3/s, and it discharges in the axial direction. Neglect all losses. If the tangential component of the velocity at the inlet is 5 f t/s, find: (a) The torque exerted on the impeller. (b) The power developed by the machine.
A wind tunnel has an incompressible flow of air, flowing horizontally from an inlet section, 7 times the test section. A u-tube is connected, containing mercury inside. The mercury has 1.33x10^5 N/m^3 specific weight. The condition of the air at the inlet section is at 1 atm and 280K respectively. What is the change of height inside the mercury, when the velocity at the throat is 70m/s?Complete solutionround off to 4 decimal places
The bore and stroke of an air compressor are 276mm and 164mm, respectively. If the piston displacement is 0.049m3/sec, what is the operating speed of the compressor?
7. a. If the blood viscosity is 2.7x10-3 Pa.s, length of the blood vessel is 0.35 m, tubular resistance of a blood vessel is 38.5 GPa-s/m3 , What is the radius of the blood vessel in mm?b. If the blood pressure at the outlet of the above vessel is 30 mm Hg and the flow rate through the vessel is 100 ml/min, find the inlet pressure in mm Hg. Density of mercury = 13,550 kg/m3, acceleration due to gravity = 9.61 m/s2
1. Atmospheric pressure is about 80 kPa (absolute). Water pressure at the base of a water tower is 600 kPa (gauge). Determine the following: Gauge pressure at the base of the tower Absolute pressure at the base of the tower A pipe carries water at a flow rate of 90 L/s. Determine the minimum inside diameter so that the average velocity of the fluid does not exceed: 3 m/s 2 m/s 4 m/s A 20 mm diameter copper pipe (19.94 mm inside diameter) carries water at a flow rate of 40 L/s. Determine the average velocity of the fluid.
5. The total head of a fan is 185 m and has a static efficiency pressure of 210 mm of water gage.What is the velocity of air flowing if the density of air is 1.15 kg per cubic meter? 8. A coal fired steam boiler uses 3000 kg of coal per hour. Air required for combustion is 15.5 kg ofcoal at barometric pressure of 98.2 KPa. The flue gas has temperature of 285 degree Celsiusand an average molecular weight of 30. Assuming an ash loss of 11% and allowable gas velocityof 7.5 meters per second. Find the diameter of the chimney 9. The gas density is 0.75 kg per cubic meters and air density is of 1.15 kg per cubic meter. If thedriving pressure is 0.25 KPA. Determine the height of the chimney. 10. A powerplant situated at an altitude having an ambient air of 96.53 KPa and 23.88 degreeCelsius. Flue gases at a rate of 5.0 kg per second enter the stack at 200 degree Celsius andleaves at 160 degree Celsius. The flue gases gravimetric analysis are 18% CO2, 7% O2 and 75%N2. Calculate the height of…
The plunger of the hydraulic lift in a gasoline service station has a diameter of 1 inch. It is operated by a compressed air (density = 63 kg/m3) from the tank in which the pressure is 9.315 x 105 pascals. The output piston and the rack on which the car rests are 2 feet lower than the input plunger and together weigh 1,336.33 newtons. What is the weight of the heaviest car that can be lifted if the output piston has a diameter of 1 foot? Assume 80% efficiency of the machine.
The clear plastic bottles used for carbonated beverages (sometimes also called “soda,” “pop,” or “soda pop”) are made from poly(ethylene terephthalate) (PET). The “fizz” in pop results from dissolved carbon dioxide (CO2); because PET is permeable to CO2, pop stored in PET bottles will eventually go “flat” (i.e., lose its fizz). A 20-oz. bottle of pop has a CO2 pressure of about 570 kPa inside the bottle, and the CO2 pressure outside the bottle is 7 kPa. Assuming conditions of steady-state, calculate the diffusion flux in cm3 at STP/cm2.s of CO2 through the wall of the bottle. The Permeability Constant of the PET bottle is 0.23 x 10^-13 cm3@STP.cm/cm2.s.Pa. Note: assume that each bottle has a surface area of 500 cm2 and a wall thickness of 0.07 cm. Answer in Scientific Notation example 1.1e-12. Round your answer to 2 significant figures.
In medical work, pressures are often measured in units of mm of H2O because body fluids, including the cerebrospinal fluid, typically have nearly the same density as water. The pressure of the cerebrospinal fluid can be measured by means of a spinal tap. A hollow tube is inserted into the spinal column, and the height to which the fluid rises is observed. If the fluid rises to a height of 160 mm, we write its gauge pressure as 160 mm H2O. (a) Express this pressure in pascals, in atmospheres, and in millimeters of mercury.
In medical work, pressures are often measured in units of mm of H2O because body fluids, including the cerebrospinal fluid, typically have nearly the same density as water. The pressure of the cerebrospinal fluid can be measured by means of a spinal tap. A hollow tube is inserted into the spinal column, and the height to which the fluid rises is observed. If the fluid rises to a height of 160 mm, we write its gauge pressure as 160 mm H2O. a) Sometimes it is necessary to determine whether an accident victim has suffered a crushed vertebra that is blocking the flow of cerebrospinal fluid in the spinal column. In other cases, a physician may suspect that a tumor or other growth is locking the spinal column and inhibiting the flow of cerebrospinal fluid. Such conditions can be investigated by means of the Queckensted test. In this procedure the veins in the patient’s neck are compressed, to make the blood pressure rise in the brain. The increase in pressure in the blood vessels is…
A wind tunnel has an incompressible flow of air, flowing horizontally from an inlet section, 7 times the test section. A u-tube is connected, containing mercury inside. The mercury has 1.33x10^5 N/m^3 specific weight. The condition of the air at the inlet section is at 1 atm and 280K respectively. What is the change of height inside the mercury, when the velocity at the throat is 70m/s?
A wind tunnel has an incompressible flow of air, flowing horizontally from an inlet section, 7 times the test section. A u-tube is connected, having mercury inside. The mercury's specific weight is 1.33x10^5 N/m^3. Air condition at the inlet section is 1 atm and 280K respectively. Solve for the change in height inside the mercury if the velocity at the throat is 70m/s.