What is the rate of heat loss through a 4-cm Fiberglass wall of the inside temperature is 22 °C and the outside temperature is 45 °C and windy (17 kph) ? the area of the wall is 100 square meters. Include surface films. Assume the k-value for 4-cm fiberglass is 0.056 W/m. °C and the surface air film coefficient for windy velocity (17 kph) is 0.053 for out film and the inner film Rs value is 0.093 as per the surface film coefficient tables ?

What is the rate of heat loss through a 4-cm Fiberglass wall of the inside temperature is 22 °C and the outside temperature is 45 °C and windy (17 kph) ? the area of the wall is 100 square meters. Include surface films. Assume the k-value for 4-cm fiberglass is 0.056 W/m. °C and the surface air film coefficient for windy velocity (17 kph) is 0.053 for out film and the inner film Rs value is 0.093 as per the surface film coefficient tables ?

Principles of Heat Transfer (Activate Learning with these NEW titles from Engineering!)

8th Edition

ISBN:9781305387102

Author:Kreith, Frank; Manglik, Raj M.

Publisher:Kreith, Frank; Manglik, Raj M.

Chapter7: Forced Convection Inside Tubes And Ducts

Section: Chapter Questions

Problem 7.38P

See similar textbooks

Similar questions

A 10-cm shaft rides in a 10.03-cm sleeve and 12-cm long, the clearance space (assumed to be uniform) being filled with lubricating oil (? = 0.11 ?? − ?). Calculate the rate at which heat is generated when the shaft turns at 100 rpm in Watts (W). (Rate of energy = Frictional force/resistance x Velocity)
How does the wall shear stress ?w vary along the flow direction in the fully developed region in (a) laminar flow and (b) turbulent flow?
1. Experimental analysis was carried out about turbulent convective heat transfer in trapezoidal cross-sectioned duct.Average Nusselt numbers and Reynolds numbers were determined for each experiment and the following data set have beenobtained from this investigation. Find an engineering correlation between the average Nusselt number and Reynolds numberin the form ofNu = aReb
During a cold winter day, wind at 55 km/h is blowing parallel to a 4m high and 10m long wall of a house. If the air outside is at 5 degrees Celsius and the surface temperature of the wall is 12 degrees Celsius , determine the rate of heat loss from the wall by convection. What would your answer be if the wind velocity has doubled? From Table A-1:thermal conductivity, k = 0.0246 W/m degrees Celsiusviscosity, v = 1.4 x 10^-5 m^2/sPrandtl no. Pr = 0.717
Prove that the thermocouple will underestimate the temperature of airflow by more than 15% but less than 30% in a large air duct if the temperature of the hot air is 1367 K, duct-wall temperature is 533 K, emissivity of the thermocouple is 0.5, and the convection heat-transfer coefficient is 114 W/m2 -K.
What is turbulent viscosity? What causes it?
A 20 °C water flows to 50cmx60cm flat plate with velocity of 6m/s . The flat plate surface temperature is maintained at 40 °C . The air flows parallel to the 50cm side of the plate. If the kinematic viscosity of water is 78x10-8 m2/s, at what length the flow become turbulent? If the average laminar heat transfer coefficient of water is 7740W/m2 °C , what is the overall heat transfer at the laminar section?
A square plate with a 20 cm side is uniformly exposed to a constant heat flux of 622 W / m2. All surfaces, except the sun-facing surface of the plate, are insulated. Unused motor oil at a temperature of 60 ° C flows over the plate at a speed of 4 m / s. a) Is the flow laminar or turbulent? b) Find the plate temperature.
Aft of the transition point between laminar and turbulent flow A. the boundary layer gets thinner and the speed increases B. the boundary layer thickens and the speed decreases C. the mean speed increases and the surface friction increases D. the mean speed increases and the surface friction decreases
The local atmospheric pressure in Denver, Colorado (elevation 1610 m), is 83.4 kPa. Air at this pressure and 20°C flows with a velocity of 8 m/s over a 1.5 m * 6 m flat plate whose temperature is 140°C. Determine the rate of heat transfer from the plate if the air flows parallel to the (a) 6-m-long side and (b) the 1.5 m side.
What are the three layers within turbulent flow? In which layer is the velocity smallest and in which layer is the turbulent portion of the shear stress dominant?
) A 75 mm-diameter orifice is on the verticalside of a closed tank. The tank rests on a flat groundand the orifice is 0.5 m above the ground. Filled withfour fluids with air on the topmost portion that is undera pressure of 15 KPa, and the rest of specific gravities of0.80, 1.0, and 1.50, respectively, the jet hits the groundat a horizontal distance of 3.75 m. If the liquids have thesame thickness, and the power lost in the system is 233watts, determine the following:(a) The initial discharge in L/s if C=0.63.(b) The thickness of each liquid in m.(c) The coefficient of contraction.