Let L be the length. Let M be the mass. A rod that has Land M was hunged from the one end of a frictionless pivot, and it was hanged vertically at rest (intially) A person fired one small ball of clay with mass (m) to the rod with a speed V(initial) and stuck to the end of the non pivoted area. Find the angle of greatest rotation for the rod/clay system? 1 M M,L V(initial)

Let L be the length. Let M be the mass. A rod that has Land M was hunged from the one end of a frictionless pivot, and it was hanged vertically at rest (intially) A person fired one small ball of clay with mass (m) to the rod with a speed V(initial) and stuck to the end of the non pivoted area. Find the angle of greatest rotation for the rod/clay system? 1 M M,L V(initial)

University Physics Volume 1

18th Edition

ISBN:9781938168277

Author:William Moebs, Samuel J. Ling, Jeff Sanny

Publisher:William Moebs, Samuel J. Ling, Jeff Sanny

Chapter10: Fixed-axis Rotation

Section: Chapter Questions

Problem 103P: A uniform rod of length L and mass M is held vertically with one end resting on the floor as shown...

See similar textbooks

Similar questions

Let r be a vector with an initial point located on the axis of rotation and with a terminal point located at the point where a force F is applied. Find the torque and explain what the torque is measuring.
Note: Because the arguments of the trigonometric functions are unitless in this question, your calculator must be in radian mode if you use it to evaluate any trigonometric functions. When powered up, a disk drive starts at rest and spins up with non-uniform angular acceleration according to the following formula: =asin(bt) where a = 708 radians/s2 and b = 1.74 s-1. This lasts for the first 1.81 seconds, after which the drive does not accelerate. How many meters of disk surface have passed underneath the head in 0.79 seconds?
Consider a bead that is threaded on a rigid circular hoop of radius R lying in the xy-plane with its center at O. What are the degree/s of freedom.
A solid sphere of mass, M = 5.0 kg, and radius, R = 0.100 m is placed on two blocks so that it’s centre of mass lies at the origin as shown on the right. A bullet of mass, m = 0.100 kg, and with an x coordinate of b = 0.04 m strikes the sphere from below with a vertical velocity, v = 65 m/s and embeds in the sphere coming to rest at the location (-b,0) in the diagram below. Since there is no momentum in the horizontal direction, after the bullet hits the sphere , it will rise up to some maximum height and then fall back to its initial position on the two blocks. While the sphere is in the air it will rotate. What is the magnitude of the angle (in degrees) through which the sphere will rotate before it makes contact with the two blocks again?
At the moment of impact, the line of the centers of the sphere is perpendicular to a vertical wall which is at a distance x from the point of collision and nearer(closer) to B than to A, and B subsequently collides with the wall. Find in terms of x, the distance of A from the wall at the instant when B hits the wall.
A uniform sphere of mass m and radius R rolls without slipping down a plane at an angle θ from thehorizontal. Show that the acceleration along the slope of the center of mass is aCM = (5/7)g sin θ and that the force of static friction needed is fs = (2/7)mg sin θ. What minimum coefcient of friction µs is needed to satisfythe conditions of the problem?
The angular moomentum of a point with a mass of m, a velocity v, and position r is: L = mr x v. Prove that the rate of change of L, dL/dt is equal to the torque (T = r x F). F is the force on the point.
Consider the coordinate system in the diagram bellow; the z axis points out of the page. At the point (-d, 0, 0) a ball of mass m is initially (at t= 0) at rest, but it is dropped under the face of gravity, near the Earth. We ignore air resistance as usual, and treat ball as a point mass. 1.c) What is the angular momentum relative to the origin of the coordinate system?
Shown below is a small particle of mass 19 g that is moving at a speed of 10 m/s when it collides with and sticks to the edge of a uniform solid cylinder. The cylinder is free to rotate about the axis through its center and perpendicular to the page. The cylinder has a mass of 0.4 kg and a radius of 16 cm and is initially at rest. What is the angular velocity (in rad/s) of the system after the collision? (Indicate the direction with the sign of your answer.) How much kinetic energy (in J) is lost in the collision?
Prove that the time rate of change of angular momentum is equal to the torque acting on the system without using the differentiation concept.
Consider two masses connected by a string passing over a pulley having a moment of inertia I about its axis of rotation, as in the Figure. The string does not slip on the pulley, and the system is released from rest. Find the linear velocities of the masses after m2 descends through a distance h, and the angular velocity of the pulley at this time.
In the figure below about the point P and Ϝ find the sum of the moments of the two forces