Liquid octane (CH3(CH,) CH,) will react with gaseous oxygen (0,) to produce gaseous carbon dioxide (CO,) and gaseous water (H,O). Suppose 3.4 g of octane is mixed with 21.2 g of oxygen. Calculate the maximum mass of carbon dioxide that could be produced by the chemical reaction. Round your answer to 2 significant digits.

Q: How many protons, neutrons, and electrons are there in a neutral atom of 113In (indium-113)?

A: Atomic number of indium = 49 Atomic mass of indium = 113

Q: ACT 3 Colligative Properties of Nonelectrolyte Solutions Review Questions 12.39 What are colligative...

A: Vapour pressure -  The  pressure exerted by the vapour in the equilibrium with liquid is called as v...

Q: Given the standard heats of formation for the following compounds, calculate AH 208 for the followin...

A:

Q: 12.49.Explain why it is essential that fl uids used in intravenous injections have approximately the...

A: Answer of 12.49 is given below

Q: ow much heat is required to raise the temperature of 1.5 x 103 g of water from 45°F to 130.°F? The s...

A: Given, mass of water = 1.5 × 103 g Temperature increase from initial temperature, T1 = 45 oF = 7.22 ...

Q: You are assigned as a design engineer to design a Carbon Dioxide Capsule (CO2). The design means you...

A: Given: Diameter of cylindrical float = 0.45 m Radius of cylindrical float = 0.225 m length of float ...

Q: A 30.00-mL sample of 0.125 M HCOOH is being titrated with 0.175 M NaOH. What is the pH after 23.0 mL...

A: pH is equal to negative logarithm of hydrogen ions

Q: A chemist determines by measurements that 0.0900 moles of fluorine gas participate in a chemical rea...

A: Given- Moles of fluorine gas particle =0.0900mol

Q: The following reaction is known to have a very large equilibrium constant. 4 NH3(g) + 5 O2(g) 4 NO(g...

A:

Q: 12.48 Describe how you would use freezing-point depression and osmotic pressure measurements to dete...

A: Colligative properties : These are the properties of any solution , which depends upon the concentra...

Q: When (S)-2-bromopropanoic acid [(S)-CH;CHBFCO,H] reacts with concentrated sodium hydroxide, the prod...

A: When an electron-donating neighboring group is present, the rate of SN2 reaction increases and the c...

Q: он OH d. C2H5 e. f. decane-2,2,9-triol 24 diguclonronule clobute 1 2

A: Since you have posted multiple subpart questions, the answer for first three subpart of question is ...

Q: Calculate the standard enthalpy change for the reaction 2C8H18() + 1702(g) -16CO(g) + 18H20(). Given...

A:

Q: What is the theoretical yleld of chromium that can be produced by the reaction of 40.0 g of Cr203 wi...

A: Theoretical yield is the amount of product (Cr here) formed when the given amount of limiting reacta...

Q: Show calculations for making 1X TAE gel running buffer and 1.25% agarose gel for your experiment.

A: Buffer is a solution that tends to maintain pH of the solution when acid or base is added to it. Per...

Q: a) Why do oxygen atoms exist longer at 120-km altitude than at 50-km altitude?

A: At higher altitude oxygen atoms exists longer.

Q: How many grams of dry NH,Cl need to be added to 2.30 L of a 0.700 mol L solution of ammonia, NH3, to...

A: Given Data : 

Q: 2. How would you carry out each of the following syntheses? Each may require more than one step.

A: Please see the attachment

Q: Sort the following structure in increasing order of their boiling points: он A. В. C. D. Drag and dr...

A:  There is no intermolecular hydrogen bonding between ether molecules, which makes their boiling poin...

Q: Which of the following statements is TRUE about elimination tests for anions? Select one: O a. NO; i...

A: Anionic analysis refers to identification of anions present in the salt mixture. Various anions pres...

Q: How many moles of cobalt (Co) atoms are there in 2.00 x 10 (2.00 billion) Co atoms? x 10. mol Enter ...

A:

Q: 3. Commercial concentrated aqueous ammonia is 28% NH3 by mass and has a density of 0.90 g/mL. What i...

A:

Q: Enter your answer in the provided bex. Calculate the molar mass of a compound if 0.382 mole of it ha...

A: This question is related to stoichiometry which determines the quantitative relationship between rea...

Q: How would the calculated molar concentration of the analyte be affected if the burette is rinsed wit...

A: In laboratory while we use burette for titration,we should always rinse it with water at first and t...

Q: PROBLEM 4: Calculate the pH of the following: a. 0.420 M in sodium formate and 0.200 M in formic aci...

A:

Q: How much heat (kJ) is evolved when 4.50 g of Fe203 is reacted with excess carbon monoxide using the ...

A: Detail mathematical calculation for heat evolved is shown below

Q: 10- 0.02 g of AGNO3 in 100 ml of water express the concentration in ppm ? 20ppm 200ppm

A:

Q: Solid aluminum and gaseous oxygen react in a combination reaction to produce aluminum oxide: 4Al (s...

A: given :-  4Al (s) + 3 O2 (g) → 2 Al2O3 (s)  mass of Al = 2.5 g  mass of O2 = 2.5 g  actual yield of ...

Q: What volume of a 0.540 M KOH solution contains 15.5 g of KOH?  My question: After converting the gr...

A:

Q: Determine the number of molecules in 28.6 grams of SO₂.

A:

Q: reaction was monitored as a function of time: AB→A+B A plot of 1/[AB] versus time yields a straigh...

A: AB-->A + B  Slope = 0.052 mol.L^-1.s^-1 Initial concentration = 0.52 mol.L^-1  Final concentratio...

Q: A 22.0 mL sample of 0.124 mol L- diprotic acid (H,A) solution is titrated with 0.1021 mol L-' KOH Th...

A: The equivalence point is a point at which the equivalent of an acid becomes equal to the equivalent ...

Q: draw all the possible sterisomers of the reaction

A: Carbonyl compound prefer to undergo nucleophilicaddition reaction due to its electrophilic character...

Q: Indicate whether the solution is acidic, basic or neutral. Basic Solution pH = 2.4 Acidic Neutral pH...

A: Since you have posted a question with multiple sub-parts, we will solve first three sub-parts for yo...

Q: A chemist measures the amount of bromine liquid produced during an experiment. She finds that 2.3 g ...

A: Given :- mass of bromine liquid produced = 2.3 g  To calculate :-  Number of moles of bromine liquid...

Q: Examine the following reaction, happening in the gaseous state: A+2 B C+ D. Describe the effects on ...

A: Given : gaseous reaction

Q: Mercury is present in Lake Miramar at a total concentration of 20.4 ng/L. Lab tests suggest an avera...

A: The partition coefficient can be calculated as: K=CHg×CpCdissolve          (1) Where CHg is the conc...

Q: Decide whether each molecule or polyatomic ion s polar or nonpolar. do f the molecule or polyatomic ...

A: Polarity of given compounds:

Q: Ethylene (CH,CH,) is the starting point for a wide array of industrial chemical syntheses. For examp...

A:

Q: Answer the following questions in vour lab notebook for prep work. The questions ask you to think ab...

A: The above problem is a lab experiment of diffusion of iodine and starch in a bag that is floating in...

Q: what is the mass of calcium carbonate reacted?

A: Given, Mass of marble before reaction 3.0g Mass of marble after reaction 1.8g

Q: A chemical reaction takes place inside a flask submerged in a water bath. The water bath contains Du...

A: heat flows from out of the flask means heat given out by the reaction and that heat is taken by the ...

Q: Why do the ability to separate and recover pure substances from mixtures is extremely important in s...

A: Purity is a necessity of scientific research.

Q: Decide whether each molecule or polyatomic ion is polar or nonpolar. If the molecule or polyatomic i...

A:

Q: Describe the effects of cooling an exothermic reaction at equilibrium.

A: Given it's a exothermic reaction. 

Q: The combustion of pentane produces heat according to the equation C5H12(1) + 802(g)→ 5CO2(9) + 6H20(...

A:

Q: Given that pKa = 4.72 at 25 °C for HN3, what is the pH of 0.125 mol L-1 NaN3(aq) at 25 °C? What is t...

A: A question based on equilibrium concept that is to be accomplished.

Q: Rx Mercury Bichloride 0.1% Resorcin M...

A: Density of isopropyl alcohol = 0.7854 g/mL

Q: Tobramycin sulfate is a 7-ion electrolyte and has a molecular weight of 1425.45 g/mol. Assuming that...

A:

Q: Be sure to answer all parts. Predict the sign of the entropy change for each of the following proces...

A: