i need the answer quickly Maximizesubject toP = 4x₁+3x2+2x33x1 + 2x2 + 5x3 ≤ 232x1 + x2 + x3 ≤ 8x₁ +x₂ + 2x3 ≤ 7X1, X2, X3 ≥ 0

Answered: Image /qna-images/answer/40c44a1c-60d4-45be-a825-11750029b9af.jpg

Answered: Maximize subject to P = 4x₁ +3x2+2x3…

Engineering

Mechanical Engineering

Maximize subject to P = 4x₁ +3x2+2x3 3x₁ + 2x2 + 5x3 ≤ 23 2x₁ + x₂ + x3 ≤8 x₁ + x₂ + 2x3 ≤7 X1, X2, X3 20

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Related questions

Q: In the diagram shown, the (aut cad) correct steps for drawing a triangle starting from point B in…

Q: A model airplane flies over an observer O with constant speed in a straight line as shown. Determine…

A: For the model airplane, it is required to determine the sign of: r, r˙, r¨, θ, θ˙, and θ¨

Q: Q- (A) Compute the volumetric efficiency of hydraulic motor with a displacement of 0.00985 Vrev at…

A: Given data: Volumetric displacement, VD = 0.00985 l/rev Speed of the motor, N = 2400 rpm Actual…

Q: The 60° V-belt of a machine is pass around the pulley A of a motor and over a pulley B as shown in…

Q: Water flows through a pipe 25 mm in diameter at a velocity of 6 m/s. Determine whether the flow…

A: The flow which maintains the particles of a fluid to a straight and parallel path is called laminar…

Q: Cable AB passes over the small ideal pulley Cwithout a change in its tension. What length of cable…

A: Given: m= 75 lb θ=41o Tension T in cable CD=? Cable AB passes over the small ideal pulley C without…

Q: Advantages of pressurized cooling system

A: Given Data : Pressurized cooling system

Q: The uniform 18-m pole has a mass of 200 kg and is supported by its smooth ends against the vertical…

Q: 5) When is the tangential force greater than the normal force? A) Only at the very beginning Q2/[ B)…

A: If it is the case of frictional force and Normal reaction then its option is D) part None of these…

Q: The root diameter of a double square thread is 0.55 in. The screw has a pitch of 0.2 in. Find the…

Q: The coefficient of friction between the 2-lb block and the surface is = 0.2. The block has an…

Q: Two radio transmitters positioned 400 mi apart along the shore send simultaneous signals to a ship…

Q: A couple consists of two vertical forces of 60 lb each. One force acts up through A and the other…

Q: The position of a particle in millimeters is given by s= 70-17t+t²where t is in seconds. Plot the…

A: Introduction: A body's displacement is simply the change in position between two points in time…

Q: Output 1. 2. D E D с B 1. с A Input Figure.2: Epicyclic gear trains used in differential box in an…

A: Introduction: Gears are used to transmit motion through the engagement of gear teeth, which results…

Q: 5) When is the tangential force greater than the normal force? A) Only at the very beginning B) in…

A: The normal force is just the frictional forces between two surfaces which is in contant. Tangential…

Q: For the circuit shown, give the sequence of operation of cylinders 1 and 2 when the pump is turned…

A: A hydraulic circuit is a device that moves liquid via a network of separate components. This…

Q: 2.1. Compute the resultant reaction at A. (CONSIDER 2-DECIMAL PLACES; NO NEED TO WRITE THE UNIT)

Q: 10.4 A steel thick cylinder of external diameter 150 mm has two strain gauges fixed externally, one…

Q: 2. Determine an estimate of the discharge in the stream depicted below using the data in the…

A: Here, firstly we'll determine mean velocity for each sector by taking average of velocity at both…

Q: An oil pump operating at steady state delivers oil at a rate of 12 lb/s through a 1-in.-diameter…

A: All pumps use the fundamental forces of nature to move a liquid. Once the moving pump element…

Q: Q1/ Select the right answer for the following question? F 1) the kinematics of a particle happened…

A: GIVEN DATA- A TRUE/FALSE QUESTION GIVEN WE HAVE TO CHOOSE CORRECT OPTION

Q: A particle moving in the x-y plane has a position vector given by r = 0.60t²i + 1.41t³j, where r is…

Q: The device shown rotates about the fixed z-axis with angular velocity w = 25 rad/s and angular…

A: Given that: angular velocity = 25 rad/s angular acceleration = 42 rad/s2 It is required to determine…

Q: Draw the top, front, and side view with dimensions. (Third angle view). Hint: You may draw the…

A: To find: Top view Front view and side view The direction of front view is shown below by red mark

Q: Saturates water vapor at 700 kPa is flowing in a pipe. Connected to this pipe through a valve is an…

Q: The sphere P travels in a straight line with speed v= 15.1 m/s. For the instant depicted, determine…

Q: A compression spring is made of music wire of 2 mm diameter having a shear strength and shear…

Q: The sprinter begins from rest at position A and accelerates along the track. If the stationary…

A: Solution - Given data- ω = 13.4 deg/s

Q: The heat flux from a wall to air in motion having a heat transfer coefficient of 15 W/m². K and…

A: Given data Heat transfer coefficient (h)=15 W/m2K Change in temperature (dT)=20 oC

Q: he entropy change across a normal shock wave (Tox= 505 K, vx= 490 ms-1)

A: Given data: Tox = 505 K Vx = 490 m/s For air, specific heat, cp = 1.005 kJ/kg.K = 1005 /kg.K Gas…

Q: For the following Figure: 1) Determine the magnitude of the vector V = V2- V1 ( 2) The angle which V…

Q: Statics is the branch of fluid mechanics that is involved with the study of Rigid bodies. Select…

A: To state TRUE or FALSE

Q: Problem 6: Four forces (1, 2, 3, and 4) are in the x-y plane and act on an irregularly shaped…

A: Introduction: A given force F can be resolved into or replaced by two forces that have the same…

Q: A 250 mm diameter pipes (f = 0.015), 150 m long is connected in series with another 200 mm diameter…

Q: 1. A moving coil voltmeter with a resistance of 150 ohms gives a full scale deflection with a…

A: Electric current measurements are made with a moving coil galvanometer. It is a sensitive…

Q: There is an ambient temperature of 65°C with a temperature rating of the conductor as 75°C. What is…

A: Introduction: Heat transmission, whether through conduction, convection, or radiation, is…

Q: *// For a simple beam loaded as shown in Figure 1. Determine the deflection at the position midway…

Q: F2-1. Determine the magnitude of the resultant force acting on the screw eye and its direction…

A: When forces F1, F2, F3,.... are acting at a point at an inclination θ1, θ2, θ3,..... form the…

Q: Fixed geometry jet engine inlet is not feasible for very low supersonic Mach no.

A: In order to achieve optimal operational efficiency, the air flow into the compressor should be…

Q: Part A Determine the magnitude of the velocity of car B relative to car A. Express your answer to…

Q: 2 kg of ammonia is contained in a rigid sealed tank at 10 °C. The surroundings temperature is 95 °C.…

A: Given:m=2 KgT1=10°CTs=95°CT2=90°C

Q: Determine the force acting on the gates in the exercises of the figures

A: Given: The height of triangular gate, h = 20 in The width of triangular gate, b = 30 in

Q: The rigid beam ABC is supported by a pin connection at C and by steel rod (1), which has a diameter…

Q: 0(a) The x-coordinate of a particle in curvilinear motion is given by x = 4.4t3 - 4.9t where x is in…

A: Introduction: Curvilinear motion is described as motion that happens when a particle moves along a…

Q: A uniform light slender beam AB of section modulus EI is pinned by a frictionless joint A to the…

Q: 1. Show the computation using P water ( HP) 2. Show the computation for Density of Air and Specific…

Q: An insulated 5000 Liter rigid tank contains air at 5 bar and 330 K. A valve connected to the tank is…

Q: Q.3) The flow rate of water through a 10-in diameter pipe is 43.912kg/s; it's measured with an…

Q: Discuss various approaches and techniques used in concurrent engineering

A: Concurrent Engineering: Simultaneous engineering (or) Parallel engineering also known as concurrent…

Question

i need the answer quickly

Maximize
subject to
P = 4x₁+3x2+2x3
3x1 + 2x2 + 5x3 ≤ 23
2x1 + x2 + x3 ≤ 8
x₁ +
x₂ + 2x3 ≤ 7
X1, X2, X3 ≥ 0

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, mechanical-engineering and related others by exploring similar questions and additional content below.

Similar questions

The marketing research department of a large manufacturing company has determined that the demand equations for two major items it produces are given by p = 2,000 - 5x + 8y and q = 4,000+ 9x - 7y where p is the price of item A. is the price of item B , x is the monthly demand for item A , and y is the monthly demand for item B. Find the total monthly revenue from items A and B when x = 15 and y = 5 .
A particle rotates with constant speed in a circle. Let be the net torque on the particle and F the net force on the particle. Then: a. tau > 0 and F > 0 O b. tau > 0 and F = 0 . tau = 0 and F = 0 Od. tau = 0 and F > 0
Answer the following problem completely and thoroughly.
For the system below, EI is constant. If x = 6.73 m from point B, determine the value of EI(Δ) ? If x = 2.49 m from point B, determine the value of EI(θ) ? If x = 7.57 m from point B, determine the value of EI(Δ) ? If x = 4.79 m from point B, determine the value of EI(θ) ?
Given the figure before, when the displacement of block D is 360 ft, then the displacement of block A is closest to:
The flow of gases through a jet engine is internal flow since the fluid is completely bounded by the sollo True or False True True False
A higher-order differential equation given as y" + p(x)y' g (x)y = O is a homogenous equation, even if p(x) = 0. A higher-order differential equation given as y" + p(x)y' + q(x)y = 0 is also a homogenous equation, even if g(x) = 0. O Only first statement is true. O Only second statement is true. O Both first and second statements are true. O Both first and second statements are false.
During a bicep curl on a bicep curl machine, I'm curling a weight stack of 100 pounds (single arm...I'm jacked like that). At this very moment, the weight stack has a moment arm of 0.12m, my elbow has an angle of 63deg, my muscle force vector has an angle of 23deg, and it attaches 3cm below my elbow joint on my radius. How much force must my bicep create right at this moment to hold the weight stack in place?
Use Hottel's Crossed String Method to find Fij. The distance between the plane and the circle is 25cm, with radius at 6cm. Also, the circle is at the left of the plane, where it has the same center line as the plane.
Given a set of concurrent forces with force A = 25 lbs, direction = 30 degrees; force B = 40 lbs, direction = 120 degrees. Find the magnitude and direction of the resultant force. a. 52.36 lbsb. 47.17 lbsc. 34.68 lbsd. 67.45 lbs
Consider the following linear equations,
The expression: "If the vector sum of the external forces on a system is zero, the total linear motion of the system ..." Complete the sentence with the best option that completes the expression: a) It is constant and the utility lies in that it does not depend on the detailed nature of the internal forces acting between the members of the system. b) It is constant and the utility lies in that it depends on the detailed nature of the internal forces acting between the members of the system. c) It is not constant and the utility lies in that it depends on the detailed nature of the external forces acting between the members of the system. d) It is not constant and the usefulness is that it does not depend on the detailed nature of the external forces acting between the members of the system.