During a bicep curl on a bicep curl machine, I'm curling a weight stack of 100 pounds (single arm...I'm jacked like that). At this very moment, the weight stack has a moment arm of 0.12m, my elbow has an angle of 63deg, my muscle force vector has an angle of 23deg, and it attaches 3cm below my elbow joint on my radius. How much force must my bicep create right at this moment to hold the weight stack in place?

During a bicep curl on a bicep curl machine, I'm curling a weight stack of 100 pounds (single arm...I'm jacked like that). At this very moment, the weight stack has a moment arm of 0.12m, my elbow has an angle of 63deg, my muscle force vector has an angle of 23deg, and it attaches 3cm below my elbow joint on my radius. How much force must my bicep create right at this moment to hold the weight stack in place?

Principles of Heat Transfer (Activate Learning with these NEW titles from Engineering!)

8th Edition

ISBN:9781305387102

Author:Kreith, Frank; Manglik, Raj M.

Publisher:Kreith, Frank; Manglik, Raj M.

Chapter5: Analysis Of Convection Heat Transfer

Section: Chapter Questions

Problem 5.5P: Evaluate the dimensionless groups hcD/k,UD/, and cp/k for water, n-butyl alcohol, mercury, hydrogen,...

See similar textbooks

Similar questions

A uniform aluminum beam 9.00 m long, weighing 300 N,rests symmetrically on two supports 5.00 m apart (Fig. ). A boyweighing 600 N starts at point A and walks toward the right. (a) In thesame diagram construct two graphs showing the upward forces FA andFB exerted on the beam at points A and B, as functions of the coordinatex of the boy. Let 1 cm = 100 N vertically and 1 cm = 1.00 m horizontally.(b) From your diagram, how far beyond point B can the boy walkbefore the beam tips? (c) How far from the right end of the beam shouldsupport B be placed so that the boy can walk just to the end of the beamwithout causing it to tip?
A small block starting from rest takes 5 sec to slide down an inclinedplane 80 cm long. (a) What was its acceleration and (b) with what speed did it reach the bottom of the incline?
Use Hottel's Crossed String Method to find Fij. The distance between the plane and the circle is 25cm, with radius at 6cm. Also, the circle is at the left of the plane, where it has the same center line as the plane.
! i want you to find the data of the boeing 777-300 to find the Service ceiling and Time to climb using the following laws :
A Jello desert resting on a plate is starts wiggling when it is sheared to the side 0.5 cm as is set on the table. The desert is a rectangular prism with a square face 25.0-cm on a side and a height of 12.0 cm. A quick Google search reveals that the density of Jello is 1140 kg/m3 with shear modulus of 530 N/m2. What is its rate of oscillation? If the energy of oscillation is dissipated at the rate of 5.00 x 10-5 J per second how long will the block wiggle?
An object with weight W is dragged along a horizontalplane by a force acting along a rope attached to the object.If the rope makes an angle θ with the plane, then the magnitudeof the force is given below in image. where μ is a constant called the coefficient of friction.(a) Find the rate of change of F with respect to θ .(b) When is this rate of change equal to 0?; (c) If W =50lb and μ =0.6 , draw the graph of F as afunction of θ and use it to locate the value of θ forwhich dF/dθ =0 . Is the value consistent with youranswer to part (b)?
A wooden plank x meters long has one end leaning on top of a vertical wall 1.5 m long and the other end resting on a horizontal ground. Neglecting friction, find x if a force (parallel on the plank) of 100 N is needed to pull a 400 N block up the plank.
Zorch, an archenemy of Superman, decides to slow Earth’s rotation to once per 29 h by exerting a force parallel to the equator, opposing the rotation. Superman is not immediately concerned, because he knows Zorch can only exert a force of 4.15 × 107 N. For the purposes calculations in this problem you should treat the Earth as a sphere of uniform density even though it isn't. a. How long, in seconds, must Zorch push with this force to accomplish his goal? (This period gives Superman time to devote to other villains.)
1. A non-uniform is 4.5m long and weighs 640N. It is balance when a 270N weight is hung 0.800m from the light end of the bar and the bar is pivoted at its center. Where is the center of gravity of the bar? 2.Two workers carry a non-uniform beam weighing 730N. The beam is 2.6m long and its center of gravity is 1.1 m from one end. If the workers hold the beam at its end, how much does each worker lift?
An archer shoots an arrow at a 22° angle to the horizontal. At the top of its motion, the arrow just clears a 36 m high oak tree. A.) How fast in km/min was tge arrow going when it left the bow? (Aasume it was shoot from a height of 1.0 m above the ground). B.) How far away is the archer from the tree in fee?
When you lift an object by moving only your forearm, the main lifting muscle in your arm is the biceps. Suppose the mass of a forearm with hand is 1.80 kg. If the biceps is connected to the forearm a distance of 2.50 cm from the elbow, how much force must the biceps exert to hold a 44.5 N (about 10 lbs) ball at the end of the forearm at distance of 35.0 cm from the elbow, with the forearm parallel to the floor, in Newtons? Use g = 10.0 m/s2.
A computer is protected against impact by foam packaging (spring stiffness, k = 100 N/cm; mass, m = 11 kg, including packaging). The maximum acceleration that the computer can withstand on impact with a hard surface is 4g. At the maximum acceptable impact acceleration, how much does the packaging compress upon impact? Give the answer in cm. What is the maximum height, h, in cm that the case can fall from without damaging the computer?