20Mercury analysis results performed on a drinking watersample are given in the table below.1315Analysis No1Mercury(ppb)54.1 55.5 63.854.455.8 57.9Which value is the average with the 90% confidenceinterval? (t = 2.02,s = 3.63)a) O 56.9 ± -3.0b) O 56.9 + -2.8C) O 55.9 ± -3.0d) O 56.9 ± -3.1O Boş bırak

The average of the given data, x = 54.1+55.5+63.8+54.4+55.8+57.96= 56.9 The value of average with 90…

Mercury analysis results performed on a drinking water sample are given in the table below. Analysis No 1 2 3 4 15 6 Mercury (ppb) 54.1 55.5 63.8 54.4 55.8 57.9 Which value is the average with the 90% confidence interval? (t = 2.02, s= 3.63) a) 56.9 + -3.0 b) 56.9 + -2.8 55.9 + -3.O 56.9 + -3.1 nc hiralc

Mercury analysis results performed on a drinking water sample are given in the table below. Analysis No 1 2 3 4 15 6 Mercury (ppb) 54.1 55.5 63.8 54.4 55.8 57.9 Which value is the average with the 90% confidence interval? (t = 2.02, s= 3.63) a) 56.9 + -3.0 b) 56.9 + -2.8 55.9 + -3.O 56.9 + -3.1 nc hiralc

Appl Of Ms Excel In Analytical Chemistry

2nd Edition

ISBN:9781285686691

Author:Crouch

Publisher:Crouch

Chapter3: Statistical Tests With Excel

Section: Chapter Questions

Problem 7P

See similar textbooks

Similar questions

1) Mass of flask, aluminum foil, and rubber band 68.45g 2) Temp. Of boiling, water 98.20 0C 3) Barometric pressure 755 mmHg 4) Volume of flask (volume of vapor occupies flask) 152 ml 5) Mass of flask, aluminum foil, rubber band, and condensed vapor 68.60g 6) Mass of condensed vapor is (5)-(1) Find Molecular weight of unknown ______ g / mol Calculation PV = (m/M)RT) è M = (mRT) / PV = ? Unknown liquid- Based on Molecular weight determine which unknown below has this molecular weight: Methanol, Ethanol, Isopropanol, Propanol. UNKNOW IS : __________________________
An analysis of city drinking water for total hardness was done by two students in the laboratory and produced the following results (in ppm CaCO3): Student A: 228.3, 226.4, 226.9, 227.1, and 228.6. Student B: 229.5, 226.1, 230.7, 223.8, and 227.5What is the 95% confidence interval for the mean?
1. Which of the following is NOT a true representation of the Lineweaver-Burk equation? Group of answer choices a. y-intercept = -1/Vmax b. x-intercept = -1/Km c. y = 1/V0 d. x = 1/[S] e. slope = Km/Vmax 2. If the y-intercept of a Lineweaver-Burk (double reciprocal) plot = 39.37 (sec/millimole) and the slope = 75.3 L/sec, Vmax equals: Group of answer choices a. 75.3 millimoles/sec. b. 0.0254 millimoles/sec. c. 0.523 millimoles/sec. d. 39.4 millimoles/sec. 3. Which of the following is true regarding allosteric enzyme behavior?Group of answer choices a. Allosteric enzymes are rarely important in the regulation of metabolic pathways. b. An allosteric effector binds reversibly on the surface of the enzyme. c. An hyperbolic representation of the relation initial velocity vs [S] is a specific characteristic of an allosteric enzyme behavior. d. Michaelis-Menten kinetics model the kinetic behavior of allosteric enzymes.
Ammonia (considered to be ideal gas, 1 mole) initially at 25 oC and 1 bar pressure is heated at constant pressure until the volume has tripled.Use CP = 25.895 + 32.999 x 10^– 3 T – 30.46 x 10^– 7 T2 , J/mole-KCalculate: c) delta H d) delta U e) delta S show complete solution
Use E5C.1(a) to Plot the data in excel. Place two data sets on the same graph: one for temp vs. x and one for temp vs y (remember, x and y are the mole fractions and they belong on the x-axis). Don’t forget to include the boiling points of the pure substances – they are data, too. Add a trendline (polynomial, 3rd order should work) to each of the coexistence lines separately. Scale the plot appropriately and use the graph to answer the questions. Then complete E5C.1(b)
Identify the effect of the condition on the parameter. Write increase, decrease, or no effect. And Explain. A. The actual concentration of the sodium hydroxide used in the calibration part of the experiment was lower than the stated value. [Ccal] B. The actual concentration of the sodium hydroxide used in the calibration part of the experiment was lower than the stated value. However, the NaOH solution used in the determination of ΔHrxn was of the correct concentration. [magnitude of ΔHrxn] C. A wet pipette was used to transfer 10.00 mL of 1M HNO3 in the determination of ΔHrxn. [magnitude of ΔHrxn]
Qq.1. Subject :- Account
The gravimetric factor used to express CoCBr6·H20 in a sample that is finally weighed as PbClBr is choose below: FW PbClBr / 6 x FW CoCBr6·H20 FW CoCBr6·H20 / FW PbClBr FW CoCBr6·H20 / 6 x FW PbClBr 6 x FW PbClBr / FW CoCBr6·H20
Calculate the specific volume, α (cm3/gm), using the following equation and the values of constants and conversion factors provided. α = (RT)/p Where R = 2.8704 x 106 erg/gm(˚K), T = 10˚C, and p = 1000 millimars (mb). All of the conversion factors you will need are: 1 mb = 103 dynes/cm2 ˚K = 273˚ + ˚C erg = dyne(cm) a. α = 8.123 x 109 cm3/gm b. α = 8.123 x 102 cm3/gm c. α = 2.8704 x 104 cm3/gm d. α = 2.8704 x 106 cm3/gm
A student performed the experiment described in this module, using 7.00 mL of a 1.8% H2O2 solution with a density of 1.01 g mL-1. The water temperature was 20 ° C, and the barometric pressure in the laboratory was 30.02 in. Hg. After the student immersed the yeast in the peroxide solution, she collected 45.1 mL of O2. (11) Calculate the percent error for the experiment.
Boyle’s law for confined gases states that if the temperature is constant, pv = c, where p ispressure, v is volume, and c is a constant. At a certain instant the volume is 75 cubic inches, thepressure is 30 psi, and the pressure is decreasing at the rate of 2 psi every minute. What is therate of change of the volume at that instant?
Oceanic uptake of carbon dioxide is thus described:CO2 (g) + H2O ⇔ H2CO3, K = [H2CO3]/PCO2 = 3 x 10-2 M atm-1 H2CO3 ⇔ HCO3- + H+, K = [HCO3-][H+]/[H2CO3] = 9 x 10-7 moles/LHCO3- ⇔ CO32 - + H+, K = [CO32 -][H+]/[HCO3-] = 7 x 10-10 moles/LCharge balance equation:[H+] = [OH-] + [HCO3-] + 2[CO32 ] If the CO2 concentration in the atmosphere is 300 ppm, what is the pH of the ocean?