mm2), as shown in the figure. Determine the dead loads acting on beam BF and girder AD. Question 1: What is the total dead load of girder AD   in kN/m?

Q: An indeterminate beam carries a distributed load and concentrated load as shown in the figure. Solve…

A:

Q: QUIZ 3 FALL 2020 Problem 1. For the frame shown in the figure, determine (a) Reactions at the…

A: Solution-

Q: An 11-m simply supported beam is supported by another simple support 6.5 meters from the left…

A:

Q: Compute the magnitude of the resultant force on the indicated area and the location of the centre of…

A:

Q: Problem #2 10*Y N/m X/10 N/m B Cm Bm 7. What is the total resultant vertical load in the beam AB?…

A:

Q: Q4/ See Fig. (4). What force P must the two men exert on the rope to slide the uniform 6 m beam of…

A:

Q: A y N fixed support at A 10 N/mm 150 mm B X 250 mm 200 mm C 2. Which of the following is the…

A:

Q: Analyze the following figure if: h=1.5 m, d=3.2 m, x=2.4 m 4.5 kN D 4.5 kN 4.5 kN h B 2 kN 2 kN h E…

A: Given:-

Q: Fi P 0.5 m. 1 m Q 3 m Wg E D

A:

Q: SITUATION 4 A concrete tank shown in Figure 4 is 80% full of water with 340 mm wall and floor slab…

A:

Q: Q1) As shown in Figure 1, choose the nearest answer letter a, b, c or d. Determine the moment of the…

A: answer = 43.467 KN-M   explanation is given below

Q: Question 3 A square lamina is immersed in water with one of the diagonals vertical as shown in…

A:

Q: The floor system of a building consists of a 125 mm thick reinforced concrete slab resting on four…

A:

Q: column Problem 2. The floor system of a gymnasium consists of a 130-mm- thick concrete slab resting…

A: Given: Thickness of concrete slab = 0.130mm, Area of steel beam As = 9100 mm2, Area of Steel girders…

Q: Q1: Determine the magnitude and direction of the resultant forces in figure below? Fq= 500 N F,- 600…

A:

Q: For the beam shown in the figure below, determine the following maximum response due to a…

A: To find the maximum response of putting the load on the beam one of the important method is the…

Q: Figure below shows a beam that is pin supported at Point A and roller supported Point B. The Point…

A: By using equilibrium condition Σfx = 0 Σfy = 0 ΣMz = 0  Support reaction ( VA, HA and VB) is funded.

Q: Given: Figure 2 shows the cross section of a wood frame building. Find: (a) Roof dead load D in psf…

A: Consider the given diagram.

Q: From the Figure shown below. Compute the magnitude of the resultant force (kN) on the indicated area…

A: Resultant Force on Area: F = ρgAh¯      = 0.88×1000×π×222×1.056     = 5838.838 N

Q: H.W: Replace the 600 lb force of Figure below by a force through A and a couple whose forces act…

A:

Q: 4. A two-story building has steel columns AB in the first floor and BC in the second floor, as shown…

A:

Q: Shown in a figure is a tower which was held by a guy wire at pin B, C, D. Considering 480 lb of the…

A:

Q: Two uniform loads of 112 kN/m acting downward are supported by a uniform upward pressure of o as…

A: Shear force: The shear force of a member or span is defined as the taking sum of all moments about…

Q: Question 2: A one-story shear building with an appendage attached to its top is subject to a…

A:

Q: 3:)In the figure, the hollow square section chimney made of stone brick is under the effect of a…

A: The FBD of the given chimney is shown below: The maximum bending moment for the given condition…

Q: Situation X:Consider the figure shown below. a =1m w = 18 kN/m P= 30 kN Flexural rigidity of beam AB…

A:

Q: The floor system of an apartment building consists of a 100-mm-thick reinforced concrete slab…

A: thick=100mm The areas of a cross-section of the floor beams and the girders= 11,800 mm2 and 21,100…

Q: Steel floor beam -Steel girder (A = 25,600 mm?) Problem 2. The floor system of a gymnasium consists…

A:

Q: For the given tower shown, Which of the following gives the nearest value of axial force acting on…

A: Find force in member BC

Q: From the figure shown, the beam carries a service dead load of 3 kN/m and a service live load of 4.5…

A: The maximum bending moment happens in a pillar, when the shear force at that part is zero or changes…

Q: The floor system of a gymnasium consists of a 130-mm-thick concrete slab resting on four steel beams…

A:

Q: b) Figure Q1 (b) shows a log with 1.2 m of diameter and 4 m of width is located between the two…

A: step 1-

Q: Consider the overhang beam shown in (Figure 1). Suppose that P = 6 kN, M= 6 kN⋅m, w= 4 kN/m. Point D…

A: FIND REACTIONS:∑ MA=0RB3-124333+3-431.5+6-6356=0RB=23.2kN∑ Fy=0 By3-1243-43-635=0   RA=-1.6kN ∑ Fx=0…

Q: Q.3) For the figure shown, if the moment of the force F about the axis BC is 150 lb ·ft. B Determine…

A: Determine the position vector for the force F.…

Q: As shown, a uniform beam of length d = 1.80m and mass 21.3kg is attached to a wall with a pin at…

A:

Q: Determine the member force CD (kN) shown in the figure. 3 KN 2 m 45° 130 30 2 m 2 m

A:

Q: 3.6. Determine the reactions to Beam D in Figure 3.22. Assume that the average dead and live load is…

A: Given: Average dead load and live load = 60 psf

Q: Q1: Determine the magnitude and direction of the resultant forces in figure below? F2= 500 N F = 600…

A: given F1 = 600 N F2 = 500N F3 = 800 N we have to find resultant.

Q: QUESTION 3: A block with mass m= (24+12)kg is pulled by a horizontal force P applied at point B in…

A: It is required to determine the mass. m=2A+12 kg=21+12 kg=14 kg It is required to determine the…

Q: 1.6 The floor system of a gymnasium consists of a 130-mm-thick concrete slab resting on four steel…

A: From the table of Unit weight of materials, we get Unit weight of concrete Unit weight of structural…

Q: D (5000 mm2) (4000 mm) E (5000 mm) 3 m 4000 mm) (S000 mm?) B (5000 mm?) A 100 kN 2 panels at 4 m 8 m…

A:

Q: A ladder AB leans against a wall for which equilibrium is maintained. Given: Static friction at both…

A:

Q: Q1: Determine the magnitude and direction of the resultant forces in figure below? F- 500 N F- 600 N…

A: Given : F1 = 600 N F2 = 500 N F3 = 800 N H = .1+.3 = .4 m L = .4 - .2 = .2 m angle = 35° slope = 3:4

Q: Calculate the approximate internal MOMENTS at point A and point B due to the vertical loading shown…

A:

Q: PROBLEM No. 2 Two steel pipe columns (E = 200,000 MPa, A1 = 1800 mm², A2 = 2000 mm²) support a rigid…

A:

Q: 1. The floor system of an apartment building consists of a 100-mm- thick reinforced concrete slab…

A: Given  Slab thickness = 100 mm  Area of floor beams = 11800 mm2  Area of girders = 21100mm2

Q: AS SHOWN IN THE FIGURE, A RIGID BEAM WITH NEGLIGIBLE MASS IS PINNED AT 'O' AND SUPPORTED BY TWO RODS…

A:

Q: Example Determine the horizontal and vertical components of force at pins B and C. The suspended…

A: m=75kg To find force at pin B and C

Q: Solve fast

A: Given: Average dead load and live load = 60 psf

Q: MOMENT DISTRIBUTION METHOD 6 kN 2 kN/m Example: 8 KN-m MATH com 3. Determine the Reactions at each…

A:

Applications of Concrete Framing Systems

A concrete frame is a structure formed by the interconnection of beams and columns to form a structural network. In simple terms, it is the basic skeletal structure of a building or any construction. The concrete framing structure is built on a concrete foundation that forms the base of the entire structure. The concrete frame system is built to support floors, roofs, walls, beams, rafters, joists, etc.