NOTE: This is a multi-part question. Once an answer is submitted, you will be unable to return to this part. Refrigerant-134a enters an adiabatic compressor as saturated vapor at 100 kPa at a rate of 0.6 m³/min and exits at 1-MPa pressure. The isentropic efficiency of the compressor is 87 percent. 1 MPa R-134a Compressor 100 kPa sat. vapor

NOTE: This is a multi-part question. Once an answer is submitted, you will be unable to return to this part. Refrigerant-134a enters an adiabatic compressor as saturated vapor at 100 kPa at a rate of 0.6 m³/min and exits at 1-MPa pressure. The isentropic efficiency of the compressor is 87 percent. 1 MPa R-134a Compressor 100 kPa sat. vapor

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

12-The saturated vapor refrigerant - 134a (refrigerant, R-134a) is compressed in a compressor from a temperature of 28°C to a pressure of 0.9 MPa. If the compressor efficiency is 89%, which of the following is the compression power? A) 13,57 kJ/kg B) 14,63 kJ/kg C) 3,90 kJ/kg D) 4,92 kJ/kg E) 4,38 kJ/kg
14 - The volumetric flow rate of the refrigerant R-134a entering a compressor at 140 kPa pressure and – 10ºC temperature is 1.23 m³/min. What is the mass flow rate of R-134a? a) 0.7376 kg/h B) 0.1229 kg/h NS) 0.6804 kg/h D) 0.1404 kg/h TO) 0.1134 kg/h
15m3/sofmoistairat45Cdb,31Cwbandpassesthroughairwasher. If the saturation efficiency is 90%. Determine the air state at the outlet of the air washer.
A certain Geothermal Power Plant shows that 1,700,000 kg/hr of pressurized ground water is available at 17.5MPa and 330°C. The water will be throttled to a pressure of 1.7MPa to produce wet steam and this mixture will be passed through a water separator to remove the water droplets so that saturated steam at 1.7MPa is available at the entrance of the Turbine. Other data are as follows: Discharge Pressure of turbine = 85kPa-Vac; Turbine Efficiency = 73%. Mechanical Loss = 2% of shaft power. Generator Efficiency = 95%. Determine the following: 1.The mass flow rate, in kg/min, of steam entering the turbine. a. 153,720 b . 76,858 c. 38,430 d. 19,200 e. 9,350 2. The maximum amount of power, in kW, that the plant can generate. a. 38,430 b. 19,200 c. 76,858 d. 9,350 e. 153,720
Please match the formulate (energy and/or mass balance) to the corresponding steady flow devices: A not well insulated nozzles by neglecting the potential energy change. An adiabatic turbine by neglecting the kinetic and potential energy change. A not well insulated compressor by neglecting the kinetic and potential energy change. An adiabatic mixing chamber with two inlets and one exit by neglecting the kinetic and potential energy change. An adiabatic throttling valve by neglecting the kinetic and potential energy change. A. B. C. D. E.
Describe the ideal process for an adiabatic nozzle, and define the isentropic efficiency for each device.
Refrigerant R134a enters an expansion valve at 800 kPa as a saturated liquid and exits at 100 kPa. The temperature of the refrigerant at the outlet of the valve and the vapor fraction will be? (a) 31.3°C and 0.0 (b) -26.4°C and 0.28 (c) -26.4 °C and 0.36 (d) 31.3°C and 0.28
Saturated ambient air with a DB of 8°C and a mass flow rate of 0.98 kg/s is divided into two streams. One stream passes through a heating section and leaves it with an RH of 30%. The conditions of the other stream that bypasses the heater remains unchanged. The two streams are then adiabatically mixed to produce the supply air stream at 22°C. The pressure is constant at 101.3 kPa. -Determine the partial pressure of water vapor (in kPa) of the heated air (Hint: sensible heating process).-Determine the mass flow of air that bypassed the heater in kg/s.-Determine the heat input by the heating coil in kW.
An isobaric boiler vaporizes saturated liquid water at 200kPa until it is saturated vapor. If the mass flowrate of the water is increased but the same heat transfer rate is maintained, what should be the new state of the boiler outlet? a. Subcooled liquid b. Superheated vapor c. Mixture of liquid and vapor d. Saturated vapor
10- Argon enters an isentropic turbine at 450°C and exits at 150°C. If the turbine power is requested as 0.5 MW, which of the following is the required mass flow rate? A) 0,867 kg/s B) 1,667 kg/s C) 8,013 kg/s D) 0,312 kg/s E) 3,203 kg/s
Can you explain the process of this refrigeration and cryogenic plant for liquid oxygen production?
6 - The refrigerant R-134a enters a throttling valve as a saturated liquid at 1800 kPa and exits at 320 kPa. Which of the following is the degree of dryness of R134a leaving the valve? a) 0.4297 B) 0.4520 NS) 0.3530 D) 0.3339 TO) 0.4075