Two masses m₁ = 4.6kg and m2 = 10.5kg are attached to the ends of a massless string passing through a massless pulley as shown in the figure below. If thesystem is released from rest, determine the magnitude of the acceleration of the blocks. Take g = 9.81m/s² and express your answer using one decimal place inunits of m/s².uAnswer:|M₂

Given data as per question m1=4.6 kgm2=10.5 kgg=9.81 m/s2

Two masses m₁ = 4.6kg and m2 = 10.5kg are attached to the ends of a massless string passing through a massless pulley as show system is released from rest, determine the magnitude of the acceleration of the blocks. Take g = 9.81m/s² and express your answer u units of m/s². 011/0

Two masses m₁ = 4.6kg and m2 = 10.5kg are attached to the ends of a massless string passing through a massless pulley as show system is released from rest, determine the magnitude of the acceleration of the blocks. Take g = 9.81m/s² and express your answer u units of m/s². 011/0

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

Pulleys and ropes are massless and frictionless. The coefficient of static friction between the mass m2 and the surface is µ(s) and the coefficient of kinetic friction is µ(k). The velocity of the mass m2 is V2 and the acceleration is a2. Give your answer in terms of (Ɵ, m1, m2, g, µ(s), µ(k) and V2). Under what conditions are V2 and a2 opposite direction. Hint: m1*a1=2*T-m1*g m2*a2=-T +/- cosƟ*m*g*µ(k) 2*x1=x2 => 2*a1=a2
A mass weighing 11lb stretches a spring 6in. The mass is attached to a viscous damper with damping constant 3lb⋅s/ft. The mass is pushed upward, contracting the spring a distance of 3in, and then set into motion with a downward velocity of 2in/s. Determine the position u, in inches, of the mass at any time t. Use 32ft/s2 as the acceleration due to gravity. Pay close attention to the units.
Pulleys and ropes are massless and frictionless. The coefficient of static friction between the mass m2 and the surface is µ(s) and the coefficient of kinetic friction is µ(k). The velocity of the mass m2 is V2 and the acceleration is a2. Give your answer in terms of (Ɵ, m1, m2, g, µ(s), µ(k) and V2). Under what conditions does the system continue to stall? Hint: T=cosƟ*m2*g*µ(s) 2*T=m1*g
A car given in Figure 1 has a mass of1500kg. It starts moving from restwith an accelera-tion ofa1= (0.5t)m/s2, wheretis given astime in seconds. It accelerates for15seconds, andthen it travels for30seconds at constantspeed. Then, suddenly the driver of the car sees a wall,and starts breaking with constantacceleration ofa2=−4m/s2for8seconds. Unfortunately,the car hits the wall.a)Drawa−t,v−tands−tgraphs for the car until it collideswith wall, and calculate thespeed (vimpact) that the car hits the wall . Clearly indicate your calculation steps.b)The front bumper of the car can be is modelled as a simple linear spring with constantk, as shown in Figure 1. Using the impact speed,vimpact, that you found in the first part of thequestion above, find the value ofknecessary to stop the car when the bumper is compressed15cm.Note:Neglect the size, and shape of the car, and model the car as a particle.
Please answer this NEATLY, COMPLETELY, and CORRECTLY for an UPVOTE. Topic: Conservation of Energy Principle A 0.2-kg block slides along a frictionless curved pipe a shown. It is connected to a spring with a spring constant of k = 32.5 N/m . The uncompressed length of the spring is Lo = 1.5 m. Determine the speed of the spring at point 2 if it starts from rest at point 1.
9. A spring has a stiffness of 100N/m. A mass of 3 kg was attached to the spring. The mass was pushed 10cm upward from the equilibrium position and was released from rest. After 5 seconds from release, determine the acceleration of the mass in m/s^2? 10.What Law governs the statement, "For every object applied with a load, the displacement or size of deformation is directly proportional to the magnitude of the applied load"?
A block of mass m1 = 3.60 kg on a frictionless inclined plane of angle 30.0° is connected by a cord over a massless, frictionless pulley to a second block of mass m2 = 2.00 kg hanging vertically. (a) What is the magnitude of the acceleration of each block? m1 = m/s2 m2 = m/s2 (b) What is the direction of the acceleration of m2? m2 accelerates downwardsnot enough information m2 accelerates upwards (c) What is the magnitude of the tension in the cord? N
A 4-lblb ball BB is traveling around in a circle of radius r1r1 = 3 ftft with a speed (vB)1(vB)1 = 6 ft/sft/s. The attached cord is pulled down through the hole with a constant speed vrvr = 2 ft/sft/s.(Figure 1) (A) Determine how much time is required for the ball to reach a speed of 12 ft/s. Neglect friction and the size of the ball. Express your answer to three significant figures and include the appropriate units. (B) How far r2 is the ball from the hole when this occurs? Neglect friction and the size of the ball. Express your answer to three significant figures and include the appropriate units
A worker drags a crate across a factory floor by pulling on a rope tied to the crate. The worker exerts a force of magnitude F = 200N on the rope, which is inclined at an upward angle q = 30° to the horizontal, and the floor exerts a horizontal force of magnitude f = 150N that opposes the motion. Calculate the magnitude of the acceleration (in the unit m/s2) of the crate if its mass is 100 kg." a)0.23 b)0.33 c)0.43 d)0.53
The radius of a highway curve is 120m, and has an angle of 9.31 from the horizontal. The center of gravity of the car is located 0.80m above the roadway and the distance between the two front wheels is 1.2m. if the car has a total weight of 15KN, a. Determine the normal acceleration (m/s2) and the velocity (in kph) of the car before overturning? Assume that friction is great enough to prevent sliding. b. Find the maximum velocity of the car could move in the curve so that there will be no pressure between the tires and the roadway, kph. c. What is the velocity of the car to prevent sliding up if the coefficient of kinetic friction is 0.60?
A motorboat and its load weigh 2150 N. Assume that the propeller force is constant and equal to 110N, and the water resistance is numerically equal to 6.7V, where V is the speed at any instant time in m/sec. If the boat starts from rest, determine its distance at the end of 10 seconds.
A hanging mass, M1 = 0.5 kg, is attached by a light string that runs over a frictionless pulley to a mass M2 = 1.5 kg that is initially at rest on a frictionless ramp. The ramp is at an angle of θ = 30.0° above the horizontal and the pulley is at the top of the ramp. Find the magnitude and direction of the acceleration of M1. a. 4.905 m/s2 , upward c. 4.905 m/s2 , upward b. 4.805 m/s2 , downward d. 4.805 m/s2 , downward