Answered: One advantage of balanced three-phase…

One advantage of balanced three-phase systens over separate single-phase systems is reduced capital and operating costs of transnission and distribution.

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter2: Fundamentals

Section: Chapter Questions

Problem 2.31MCQ: One advantage of balanced three-phase systems over separate singlephase systems is reduced capital...

See similar textbooks

Related questions

Q: A three phase system cannot be obtained using two single phase source.

A: given two single phases source we need to obtain 3 phase source

Q: Three-phase, 4-wire, wye-connected systems are created by connecting ____ single-phase transformers…

A: In the “Y” (wye) configuration, three single-phase transformers to create three-phase, 4-wire,…

Q: (a) A single phase, unity power factor load takes 70 A at 25 kV. Using a base voltage of 60 kV and…

A: Per unit

Q: With neat diagrams explain how a three phase delta connection to be made with three windings and…

A: Resistors, inductors and capacitors form an integral part of any electrical circuit. A source,…

Q: For the same voltage and current produced by a three phase and single phase source, the power…

A: In this question, We need to choose the correct options Choose the given Statment is true or false?…

Q: 1.The primary conductor in the figure is one phase of a three-phase transmission line operating at…

Q: 1. What types of connections are possible for three-phase generators and loads? 2. What is meant by…

Q: Sketch the connection of 3-phase source to 3-phase load using 3–phase 4 wire complete with labels

A: 3-phase source to 3-phase load using 3–phase 4 wire Diagram

Q: 2.27: 208V, , 3-, 3-wire and CBA-system with Y-load (ZA=60°Q. Z3=630°Q and Zc=5Z45°Q). Find the line…

A: A 3 phase balance star connected system. Sequence of the system CBA. Line to line voltage V=208V…

Q: (a) Give THREE (3) advantages of a three-phase system compared to a single-phase system.

Q: Van = 330&angle;510°, Vbn = 330&angle;270°, Vcn = 330&angle;390°" A POSITIVE PHASE SEQUENCE B…

A: Conversion formula

Q: For a single phase network shown in the figure below, work in per-unit with 200 VA & 250 V as base…

A: In this question we need to find a load current of the given system.

Q: Q5. Using neat circuit diagrams explain the working of following: (i) Earth fault/leakage protection…

A: (i) Earth fault/leakage protection of transformer normally having of a partial breakdown of winding…

Q: is a convenient way of representing a three-phase balanced system.

A: a three-phase system is represented using the simple diagram for simplicity.

Q: The _____________________ of transformers are neglected to draw the reactance diagram. a-Shunt…

A: This is based on the fill the blank The _____________________ of transformers are neglected to draw…

Q: The algebraic sum of the three voltages in a three phase system is always equal to zero. True…

A: Brief description: Here in the above given question they are discussing about three phase systems.…

Q: Three-phase alternator supplying a three wires, CBA system with a line voltage of 100 Volt,…

Q: Three zones of a single-phase circuit are identified in the figure with a generator voltage…

A: For the evaluation of electrical machines, one-of-a-kind values are required, consequently, per unit…

Q: Draw the developed diagram of a 3-ph, 6-pole, chain winding. The number of slots per pole per phase…

A: Chain winding is a type of distributed winding with a diamond shape and having an equal length of…

Q: Draw a layout of a typical supply systems with both 1-phase and 3-phase loads mentioning different…

A: Single-phase supply system: Most electrical power, when delivered at the power plants, is created as…

Q: What is a three phase balanced star connected load? Its phase power measurement and total supply…

Q: For the 3-phase system shown below, the source line voltage is 460 V, 60 Hz, 1). Phase "a" voltage,…

A: In the question, A three phase system given as shown in the figure find the each phase voltage and…

Q: Single Phase and Three Phase Principles

A: As per Bartleby guidelines we are allowed to solve only one question, please ask the rest again.

Q: Which one of the following diagrams shows delta-delta connections of three single-phase transformers…

Q: 2-What is the relationship between phase and line quantities in balanced star and delta connections?…

A: As per Bartleby guidelines we are allowed to solve only one question, please ask the rest again.…

Q: In zero sequence impedance net work why we need

A: Zero sequence network models on a three phase basis shown in the below figure. The current flowing…

Q: What are symmetrical components and why are they used

A: Characteristic of three phase balanced system: Each phase is displaced by 120° phase angle. Each…

Q: The line-to-line voltages in an unbalanced three-phase

Q: Differentiate Wye and Delta Connection in Three Phase System and Relate it with Computer Engineering

A: The differences between the wye and delta connection is listed in the table shown below: Delta…

Q: What is the primary reason for adopting transposition of conductors in a three phase distribution…

A: In this question we will write about transposition of conductors in 3 phase distribution system....

Q: A three-phase symmetrical double circuit line is arranged in a horizontal plane as shown in figure…

A: Transposed line: It is an arrangement of conductors. In this conductors are periodic changes its…

Q: Calculate a. The synchronous impedance Z, per phase b. The total resistance of the circuit, per…

A: In this question, We need to determine the synchronous impedance Zs and total resistance of the…

Q: For a delta connected three phase balanced system, a. Phase current is equal to line current and…

A: According to the question we have to discuss the delta-connected balance system.

Q: Figure below shows the one line diagram of a 3-o system. By selecting a common base of 100 MVA and…

A: There will be three sequence networks in the given power system- Positive-sequence network…

Q: explain why Transformers are necessary in all stages of power distribution systems. Three-phase…

A: Given: Transformer: Transformer is a static device used for the transfer of varying voltage and…

Q: The sequence component line-to-line voltages of a three-phase, 4-wire system are the following: Vab0…

Q: In a three-phase system the per-unit phase voltages are Van = 0.9220° , Vin 0.9Z – 100° , Von…

Q: 2-What is the relationship between phase and line quantities in balanced star and delta connections…

A: Let us consider a balance 3 phase system in which a balance 3 phase load connected in star and delta…

Q: Single Phase equivalent Y-Y system is shown in the figure 3 below, operated by a generator with…

A: Single phase equivalent circuit as given in the circuit is shown below

Q: The one line diagram of a three phase power system is as shown in Figure 7 Impedances are marked in…

Q: a) Explain mathematically how to covert impedance Z per unit using new MVA and kV bas values. b) A…

A: In this question we will write how we will convert impedance from old MVA and KV to new MVA and…

Q: Qs : In a 3-phase 4-wire System in a, b,and e. lines under übnormol condifions of loading the…

A: Solve the problem

Q: Choose the right answer. 1. The symmetrical component method is …………. 2. Conditions for succesful…

A: 1) Symmetrical component method:- This method is used to solve the set of coupled equations. In this…

Q: Athree-phase, wye-connected, 6.25 kVA, 220 V synchronous generatorhas a reactance of 8.4 N perphase.…

A: The given system is a three-phase Y connected, the base values are as follows: Vbase=220…

Q: Hw2.2-4: 3-phase, 15 MVA, 13.6 KV, 2-pole, 50 Hz alternator of synchronous reactance 8.94 Q. Find…

A: Alternators are the important parts of electrical machines and power systems in terms of power…

Q: A three-phase system is said to be more economical than an equivalent single-phase two-phase system…

A: Mainly speaking about 3phase system, it initially requires huge cost but after construction, the…

Q: The terminal voltage of a 3-φ generator is 19053 V, line-to-line. The load draws a current of 1515…

Q: What are two main types of three-phase connections

A: Two main types of three-phase connections are : Star connection Delta connection In star…

Concept explainers

Fault Analysis

In an electrical engineering system, a fault is an abnormal electric current flowing through the system, and fault analysis is the study of these faults. For instance, a short-circuit is a fault where the live wire touches the ground or neutral wire. If a circuit is interrupted by a failure of a current-carrying wire then an open circuit fault occurs. The open-circuit faults are also called series faults. One or more phases or ground may be involved in a three-phase fault or may occur only between two phases. Current flows into the earth in case of a ground fault or earth fault. For most situations, the prospective short circuit current of a fault that is predictable can be calculated. To limit the loss of service because of a failure, the protective devices can detect fault conditions and operate circuit breakers and also other devices. All phases equally can be affected in a poly-phase system which is known as symmetric electrical fault. The asymmetric fault becomes more complicated to analyze if only some phases are affected. By using methods such as symmetrical components, the power system analysis of these types of faults is often simplified. The main objective of power system protection is to design, detect, and interrupt power system faults.

Question

Is it true??

One advantage of balanced three-phase systens over separate single-phase systems is
reduced capital and operating costs of transnission and distribution.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step 3

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 3 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

In a three-phase line, in order to avoid unequal phase inductances due to unbalanced flux linkages, what technique is used?
Does an open connection permit balanced three-phase operation? - (a) Yes (b) No
Determine the bus admittance matrix (Ybus) for the three-phase power system shown in Figure 6.23 with input data given in Table 6.11 and partial results in Table 6.12. Assume a three-phase 100 MVA per unit base. TABLE 6.11 Bus input data for Problem 6.20 TABLE 6.12 Partially Completed Bus Admittance Matrix (Ybus) for Problem 6.30
Consider a single-phase electric system shown in Figure 3.33. Transformers are rated as follows: XY15MVA,13.8/138kV, leakage reactance 10 YZ15MVA,138/69kV, leakage reactance 8 With the base in circuit Y chosen as 15MVA,138kV determine the per-unit impedance of the 500 resistive load in circuit Z, referred to circuits Z, Y, and X. Neglecting magnetizing currents, transformer resistances, and line impedances, draw the impedance diagram in per unit.
One advantage of balanced three-phase systems over separate singlephase systems is reduced capital and operating costs of transmission and distribution. (a) True (b) False
In a balanced three-phase Y-connected system with a positive-sequence source, the line-to-line voltages are 3 times the line-to-neutral voltages and lend by 30. (a) True (b) False
3. Which one of the following method uses weak coupling between reactive power and voltage angle?. A. Newton - Raphson Method B. Decoupled Method C. Gauss-Seidal Method
Outline the drawbacks and the advantages of six-and twelve phase transmission lines configarations.
Three-phase alternator supplying a three wires, CBA system with a line voltage of 100 Volt, connected to a three impedances of 3 - j 4 in Delta connection. Determine the line current, phase current, phase and line voltage and draw the voltage-current phasor diagram, assuming that VBC is the reference vector.
With neat diagrams explain how a three phase delta connection to be made with three windings and it’s current, voltage, power and power factor.
Discuss how delta connection is achieved in three-phase systems?
What can you say about the flow of power as a function of time between a balanced three-phase source and a balanced load? Is this true of a single-phase source and a load? How is this a potential advantage for the three-phase system? What is another advantage of threephase power distribution compared with single-phase?